A centrifugal fan with a rotational speed of 1500 rpm has a weight of 1200 N and an imbalance of 30 kg-cm.The fan is found to emit a high level of noise while operating, vibrating the floor on which it is placed. To provide 90% insulation using rubber wedges with a dimensionless damping coefficient of 0.15 What should the resistance of the rubber wedges be? What will be the maximum value of the force transmitted to the ground in this case?

Q: The amplitude of vibration of a single degree of freedom spring-mass-damper system is observed to…

A: A Spring system is a system in which the mass in the system is concentrated on the spring. The…

Q: 3 EW) 24. A centrifugal clutch has four blocks which slide radially in a spider keyed to the driving…

A:

Q: The amplitude of vibration of a single degree of freedom spring-mass-damper system is observed to…

A: Given data: - The stiffness of the spring is K = 1516 N/m. The mass is M = 23.5 kg. The ratio of…

Q: eads damping force g force leads inertia and damping force are rce leads them by 90

A:

Q: The amplitude of vibration of a single degree of freedom spring-mass-damper system is observed to…

A: Given:x5x0=0.15K=1502 N/mm=9.5 Kg

Q: What are the allowable values of the cross-sectional height

A:

Q: A small block is attached to an ideal spring and is moving in SHM on a horizontal frictionless…

A:

Q: In a spring-mass system, the mass is m and the spring constant is k. The critical damping…

A: Given,  Initial mass = m1 = m Final mass = m2 = 2m Initial spring constant = k1 = k Final spring…

Q: A diaphragm pressure transducer is connected to a pipe wall tap by a stiff-walled tube. The tube can…

A:

Q: An accelerometer is composed of weight W = 0.042 lb suspended by a spring for which k = 5 lb/in.,…

A:

Q: The amplitude of vibration of a single degree of freedom spring-mass-damper system is observed to…

A: Given data: - The ratio of the amplitudes after 5 cycles is xo/x5 = 1/0.15. The stiffness of the…

Q: A machine is represented as a single degree of freedom spring-mass-damper system. The machine has a…

A: Givensingle degree of freedomm=100kgme=0.125kge=0.01m C=109N/m secK=1009N/mN=3000rpm

Q: Find frequency and mode shape for the system shown in Fig. 5, using Stodola process. Take m= 1 kg;…

A: The mass, m = 1 kgThe stiffness, k = 1000 N/m

Q: In a spring-mass-damper system with a mass of 20 kg, the rigidity and damping properties are…

A: Given        Mass, m = 20 kg                    t = 3 s Amplitude, A = 0.5 cm

Q: Q3. Consider a spring-mass-damper system with m 80 kg, c 15 kg/s, and k = 1500 N/m with an impulse…

A:

Q: Consider a spring-mass damper system whose block of mass “m” is connected to the top wall by a…

A: The mass of the block is m. The applied force on the block is u(t). The displacement of the block is…

Q: the stiffness of the spring is 1 kN/m. By introducing the stiffness of the spring is 1 kN/m. By…

A:

Q: The compressor shown has a mass of 250 kg and operates at 2000 rpm. At this operating condition, the…

A: As per the given condition xn=-(mrωf2)/k1-ωfωn2kxn=(mrωf2)ωfωn2-1ThusP=(mrωf2)ωfωn2-1Thus it can be…

Q: Find the natural frequencies for the system illustrated below.

A: As no external force is acting on the system so the total energy of the system is conserved.…

Q: A 100 kg fan is mounted on four parallel springs and a damper as shown. If the spring coefficient of…

A: Equivalent stiffness of the system = 120/4 = 30 kN/m angular rotation = w =4000 x 2π60= 418.8790…

Q: When the w/w, value of a harmonically excited spring-mass-dashpot system equals one and the damping…

A: Option (c) Approaching infinity. I

Q: speed of the pulley in rpm and the power transmitted if the condition of maximum power prevail?

A: Given data;   d=3.5 mn=102β= 450β=22.50θ=160×π180θ=2.79 radμ= 0.3T=1000 Nm=1.5 kg/m    for maximum…

Q: Consider the following system. Assume m = 1 kg, k = 7000 N/m and c = 70 N.s/m. The damping ratio of…

A: The damping ratio of the second mode. Given: The mass is m=1 kg. The spring constant is k=7000 N/m.…

Q: A general basic vibratory system consists of mass and spring. Figure Q1 shows the vibration…

A: Given : To find : -Sketch free body diagram of the system together with the action and…

Q: A 2.50-kg object is attached to a spring with a force constant of 4.50 N/m. The object rests on a…

A:

Q: A machine is represented as a single degree of freedom spring-mass-damper system. The machine has a…

A:

Q: Consider a one-ninth t g/9), then t of a simple as compare earth is:

A: The frequency of the simple pendulum can be determined as, Here, g: acceleration due to gravity l:…

Q: A perfectly balanced motor with its shaft has a mass of 18 kg , and a 2 kg disc is fixed onto the…

A: Given data as per the question Mass of motor=18 kgMass of disc=2 kgMass of platform=180 kgk=1.5×107…

Q: A solid shaft having diameter , length and modulus of rigidity ⁄ is attached to a circular disc…

A: Consider a system in which the circular disk is fixed to the shaft. In this system a damper of…

Q: reciprocating compressor of mass 20 Kg runs at a constant speed  of 3000 rpm. After installation the…

A:

Q: (a) Draw a free-body diagram for each mass. Write the equations of motion in terms of æ(t) and y(t)…

A: Given:

Q: LA car is be ap spring of 1.1 sinusoidal in response amp

A: mass m=750kgspring=1.1E+5 N/mCoefficient =4.5E+3 N s/m Input=4cmWavelength =20mTravelling =10m/s

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.