A coil of resistance 1500 ohms and 0.25-H inductance is connected in parallel with a variable capacitance across a 10 V, 8 kHz supply. Calculate the minimum supply current.
Q: A CAPACITOR OF CAPACITY 10MF CHARGED FOR A VOLTAGE DIFFERENCE OF 15V WAS CONNECTED IN SERIES WITH AN…
A: For the given question we have to calculate potential difference across each capacitor after…
Q: 6. A circuit having a resistance of 15 Q, an inductance of 0.15 H and a capacitance of 100 µF in…
A:
Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…
A: Given the circuit, as shown below: Given: R1=299 Ω, L1=208 mH, L2=181 mH, C=97 μF, V1=12 V. The…
Q: A coil having a resistance of 45ohms and inductance 0.4 H is connected in parallel to a 20 microF…
A: Step1 In this question, we have to find out Current I taken from mains. Following parameters are…
Q: An inductor of 1 H, a capacitor of 0.1667 F, and a resistor of 5 n are connected in series with an…
A:
Q: A coil of 20 ohms resistance has an inductance of 0.2 H and is connected in parallel with a 100…
A: Circuit will act as non inductive resistance at only resonant frequency.
Q: Example: A 500 mH inductor is supplied from a 115 V source with a frequency of the 60 Hz. Calculate…
A: L=500 mHV supply Vs=115 v∠0∘frequency =60 HzInductive reactance =XL=(jwL)XL=j×(2π×60)×500×10-3…
Q: An inductive impedance of 32 ohm resistance and unknown inductance and a pure capacitor of 33.4…
A: In this question we need to find a value of unknown Inductance.
Q: A capacitor of luFand resistance 820are connected inseries with ane.m.f. of 1000 V.Calculatethe…
A:
Q: Given a set of caapcitors: 7 nF, 6 nF, 5 nF, 4 µF, 3 pF and 10 µF, solve the following problems: A.…
A: As we know that the equivalent capacitance of parallel connected capacitors is given as Ceq=…
Q: A 12 volte battery is connected to simple series circuit in which inductor is H and the resistance…
A: We will apply KVL in loop and than solving equation gives indictor current.
Q: 1. a. Find the current for time > 0 in a series RC circuit. Resistance is 10 Ohm and capacitance is…
A:
Q: Q6. Given C1 = luF, C2 = 2uF, C3 = 6uF and C4 = 6uF. Calculate (a) the total equivalent capacitance;…
A:
Q: 22. Given a set of capacitors: 12nF, 6nF, 9nF, 4µF, 2pF and 7µF, solve the following problems: a.…
A:
Q: A 200µF capacitor is connected in series to a 250V, 60Hz source. Assuming its resistance is 20Ω,…
A:
Q: Ideal capacitors do not dissipate energy; they store it for use in the circuit. True False
A: An ideal capacitor is a purely reactive device, containing absolutely zero resistive effects. As a…
Q: 2) Two parallel-plate capacitors are constructed using dielectric materials with dielectric…
A: The above shown arrangements of parallel plate capacitors can be simplified as below;
Q: A coil of resistance 50 ohm and inductance 100 mH is connected in parallel with a 30 mF capacitor…
A: The impedance of inductive element is given as XL=j2πfL Here, XL=j2πfL is the inductance and…
Q: Calculate the value of the resistor(Ω) that must be connected in series with a 110 mH inductor to…
A:
Q: 2. Parallel and series combinations of inductors: Connect 0.1 H parallel and series L inductors…
A: When same current flows through all elements , they are said to be in series. When same potential…
Q: A 12-Volt battery charges the four capacitors shown in Figure 5.12.1. C, Figure 5.12.1 Let C = 1 µF,…
A: If capacitors C1 and C2 are in series equivalent capacitor is C1×C2C1+C2 If capacitors C1 and C2 are…
Q: Obtain the energy stored in each capacitor in the figure as shown under dc conditions. 2 mF 2 k2 5…
A: In this question we will find energy stored in capacitor under dc conditions....
Q: Two coil of self inductance 3 H and 5 H are connected in a series- opposing each other. What is the…
A:
Q: A capacitor is connected in parallel with a coil having L = 5. 52 mH and R = 10 ohms to a 100 V, 50…
A:
Q: 1. Three inductors of 20mH, 30mH and 60mH respectively, are connected together in a parallel…
A: If three inductors L1 , L2 and L3 are connected in parallel than equivalent inductance is Leq than…
Q: Simplify the circuit below to determine the equivalent capacitance. Fill up the table of properties…
A: C3 and C4 are in series. Hence their equivalent-C'=C3C4C3+C4=6×126+12=4μFNow, C2 and C' are in…
Q: Find the equivalent capacitance with respect to the terminals a, b for the circuit shown below 20 nF…
A: When two capacitors are in series, then the equivalent capacitance is 1cS=1C1+1C2 When two…
Q: A coil of wire having negligible resistance and inductance of 0.248 H is connected to a 117 V, 50 Hz…
A:
Q: A capacitance of 2.0 F with an initial charge Q, is switched into a series circuit consisting of a…
A:
Q: 1. Two capacitors having capacitance values of 8µF and 24µF, respectively, are connected in series…
A:
Q: A. Simplify the circuit below by finding the equivalent resistance and equivalent capacitance. Show…
A: Given circuit shown
Q: Electrical strain gauge works on the principle of Select one: O a. variation of inductance O b.…
A: The strain gauge is one of the best devices used in electrical measuring techniques for mechanical…
Q: 50u(t) V 50 V 6n 2 3 H Discussion: 1- Find the initial and forcing inductance current from your…
A:
Q: Given a set of capacitors: 7 nF, 6 nF, 5 nF, 4 µF, 3 pF and 10 µF, solve the following problems: a.…
A:
Q: 5 minutes 8. If the voltage v=10cos(100t + 30) is applied to a 10mH inductor, calculate the current…
A: The solution is given below
Q: For the circuit diagram provided below, what is the total capacitance between terminals a and b if…
A: To solve above problem, one should know how to find equivalent capacitance for series and parallel…
Q: Calculate the value of the resistor(Ω) that must be connected in series with a 120 mH inductor to…
A: From expression of current in terms of R and L find resistance required Now power dissipation =…
Q: A resistor and a capacitor are connected in series with a variable inductor. When the circuit is…
A:
Q: 6. A circuit having a resistance of 15 Q, an inductance of 0.15 H and a capacitance of 100 µ F in…
A: Given values are - R=15ohmL=0.15HC=100μFf=50HzVS=100V
Q: Find the impodance theorctically of a wire if it canies the frequency 10 kHz have a voltage is 8v,…
A: The impedance of a wire is nothing but the ratio of Voltage across the wire to the current through…
Q: D) Two capacitors A and B having capacitances of 20 uF and 12 uF respectively, are each connected…
A: The charge stores in capacitor in the dielectric with which the capacitor. The charge stored is…
Q: For the circuit diagram provided below, what is the total capacitance between terminals a and b if…
A:
Q: 1. It is the variation in capacitance express as a percentage of its specified value at 25 degrees…
A: 1.Answer: Temperature coefficient of capacitance(TCC). 2.Answer capacitor stores 1 coulomb of charge…
Q: A capacitor having a capacitance of 20 µF is connected in series with a non-inductive resistance of…
A: Given: C=20 μFR=120 ΩV=100∠0° Vf=50 Hz
Q: 18. Two coils of inductances 4 H and 6 H are connected in parallel. If their mutual inductance is 3…
A:
Q: A series circuit having pure resistance of 40 ohms, pure inductance of 50.07 m Hand a capacitor is…
A: First find the total impedance seen by source and than equate this with impedance of series circuit…
Q: A coil of resistance of 8 ohms and inductance of 150mH in series with a 110 microFarad capacitor, is…
A:
Q: 20 µF a 10 k2 :5 µF 15 V b (a) Determine (a) the amount of energy stored in each of the three…
A:
Step by step
Solved in 2 steps with 2 images
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
- Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
- A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor?
- A capacitance is a circuit component that opposes the change in circuit A. current B. voltage C. impedance D. none of the above2. A resistor in series with a capacitor absorbs 10 W when the combination is connected to a 120 – V, 400 – Hz source. If the power factor is 0.6 leading, what are the resistance and capacitance?What is the equivalent resistance ?? and what is the total inductance ??