A circuit calls for a 0.200 mm -diameter copper wire to be stretched between two points. You don't have any copper wire, but you do have aluminum wire in a wide variety of diameters. Part A What diameter aluminum wire will provide the same resista Express your answer with the appropriate units. μÅ Value Submit Units Request Answer ?

A circuit calls for a 0.200 mm -diameter copper wire to be stretched between two points. You don't have any copper wire, but you do have aluminum wire in a wide variety of diameters. Part A What diameter aluminum wire will provide the same resista Express your answer with the appropriate units. μÅ Value Submit Units Request Answer ?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A A dozen resistors are arranged in a cube as shown in the diagram. What is the effective resistance between point A and point B? All resistors are 1 ohm. B
a. A heater consists of a variable resistor connected across an ideal voltage supply (no internal resistance). To increase the heat output, should you decrease the resistance or increase the resistance? Explain your answer.
Part A Consider circuit in the figure (Figure 1). Find the rate of conversion of internal (chemical) energy to electrical energy within the battery. Express your answer using two significant figures. Pehemical = W Figure O 1 of 1 > Submit Request Answer 1.0 Q 12.0 V d Part B a Find the rate of dissipation of electrical energy in the battery. Express your answer using two significant figures. C 5.0 N P =
IP Three resistors, R₁ = 30, R2 = 68 2, and R3 = R, are connected in parallel with a 12 V battery. Part A The total current flowing through the battery is 0.88 A. Find the value of resistance R. Express your answer using two significant figures. R= Submit Part B I1, I2, I3 = | ΑΣΦ Submit 3 Request Answer Find the current through each resistor. Enter your answers numerically separated by commas. Express your answers using two significant figures. [ΨΕΙ ΑΣΦ ? Request Answer Ω ? A
B A hair dryer is basically a duct of constant diameter in which a few layers of electric resistors are placed. A small fan pulls the air in and forces it through the resistors where it is heated. If the density of air is 1.15 kg/m3 at the inlet and 1.05 kg/m3 at the exit, determine the percent increase in the velocity of air as it flows through the hair dryer 1.05 kg/m³ The increase in velocity is Pin kg/m³ Check my work %6
A conductor has a circular cross-sectional area A, length L, and L resistivity p, as shown. A Suppose you want to double the resistance of the conductor. Would the following changes achieve this goal? i) Yes No Replace the conductor with one made from a material with half the resistivity, keeping everything else the same: ii) Replace the conductor with one made from a material with half the conductivity, keeping everything else the same: Yes No Double the length of the conductor, keeping everything else the same: iii) Yes No Double the radius of the conductor, keeping everything else the same: iv) Yes No Yes Reduce the radius of the conductor by half, keeping everything else the same: v) No
A material is formed into a long rod with a square cross-section 0.50 cm on each side. When a 112 VV voltage is applied across a 20-mm length of the rod, a 4.0 AA current is carried. Part A What is the resistivity of the material? Express your answer using two significant figures.
A standard 100 W (120 V) lightbulb contains a 7.0-cm-long tungsten filament. The high- temperature resistivity of tungsten is 9.0 × 10-7 Ω m. Part A What is the diameter of the filament? Express your answer with the appropriate units. d = Submit μÅ Value Request Answer Units ****** **** ?
Q2
A silver wire s 50 m long and 0.56 mm in diameter. Part A What is its resistance? Express your answer using two significant figures. R=. Provide Feedpack
In an integrated circuit, the current density in a 2.3-um-thick x 75-um-wide gold film is 7.0x105 A/m² Part A How much charge flows through the film in 15 min? Express your answer to two significant figures and include the appropriate units. Q = μA Value Submit Request Answer Units ?
Part A The current in a 100 watt lightbulb is 0.900 A. The filament inside the bulb is 0.280 mm in diameter. What is the current density in the filament? You may want to review (Pages 750 - 752). Express your answer to three significant figures and include the appropriate units. HA | ? Value Units Submit Request Answer Part B What is the electron current in the filament? Express your answer using three significant figures. ? electrons second