. A cannister contains water with a height level of 80 cm and is transported up a buildingusing a pulley-operated dumbwaiter. Determine the pressure at the bottom of the cannisterwhen the dumbwaiter is stationary, moving up with an acceleration of 3.8 m/s², and movingdown with a downward acceleration of 3.5 m/s². Draw your schematic/ free-body diagram.

Name: . A cannister contains water with a height level of 80 cm and is tran
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: . A cannister contains water with a height level of 80 cm and is transported up a buildingusing a pulley-operated dumbwaiter. Determine the pressure at the bottom of the cannisterwhen the dumbwaiter is stationary, moving up with an acceleration of 3

Givenh=80cm=0.8mwhen moving up a=3.8m/s2when moving downa=3.5m/s2

Engineering

Mechanical Engineering

A cannister contains water with a height level of 80 cm and is transported up a bu using a pulley-operated dumbwaiter. Determine the pressure at the bottom of the car when the dumbwaiter is stationary, moving up with an acceleration of 3.8 m/s?, andm

A cannister contains water with a height level of 80 cm and is transported up a bu using a pulley-operated dumbwaiter. Determine the pressure at the bottom of the car when the dumbwaiter is stationary, moving up with an acceleration of 3.8 m/s?, andm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A tank containing water moving horizontally with a constant linear acceleration (3.5m/sec2), and vertical acceleration decreases by (25%) from the horizontal acceleration. The tank was (3m) high, (2.5m) length and (1m) width. Determine the force on the bottom of tank if the water level at rest was (2m). (Answer with sketch, See Fig.3)
Q4) There is a balance between an immersed block and the mass on the scale as shown in figure. Assuming that the block is immersed in water, determine the density for block. (Block has a cubic geometry. Pwater= 1000 kg/m®) 2 kg Mass 12 cm Block
A semicircular plate with radius r= 2 is submerged in water as seen in the picture. Using the facts that the density of water is 1000 kg/m³ and acceleration due to gravity is 9.8 m/s², calculate the fluid force (in N) against the side of the plate. Make sure your answer is correct to three decimal places at least. Fluid force radius-r N
A vessel is filled with oil (ρoil = 900 kg/m3) up to 1 m of its height. It is 3m wide, 2m high and 10 m long.Find the following :A. The maximum horizontal acceleration that can be charged to the vessel without spilling anyoil.B. If this vessel is closed and is completely filled with oil and accelerated horizontally at a rate of 3 m /s2 .B.1. The total force acting at the rear wall and at the front wall of the vessel.B.2. The accelerating force on the fluid mass.
h = 4 ft F 2 ft A hemispherical glass bubble is installed in the side of a tank as a viewing window with its center 4 ft below the surface of the water. What is the magnitude of the vertical component of the force on the glass in lbs? The specific weight of water is 62.4 lbf/ft3.
ВЗ. A circular plate of diameter 3 m is vertically placed in water in such a way that the centre of the plate is 9.4 m below the free surface of water. Find the total pressure & center pressure on the plate. Draw the diagram neatly. Total Pressure on the circular plate (in N) Centre of Pressure on the circular plate (in m)
A 10000 litre water tank is placed on a building roof and filled to capacity. The empty tank has a mass of 550kg. It is supported on 4 feet, each of which is a 300 x 300 mm steel plate. What is the pressure exerted by each plate, in Pa? (Round your answer to 2 significant figures)
A semicircular plate with radius r = 2 is submerged in water as seen in the picture. Using the facts that the density of water is 1000 kg/m³ and acceleration due to gravity is 9.8 m/s2, calculate the fluid force (in N) against the side of the plate. Make sure your answer is correct to three decimal places at least. radius=r Fluid force = # N
A vertical plate is submerged in water and has the shape as seen in the picture. Using the facts that the density of water is 1000 kg/m³ and acceleration due to gravity is 9.8 m/s², calculate the hydrostatic force (in N) against the end of the tank. Make sure your answer is correct to the nearest thousand. (Hint: First set up a Riemann sum that approximates the hydrostatic force, which can then be used to obtain an integral that represents the force.) 20 m Hydrostatic force =
The open tank shown, which has a liquid with a specific gravity of S=12.4 as shown in the give figure, is accelerated upward at one g. what is the pressure at point 1(kpa)? 150 cm 1 190 mm 2.
Consider two tanks filled with water. The first tank is 8 m high and is stationary, while the second tank is 2 m high and is moving upward with an acceleration of 5 m/s^2. Calculate the pressure of each tank at the bottom.
The open tank shown, which has a liquid with a specific gravity of S=12.4 as shown in the give figure, is accelerated upward at one g. what is the pressure at point 1(kpa)? 150 cm 1 190 mm N 2.