A coil having a resistance of 45 and an inductance of 0.4 H is connected in parallel with a capacitor having a capacitance of 20 μF across a 230-V, 50-Hz system. Calculate (a) the current taken from the supply (b) the power factor of the combination

A coil having a resistance of 45 and an inductance of 0.4 H is connected in parallel with a capacitor having a capacitance of 20 μF across a 230-V, 50-Hz system. Calculate (a) the current taken from the supply (b) the power factor of the combination

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: V1 + V₁ = 33, 80/0° L₁ = 2je C₁ = -5jN L1 R1 10 www I Vx www R2 392 C1 ww R3 20 0,75 VX

Q: QUESTION 13 The resistance of the Armature's conductor coil(s) in most motors is: quite high,…

A: The resistance of armature conductors are very low of range 2 to 4 ohm the reason behind the low…

Q: * three - phoge syctem hay line to line woltage Vab = 1500 Voms ith 30° angle with a %3D load.…

A: Solve the problem

Q: Find the Inverse Laplace Transform of 20s

A: The solution is given below

Q: Find the laplace transform of f(t) = 2t4 - 3e³t + 10 cos 2t F (s) =…

Q: A 3-phase induction motor has a star-connected rotor. The rotor e.m.f. at standstill is 50V. The…

A: Given data, Emf is given, E=50 V Resistance is given R=0.5 Ω Reactance is given X=3 Ω

Q: A transmission line has a capacitance of 25 pF / ft. and an inductance of 0.15 µh / ft. Determine…

Q: 11.29 In a balanced three-phase wye-wye system, the total power loss in the lines is 400 W. VAN =…

A: Steps: First, write the per phase mode and calculate the current magnitude using the given power…

Q: Find the Fourier Series Representation of f(eitheta) = 1/13-12 cos(theta

Q: List three applications of electrical transformers.

A: Brief description : Transformers works based on the principle called electromagnetic induction and…

Q: A 10kVA, 230 Volts, single phase generator has synchronous impedance of 0.5 + j1.2 ohms per phase.…

A: The solution is given below

Q: Four e.m.fs e1 = 100 sin ωt, e2 = 80 sin (ωt − π/6), e3 = 120 sin (ωt + π/4) and e4 = 100 sin (ωt −…

Q: Sketch the root-locus plot for the system shown in Figure below K (s+5) GCS) (S+1) ( S+2)

Q: In the circuit shown below, the op-amps are ideal. Then Vout in volts is 1 ΚΩ 1 ΚΩ -2 VoM Μ +15 V…

Q: For the circuit shown below find Av, Ai, Ro, Ri.

A: The required parameters can be calculated by using DC and AC analysis of amplifier circuit.

Q: What is the z-transform of the following finite duration signal? 1…

A: In this question we need to find a z transform of the given signal

Q: y[n] = x|1 – 2| T. (•} n|= 2x[n-2] Figure Q1(b) (i) With consideration of the discrete signal…

Q: A 18 nC charge is uniformly distributed over a spherical shell r = 8 cm and a -6 nC charge is…

Q: /v2 and VDD Consider thne linear source follower below. [VTH 100 M1 500 500 M2 If Ip2 = 2 mA, a.…

A: MOSFET refers to the metal oxide semiconductor field-effect transistor, it belongs to the FET…

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown www 50Ω S3 个 502 ↑ Vs…

A: In this question we need to draw Vm as a function of time

Q: To put it another way: A BTS broadcasting information with 10 W of output power at 1800 MHz can only…

A: BTS broadcasting It is the type of base transceiver station, in which a fixed radio transceiver is…

Q: A Class C amplifier is as shown in Figure Q2(c) below. Determine: +Vcc =+60 V L7 = 15 µH C;= 120 pF…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: PROBLEM 1. Find IL single prime; I. double prime ; IL LL I= 0.3 AZ 60° 0° ell 8 Ω Xc150 E = 10 V 20°

Q: What are the poles of the system with state space equations 20 x' - [ ] +[i]• [29] x 4- y = [10] z…

Q: 1)))))For the above circuit, determine: a) The value of a resistance Rv, so that there is the…

A: In this question, We need to determine the The value of a resistance Rv for maximum power transfer…

Q: Practice Problem 2.7 10 252{ 9A 7104 8 Ω ww + Vo

A: Circuit diagram is given as,

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown 50Ω S3 ↑ 5002 个个 Vs Vm…

A: In this question we need to draw Vm as a function of time

Q: Use the Principle of Superposition to determine the current i through R3 in the Figure. Let R1 =…

A: The solution is given below

Q: Calculate the output voltage if V1= 2V and V2 = 1V for the circuit: Vo=____Volts

Q: How far does the electron of a hydrogen atom have to be removed from the nucleus for the force of…

A: Solution -

Q: . Using nodal analysis calculates I

Q: For a FM signal v(t) = 15 cos ( 10 10°t + 10 sin 1220t), calculate 1. Carrier frequency 2.…

A: Given FM signal, vt=15 cos 10×108t+10 sin1220t

Q: 1. Consider the linear source follower circuit below. Let Vrí = 4 V, k =1 MA v2 and Vpp = 20 V. VDD…

A: The linear source follower circuit is shown below, Here,VTH = 4 Vk= 1mAV2VDD = 20 V

Q: + V1 R1 20 ww 10 V ww R2 40 R3 20 ww + 3 Vo R4 20 ww + Vo R5 40 A B

Q: A 60kVA, 220V, 50Hz, single phase alternator has effective armature resistance of 0.016 ohm and an…

Q: Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic…

Q: Given ID = 4 mA at VGS = -2 V, determine IDSS if VP= -5 V.

A: In this question, We need to determine the Saturation drain current IDSS ?

Q: 5.16. When operating from rated voltage, a DC machine has a no-load speed of 5,000rpm and rated…

A: Efficiency is defined as x x= (((no load speed)- full load speed)/full load speed))*100

Q: Q1: Determine the critical frequency for the figure below:

A: The given circuit is a cascaded active low pass filter. The cascading is done to increase the roll…

Q: (a) Draw the state transition table and the state diagram for the circuit shown in Figure Q1(a). Is…

A: The solution is given below

Q: Find all eigenvectors for A = [2 13 3.

A: Solve the problem

Q: Given the NMOS circuit in Figure 2 with VDD = 18 V and the following transistor parameters: V₁=0.8…

Q: simplify the Boolean function, F=B’(CD’+A) + C’D(A’+B)

A: To simplify ,F=B'(CD'+A)+C'D(A'+B)

Q: Given a three-phase induction motor, 380 V, 2 poles, 60 Hz. At a given time the phase currents are…

A: Steps: Ia ,Ib ,Ic and angle are given Apply d q axis formula in the form of ABC Substitute the…

Q: In a A-connected source, the phase voltage is Ve = 102 V. What is between the lines in V? Your…

A: Given data, Delta connected source with Phase voltage, Vθ=120 V

Q: 11.47 In a three-phase balanced delta-delta system, the source has an abc-phase sequence. The line…

Q: A 4-pole, 3-phase, 50 Hz induction motor has a voltage between slip-rings on open-circuit of 520V.…

Q: Find the voltage and current for the AC circuit

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: 6. Refer to the graphics addendum (B). When the impedance is converted to the other configuration…

A: Impedence per phase of delta connection = 3 × (Impedence of star connection)

Q: A Class C amplifier is as shown in Figure Q2(c) below. Determine: +Vcc =+60 V L7 = 15 µH Cr= 120 pF…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
The parallel capacitor combination shown in the figure is connected across a 12 V source. Determine the following: a. equivalent capacitance Ceq b. the charge on the combination. c. the work needed to carry the charge across 1uF + 12V 3uF 2uF
A pure resistance of 50 ohms is in series with a pure capacitance of 100 microfarads. The series combination is connected across a 100 volt, 50 hz source. Find the a) impedance, b) phase angle, and c) equation of the current
A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the final value of current, the value of current after 4 ms, the value of the voltage across the resistor after 6 ms, the value of the voltage across the inductance after 6 ms, and the time when the current reaches 15A.
A resistance 120 Q and a capacitance 15 µF are connected in series across a 240 V, 50 Hz a.c. supply. Calculate (a) the circuit impedance (b) the voltage across the resistance (c) the voltage across the capacitor and (d) phase angle in degrees.
Draw block diagrams for each of the following elements, first voltage as input and current as output, and then vice versa: a. resistance, b. capacitance, c. inductance.
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.