A car engine with a power output of 65 hp has a thermal efficiency of 24%. Determine the fuel consumption rate of this car if the fuel has a heating value of 19,000 Btu/lb m. Answer ASAP thanks. I will rate helpful

Q: A engine generates 22 kW of power (constant friction power) at 40% load. When the engine is at full…

A:

Q: You are part of a team that is completing a mechanical-engineering project. Your team built a steam…

A:

Q: Why is humans are very dependent on the used of fuels to produce power?

A: Alternative fuels reduce toxic exhaust emissions (such as carbon dioxide, carbon monoxide,…

Q: Define the thermal efficiency of the reheat cycle shown in the T-S diagram below using the enthalpy…

A: The thermal efficiency of the cycle is the ratio of net work done to the total heat given to the…

Q: A diesel engine consumed 945 liters of fuel per day at 30°C. If the fuel was purchased at 15.5°C and…

A: Given    Volume at 30oC = 945 liters       Cost per liter = Php 5 Find   Cost of fuel

Q: Q6/ Your company produces small power plants that generate electricity by expanding waste process…

A:

Q: Your neighbor lives in a 2500-square-foot (about 250 m2) older house heated by natural gas. The…

A: Assumptions: The price of natural gas is based on international prices. so, the price for 1 unit (1…

Q: Steam enters a turbine operating at steady state with a mass flow rate of 1.5 kg/s. The turbine…

A: Given:m=1.5 kg/sP=2.7 MWh1=3506.2 kJ/kgc1=30 m/sh2=1671.67 kJ/kgc2=130 m/s

Q: Thermal efficiency is of key importance in power producing system design.  If the engine high and…

A: If the engine high and low temperatures are fixed, Brayton Cycle has highest efficiency. It operates…

Q: The owner of a propose steam power plant received bids from two fuel supplier. The first supplier…

A: Given data: Net power output = 100 MW Turbine inlet enthalpy h1 = 3582.3 kJ/kg Turbine outlet…

Q: Discuss the function of the diesel and gasoline engines of each part.

A: Solution:   In a gasoline engine, fuel is mixed with air, compressed by pistons and ignited by…

Q: pl-diagram on the right shows a cycle of a heat engine that uses 0.250 mol of an ideal gas with =…

A:

Q: 4. Which of the following formulas can be used to evaluate the thermal efficiency of a reversible…

A: 4

Q: To understand the mathematical expression for a thermodynamic cycle you must calculate the index of…

A: Consider below P-V diagram to understand different states. From the data given in question, P1 =…

Q: | As a mechanical engineering technician, you are asked by your building manager to investigate the…

A:

Q: A city has a fleet of 10 gasoline cars and 5 gasoline light trucks built in 2009. The annual vehicle…

A: Given data :-fleet of 10 gasoline cars and 5 gasoline light trucks built in 2009. The annual vehicle…

Q: Fossil fuel power plant generates power to 5 residential household cornmunity with the following…

A: ◆ The maximum demand of the power plant is 1246.25 kW. ◆ Therefore, the correct answer is option…

Q: Express the result in %.

A:

Q: A heat engine with a thermal efficiency of 45% rejects 1000 kJ/kg of heat to a low temperature sink.…

A:

Q: Due to heavy traffic during rush hours (around 7am in the morning and 5pm - 7:30pm in the evening),…

A:

Q: 1. An ideal Otto engine, operating on the hot-air standard with k = 1.34, has a compression ratio of…

A: Solution to first three sub-parts as per our company policy:

Q: A car has a fuel efficiency of 17.5 mpg and is driven 100,000 miles during its life.   How many lbs…

A: Given: Fuel efficiency of car =17.5 mpg Distance traveled in lifetime=100,000 miles CO2 emission…

Q: Question 2 The figure below shows a gas turbine which draws in air from the atmosphere at 1 bar and…

A: Given data : The isentropic efficiency ηi=85%=0.85 Net power Wnet=80 kW Compression ratio rp=5…

Q: 010. Sketch a P-V diagram Carnot cycle for a heat pump. What does the area enclosed by the graph…

A: The p-v diagram is shown where the area enclosed represents the work done.

Q: 5.) Does a refrigerator full of food consume more power if the room temperature is 20°C than 15°C?…

A: 5) The coefficient of performance of the refrigerator is, K=(Q(c))/W K=(Q(c))/ (Q(H)-Q(c)) In the…

Q: kw per cylir of the crank and combu

A:

Q: a: Draw the P-v diagrams for the three power cycles and label each process: Diesel, Stirling, and…

A:

Q: An electric resistance heater is used to provide space heating at an efficiency level of 100%. The…

A: Space heating demand: 1137.8 MBHConversion factor: 1 MBH = 1000 BTU/hElectricity cost: $0.13 per…

Q: Show that the thermal efficiency of any internal combustion engine can be simplified as a ratio of…

A:

Q: ABOITIZ power plant operates a fuel engine plant with monthly energy of 18.5 KW-HR uses a Diesel…

A: Given data Monthly energy produced = 18.5 kW-hrDiesel fuel has energy of 1.35 kW-hr/kgWe have to…

Q: able 1. Carnot Engine. High Engine Temperature Temperature (tH) in °C AS (high – low) in KJ/kgK Net…

A: Given Data⇒ Carnot engine A Carnot engine B

Q: Suppose that a new gasoline engine has been invented which can operate at the maximum thermodynamic…

A:

Q: 1. Define the efficiency of a heat engine.

A: According to terms and conditions of bartleby we can only provide 1st solutions . Thank you!

Q: A heat engine is proposed in a patent application. It receives heat from a 167 °C heat source and…

A: Given:Heat source temperature, TH=167oCCold source temperature, TC=7oCHeat received by heat engine,…

Q: kg 9 Air (M= 28.97 kmol) is used for a Stirling cycle engine. Determine the unknown states in the…

A: INTRODUCTION : A Stirling cycle engine is a closed-cycle regenerative heat engine that converts heat…

Q: Question 2 The figure below shows a gas turbine which draws in air from the atmosphere at 1 bar and…

A:

Q: Determine the uses of diesel and gasoline engine in agriculture

A: The agriculture is very difficult before a long time but after using the engines (diesel and…

Q: The data listed below are claimed for a power cycle operating between hot and cold reservoirs at…

A:

Q: Q2/ The peak load on a power plant is 60 MW. The loads having maximum demands of 30 MW, 20 MW, 10 MW…

A: Power plant is a facility where we generate electricity using fossil fuels like coals, natural gas,…