A cectangular air-filled copper waveguide with dimenssion 2.28 cm x 1.01cm cross section 30.48 cm length is operated at 9.5 GHz with a dominant mode.Find: a)cut off frequency b)guide wavelength c)phase velocity d)characteristic impedance e) attenuation in dB

A cectangular air-filled copper waveguide with dimenssion 2.28 cm x 1.01cm cross section 30.48 cm length is operated at 9.5 GHz with a dominant mode.Find: a)cut off frequency b)guide wavelength c)phase velocity d)characteristic impedance e) attenuation in dB

Related questions

Q: A series RLC circuit has components with R = 100Q, L = 0.25 H, and C = 5µF. A) Calculate the…

A: (A) Given: R=100 Ω, L=0.25 H, C=5 μF. Introduction: Impedance is a measure of the overall opposition…

Q: 0.35λ long with characteristic impedance Z0= 50 ohms transmission line is combined with ZL=10+j25…

Q: 5. For the network of Figure, Calculate (i) (ii) (iii) (iv) (v) (vi) the total impedance Z₁ in polar…

A: Disclaimer: “Since you have asked posted a question with multiple sub-parts, we will solve the first…

Q: suppose R=500ohms; C=0.5F; L=80mH; current in circuit is i(t)=Icos(5000rad/s)t where I is amplitude…

A: This problem can be solved using the formula for inductive capacitance and inductive reactance.

Q: Part A A radio can be tuned into a particular station frequency by adjusting the capacitance in an…

Q: You have four metal bars. When bar 1 is placed in a line with each of the other three bars, the…

A: Bar 1 attracts all other bars but when the 4th bar is flipped, bar 1 and bar 4 repels each other.…

Q: Given the following current and voltage phasors, what is the power being absorbed by the impedance?…

A: given data as per question voltage and current phasor value

Q: A series RLC circuit has an inductive reactance of 6.00 x 102 Q, a capacitive reactance of 2.85 x…

A: XL is inductive reactance = 6.00 * 102 Ω XC is capacitive reactance = 2.85 * 102 Ω R = 2.50 * 102 Ω…

Q: A spaceship whose rest length is 406 m has a speed of 0.83c with respect to a certain reference…

A: Given: The rest length of spaceship is L=406 m. The speed of spaceship relative to reference frame…

Q: A three-phase line has an impedance of j2 Ohms( ZT=j2 Ohm) is shown below. The line feeds two…

Q: An airport has a radar transmitter that contains an LC circuit oscillating at 2.10 x 10³ Hz. (a) For…

Q: The cutoff frequency, fo, for a low pass filter is given by the following equation: 1 2TRC The…

A: We have fc=12πRC=12π×1.5×103×0.02×10-6=5305.16 Hz

Q: (b) Calculate the resonant frequency of the Band Pass Filter if its bandwidth is 100Hz and Q factor…

Q: A sinusoidal voltage Av = 36.0 sin 100t, where Av is in volts and t is in seconds, is applied to a…

A: Since you have posted a question with a multiple sub parts, we will solve first three sub - parts…

Q: North American outlets AC electricity with a frequency of f = 60.0 Hz while the European standard is…

A: Given : Frequency of American Standards, f1 = 60.0 Hz Frequency of European standards, f2 =…

Q: Problem 1: You construct an oscillating LC circuit with inductance 18 mH and capacitance 1.1 uF.…

A: Part (a) Answer is 75464 Hz or, 75.46 KHz

Q: Determine the order of a unity gain Butterworth filter where fc= 300 Hz, and the gain decreases at…

A: Given, fc= 300Hz gain, Az = 39dB ωz=8900rad/s The nearest possible integer for Butterworth filter is…

Q: 14. Find the impedance magnitude and phase angle: 226 юкл mu AS E ст 50lvo что ре f = 100Hz INI ег…

Q: What is the average power dissipation in a series RLC circuit if R = 20.00 k[I, C= 10.00 µF, L=180…

Q: Question 2 A 50kHz sinusoidal voltage has zero phase angle and a maximum amplitude of 10mV . When…

Q: 17. Given that L = 0.05 H in the circuit of Figure D, and the values of R and C as in problem 16,…

Q: Q1/ The impedance of the basic A.C bridge are given as follows: Zz= 250275° (inductive impedance),…

A: Write the given data. Z1=250 Ω∠75°Z2=200 ΩZ3=500 Ω∠45°

Q: Tow voltages V =5 V is applied to non- inverting OP-AMP, the voltage gain * .will be . . if Av =…

A: Op-amp or operational amplifier is an analog circuit used to amplify weak electric signals. It has…

Q: has nominal low-pass filer Constant-k impe dance f 752 & cutoff frequency af 2MAZ find L & C T-…

A: Nominal impedance Znom of the given circuit is 75 Ω and is defined by the relation Znom=LC…

Q: ) Problem 3: An LC circuit consists of a 3.75 mH inductor and a 7.5 µF capacitor. Rar domized…

Q: An d.c. asupply of 50H% is supplied to a seuies combinalion of 25UF capacity 0d Hlensy indualor f…

A: To find-(1) Reactance (2) ImpedanceGiven-f=50 HzC=25 μF=25×10-6 FL=0.1 HenryR=24 ohm

Q: In a LCR series circuit, at resonant frequency (a) The impedance and the current are maximum (b) The…

Q: Suppose an audio amplifier produces 100W rms output when the input is 5.00W rms. This represent a…

Q: A 150MHz uniform plane wave is incident from air onto a material with unknown imped A measurement…

A: Wave impedance is defined as the ratio of electric to magnetic field intensities in an…

Q: A Type High Pass Filter IC an 229 C= 20n L1=100mH L2=100mH we adjust input voltage 20 Vpp=10V 1 TYPE…

A: The gain of a high pass filter is defined as The above equation represents the gain of a high pass…

Q: An RLC series circuit has a 45.0 Ohm resistor, a 75.0-uH (micro-Henry) inductor, and an 45.0-uF…

A: Given data The resistance is R=45.0 Ω The inductance is L=75.0 μH The capacitance is, C=45.0 μF The…

Q: When in resonance, an LC circuit with a 6.5 pF capacitor emits radiation at a wavelength of 3.35 m.…

A: Step 1: Step 2:

Q: A1) Voltage V = 200 sin wt is applied to a series RLC circuit with L = 15 mH, C = 150 nF and R = 25…

A: A1) Given L = mH, C = 150 nF and R = 25 Ω a) Resonant frequency b) Total Impedance of the circuit…

Q: A sinusoidal voltage Av = 37.5 sin(100t), where Av is in volts and t is in seconds, is applied to a…

Q: An antenna has an impedance of 50 Q. An unmodulated AM signal produces a current of 4.8 A. The…

Question

A cectangular air-filled copper waveguide with dimenssion 2.28 cm x 1.01cm cross section 30.48 cm length is operated at 9.5 GHz with a dominant mode.Find:

a)cut off frequency

b)guide wavelength

c)phase velocity

d)characteristic impedance

e) attenuation in dB

Expert Solution