a common method used in manufacturing sodium hypochlorite bleach is by the reaction: 425kg gaseous  chlorine is bubbled through  a water-NAOH solution.  The solution  contains 600kg of pure NaOH and 310kg of NaOCl is produced. Balance the reaction  equation  and determine  the following: 1 limiting  reactant  2 the  % excess reactant  3 the conversion of NAOH to NaOCl 4 the degree of completion  5 The kg of NaOCl yielded per kg of NAOH fed

Q: Determine the percentage of excess air fed to this reaction, then calculate the molar flowrate of…

A:

Q: A common method used in manufacturing sodium hypochlorite bleach is by the reaction: 425 kg gaseous…

A:

Q: For the preparation of methyl iodide, 2000 Ib/day of hydroiodic acid are added to an excess methanol…

A: Given that, Reaction: HI + CH3OH → CH3I + H2O The mass flow rate of hydroiodic acid in the fresh…

Q: In Deacon process, gas phase reaction was carried out in isothermal batch reactor to form chlorine…

A:

Q: When 13 g of reagent Z dissolves in 500 g of water in a coffee cup calorimeter, the initial…

A: The heat released or absorbed can be calculated by the product of the mass of the substance,…

Q: In a roasting plant, 1000 kg per hour of molybdenum(IV) sulphide (MoS2) is roasted with 25 % excess…

A: Heat of reaction is the enthalpy change for a process. where stoichiometric quantities of reactant…

Q: Example 4.2. HNO, and 8 wt% water, by mixing You are asked to make 1,000 kg of the mixed acid…

A:

Q: An iron-carbon alloy initially containing 0.255 wt% C is exposed to an oxygen-rich and virtually…

A: Given data: Initial concentration of C = 0.255 wt % Surface concentration = 0.0 wt % Temperature =…

Q: Q2 Sulphur trioxide gas is obtained by the combustion of pyrites (FeS,) according to the following…

A:

Q: An iron-carbon alloy initially containing 0.200 wt% C is exposed to an oxygen-rich and virtually…

A: Given data:The initial carbon concentration is The carbon concentration at the surface is The carbon…

Q: NaCl crystals are produced from 1000 kg of solution containing 10% NaCl, 1% KOH and 89% H2 0. The…

A: Out 1000 kg 100 kg is NaCl,10 Kg KOH and 890 kg in water.750 Kg of this water goes evaporated. So we…

Q: O Flash Distillation (or Single-Stage Contact) A mixture of 60 mole % n-heptane and 40 mole %…

A: A mixture of two hydrocarbons is flashed vaporized.

Q: arbon can be used as a tie substance between the fuel and the stack gas. Theoretical oxygen is…

A: 1. True.  Carbon can be used as a tie substance because it is present in both the inlet and outlet…

Q: The naphtha fraction derived from the distillation of Kuwait crude oil is with 0.02 wt% sulfur…

A: Dear User ! As per our  authoring guidelines, we have answered the first of the two independent…

Q: A binary mixture of n-heptane and n-octane at its boiling point containing 70% (mol percent) of…

A: A mixture of n-heptane and n-pentane is separated into distillate and bottom product in a continuous…

Q: In a process for the manufacture of chlorine by direct oxidation of HCl with air over a catalyst to…

A: Basis: 100 moles of product stream The number of moles of components in the product stream nHCl,P =…

Q: Ethanol is produced by the hydration of ethylene according to the first reaction below. However,…

A: The molar composition of an effluent stream is given.

Q: 4. A waste mixture of 50% xylene (C8H10), 40% toluene (C7H8) and %10 water is to be combusted in a…

A: The mass flow rate of the mixture, m = 500 kg/h Mass composition of the mixture, 50% xylene (X), 40%…

Q: 50% by mass NaOH was diluted to 10% by the addition of water. The temperature of the 50% by mass…

A: Given: 50% at 65.6 °C by mass NaOH was diluted to 10% at 37.8 °C Enthalpy change by using NaOH/H2O…

Q: Pure propane (C,Hg) from El Paso is dehydrogenated catalytically in a continuous process to obtain…

A: Given: The Dehydrogenation reaction of propane to propylene is given as follows: C3H8    →Catalyst…

Q: n the manufacture of sulfuric acid by the contact process iron pyrites, FeSj, is burned in dry air,…

A: (a) To calculate the weight of air to be used per 100 lb of pyrites charged, we need to consider the…

Q: Isobutane is produced by the reaction of i-butane and butylene in an emulsion with concentrated…

A: Solution: a) The ratio of FR1 / Ffresh (in mol) is b) The ratio of FR2 / Ffresh (in mol) is c) The…

Q: A tray distillation column tower is to be designed to distill 550 Ibmol/h of a binary mixture of 50…

A:

Q: 100 k/moles of Heptane is burned with 40% excess air. Seventy percent reacts to form CO₂ and the…

A: Given data: Number of moles of heptane = 100 kmol Heptane reacts to form CO2 = 70 % Heptane reacts…

Q: Butane is burned with 80% of theoretical air. Calculate the composition of gases leaving, assuming…

A:

Q: Pure sulfur is burned with 30% excess air. As a result of combustion, 7.23% SO 3, 4.06% SO 2, 7.06%…

A: Given: Pure sulfur (S) is burned with 30% excess air by the following reactions: S + 32O2  →  SO3S…

Q: F2 gas and excess iodine solid are heated together at high temperatures.  The iodine sublimes and…

A: Given, I=2.5g,  No. of moles of I=2.5/Atomic mass of I=2.5/127 moles No. of moles of I=0.019685…

Q: leaving the distillation column are at different temperatures. a) Determine the number of degrees of…

A: 1) feed mixer contains pure nbutane at temperature T which is only unknown so it's degrees of…

Q: A catalytic reaction was used to produce methanol.  Methane and methanoic acid are unwanted products…

A: In chemical reaction engineering, Catalytic reactions are defined as typically used to accelerate…

Q: In the manufacturing of chlorine, HCL and O2 are reacted to form Cl2 and H2O. Air is fed with 35%…

A:

Q: In biodiesel production, it is desired to separate methanol from glycerol for methanol recovery.…

A: Given Data  XF=0.45XD=0.95XW=1-0.94=0.06To Find The distillate to feed ratio for the distillation

Q: Copperas (crude ferrous sulfate) is purified by dissolving it in water and recrystallizing it in a…

A: Given Copper(impure)is purified Feed+water→28%FeSO4 Feed=96% FeSO4.7H2O Solubility of FeSO4=20.51 g…

Q: A fuel containing 75% ethane and 25% propane (mole%) is burned with dry air. All the H2 burns to H2O…

A: Basis: 100 moles of the fuel mixture containing ethane and propane. Given: The moles of ethane…

Q: A saturated vapor feed that is 90 %mol maleic anhydride and 10%mol benzoic acid is distilled  at…

A: Given : since feed is sat vapor hence PsM + PBs = PThence  PsM + PBs = 99.8also, the composition of…

Q: A mixture containing 30% acetone and 70% chloroform is extracted with a mixed solvent containing…

A: Given Feed=F, E=100 Kg Overall material balance, F+S=E+R F+S=100+R          (1) Component balance…

Q: Chemical Engineering Calculation All questions are interconnected, allowed by bartleby.    PROBLEM…

A:

Q: Aniline is produced by the hydrogenation of nitrobenzene. A small amount of cyclohexylamine is…

A: Given Hydrogenation of nitrobenzene→ Aniline By-product- cyclohexylamine Nitrobenzene in feed=3×…