A column (with initial dimensions x 150 mm, y 150 mm, and z 1000 mm) is confined by a rigid material on its x-axis as shown. Take note that the column is free to elongate/shorten along the y- and z- axis. What are the final dimensions of the column when a load P₂ - 150 kN is applied? Also, determine the bearing stress along the x-axis developed between the column and the rigid material. Use G = 35 GPa and v=0.33.

A column (with initial dimensions x 150 mm, y 150 mm, and z 1000 mm) is confined by a rigid material on its x-axis as shown. Take note that the column is free to elongate/shorten along the y- and z- axis. What are the final dimensions of the column when a load P₂ - 150 kN is applied? Also, determine the bearing stress along the x-axis developed between the column and the rigid material. Use G = 35 GPa and v=0.33.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Need both parts, handwritten. Remember this handwritten, no plagiarism should be there. THANKS
please recheck your final answer.
Answer in two decimal places please
A flat steel bar, 26 mm wide by 2 mm thick and 1.8 m long, is bent by couples applied at the ends so that the midpoint deflection is 27 mm. Compute the maximum stress in the bar. Use E =220 GPa. Answer must be in MPa.
A flat steel bar, 30 mm wide by 2 mm thick and 1.3 m long, is bent by couples applied at the ends so that the midpoint deflection is 27 mm. Compute the maximum stress in the bar. Use E = 220 GPa. Answer must be in MPa.
A flat steel bar, 26 mm wide by 3 mm thick and 1.7 m long, is bent by couples applied at the ends so that the midpoint deflection is 21 mm. Compute the maximum stress in the bar. Use E = 240 GPa. Answer must be in MPa.
Kindly give me right solution with clear calculations (Hand writing)
Please show all steps so your process is easy to follow
A flat steel bar, 30 mm wide by 2 mm thick and 1.6 m long, is bent by couples applied at the ends so that the midpoint deflection is 23 mm. Compute the maximum stress in the bar. Use E =210GPA. Answer must be in MPa.
X= 482 show complete solutions and FBD
A rectangle column 500 mm x200 mm in cross-section is subjected to a compression load 1000 KN, the stress on the column is: a. 30 MPa b. 10 MPa C. 50 MPa d. 20 MPa
FE.Question 3