A certain gas was produced as a product of a decomposition reaction in a reactor vessel. The reaction generated a certain amount of force that allowed the gas to move at 35 m/s. The diatomic product gas (gamma = 1.36) will be transported adiabatically in a commercial steel pipe with a diameter of 1 inch. If the exit of the reactor and start of the pipe has a same pressure of 6 atm abs. and temperature of 120 degrees Celsius. The molecular weight of the gas is 70.91 kg/kgmol. 2. What is the Mach No. at the entry of the pipe? 0.36 0.41 0.14 none of the given

Q: For inviscid and adiabatic flow, the thermal energy equation can be written as de p- dt -PV · ū.…

A: Given: To prove:

Q: Identify the state of the fluid: Ammonia at 120kPa, with a specific enthalpy of 35 kJ/k

A:

Q: He equipment room housing the compressor and condenser of a refrigerant ammonia system has…

A: Dimension=5 by 4 by 3 Time =1/2

Q: A supply line contains a two-phase mixture of steam and water at 240 °C. To determine the quality of…

A: Given data, According to the given data T1=240°C Po=100kpa We need to find Quality of the mixture…

Q: A single-effect evaporator concentrates 4.00 kg/s of a 10% by mass solution of H2SO4. The entering…

A: Given that, Mass flow rate of solution, F=4 kg/sec,xF=0.10Mass flow rate of vapor, V=3.2 kg/second,…

Q: Water, m = 110.27 g, is mixed with 111.33 g of an unknown fluid with specific weight of 0.158…

A:

Q: Calculate the time in hours that it will take to reach thefatal concentration of 40% methane in a…

A:

Q: Air (diatomic, MW = 28.8664 g/ mol) in an automobile tire is maintained at a pressure of 220 ka…

A: The initial mass flow rate. Given: The gauge pressure in the tire is Pgauge=220 kPa. The atmospheric…

Q: 4. A large dry containment of a PWR has a volume of 2E6 ft’. At normal opera- tion, the mixture of…

A:

Q: If Xf = 42000 ppm, Xb= 70000 ppm, and Md= 1 kg/s then the mass flow rate of the brine is

A: Given DataXf=42000 ppmXb=70000 ppmMd=1 kg/s

Q: A river has a flowrate of 3 m3/s. A stream discharges into the river at a flowrate of 0.05 m3/s. A…

A: Given, Flow rate of river = Qr = 3 m3/sConcentration of tracer in river flow = Cr = 0 mg/LFlow rate…

Q: A process to liquify nitrogen gas (N2) from 300K, 200atm to 98.69K (saturation temperature) and 7atm…

A: Given data, Initial temperature of the nitrogen, T1 = 300 K Initial pressure of nitrogen, P1 = 200…

Q: 100 m3/h of a gas mixture containing 84.0 mol % N2 and the balance n-Heptane (the condensable…

A:

Q: Elaborate and explain the piping equipments in cryogenic plant including the pipes and fittings,…

A: According to the question we explain the piping equipments in cryogenic plant including the pipes…

Q: . Determine the SOTR (g/m.h) in a deep tank aeration at a point x= 15.00 at 25°C when the the…

A: INTRODUCTION : The goal of this problem is to compute the SOTR of the given system, and we will use…

Q: AH of vaporization of water is 439.2 cal/g at the normal boing point. Since virus can survive at…

A:

Q: Nitrogen and carbon dioxide are to be mixed and allowed to flow through a convergent nozzle. The…

A: At temperatures above absolute zero, all gaseous particles, according to the Kinetic theory of…

Q: Oxygen gas is maintained at a pressure of 4 bar and 1 bar on opposite sides of a membrane. The…

A:

Q: Steam at 101.325 kPa and 373.15 K was isothermally compressed. Which is expected to happen? A It…

A:

Q: A bomb calorimeter is used to determine the Higher Caloric Value of an oil sample . the mass of the…

A: Mass of the sample =2.12g" data-mce-style="display: inline-block; line-height: 0; text-indent: 0px;…

Q: Imagine that you have a rigid leak-proof container that contains nitrogen (N2) gas at atmospheric…

A: Given data: Initial gas pressure, P = 1 atm Initial Temperature, T = 25 °C Final gas Pressure, P' =…

Q: The volumetric analysis of a mixture of gases is 30 percent oxygen, 40 percent nitrogen, 10 percent…

A:

Q: Which of the following properties are not desirable for a binary fluid? Less freezing temperature…

A: The binary fluid is the special type of chemical composition which enables special reaction or…

Q: Newton's law of cooling states that dT/dt = k(T−t0), where T(t) is the temperature of the body that…

A: Given data :-Newton's law of cooling for a body dT/dt = k(T−t0) To find: Solve the differential…

Q: Find the mass in metric tons per day of at -5 °C that would theoretically made in a refrigerating…

A: Answer: The mass in metric tons per day is 32.8340 tons/day.

Q: Which statement about vaporization enthalpy and condensation enthalpy is correct?

A: This question is based on the concept of enthalpy.

Q: In a paint manufacturing process, two different colored paints are being mixed in an infinitelylarge…

A: The objective of the question is to find the concentration of pigment in the resulting mixture when…

Q: 14. In a test to determine the dryness fraction of a sample of steam combined separating and…

A: Given-Data:- The pressure of steam before throttling=1.2MPa = 12bar The pressure of steam after…

Q: 300 ml sample of dry oxygen at STP ( standard temperature and pressure ) is transferred to a…

A: For solution refer below images.

Q: A 1500L tank contains benzene (C6H6) at a pressure of 400 kPag and a temperature of 320K. Later,…

A:

Q: OL X-axis. O I. O m Z II. ONX IV.

A: we are to determine the point where heat removal takes place

Q: kg 2kg Of air at 500 K is mixed with 1.6 of air at 900 K in an insulated chamber S The resulting…

A:

Q: 5 kg of 371.15 K water are mixed with 12 kg of water. If the final mixture has a temperature of…

A: Given: m1 = 5kg m2 = 12kg T1 = 371.15 K final T = 301.15 K

Q: To purify hydrogen gas, it can be diffused through a 5 mm palladium sheet. Two kilograms of hydrogen…

A: The area of sheet is A=105.2 m2. Therefore, option B is correct.

Q: What is the stress concentration factor?

A: Given Stress To find Stress concentration factor

Q: determine the saturation mixing ratio and the mixing ratio of each of the following air samples.…

A: Temp: 140C   ;  RH: 90% Temp: 200C  ;  RH: 60% Temp: 240C   ;  RH: 40% Temp: 300C  ;  RH: 40% Temp:…

Q: Explain the concept of heat transfer, and spontaneity and probability base on the increasing…

A: Heat transfer can be defined as the process of transfer of energy in which molecules are moved from…

Q: 15. An empty flask has a mass of 48.293g and 48.612g when filled with acetone vapor at 80°C and…

A: Given:-

Q: Two hundred and fifty pounds of a mixture of 10 mol % propane 20% n-butane, and 70% n-pentane is…

A: Given: Total mass of mixture = 250 lbMass percentage of propane, butane & pentane = 6.63, 17.47…

Q: 100 grams of water are mixed with 150 grams of alcohol (ρ = 790kg/m3 ). What is the specific volume…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: ind the diffusitivity of air in methane and the molecular diffusion of methane, if the tank filled…

A:

Q: Methane is diffusing at steady state through a 0.5mm diameter and 4mm long tube containing nitrogen…

A: Methane is diffusing at steady state through      Dia=0.5 mm Length=4mm Nitrogen gas @ pressure…

Q: Thermal fluid mechanics Detailed solution With an understanding of the laws of the subject

A: Please Rate if this solution helps youThank You

Q: Problem 1: Helium gas is seperated from other components of a gas mixture by its selective diffusion…

A: P1: Given: The helium pressure at the inner surface, Pi = 1.5 bar The helium pressure at the outer…

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.