a) Calculate the self-inductance (in mH) of a 49.0 cm long, 10.0 cm diameter solenoid having 1000 loops. b) How much energy (in J) is stored in this inductor when 22.0 A of current flows through it? and c) How fast (in s) can it be turned off if the induced emf cannot exceed 3.00 V?

Q: A 10 g bullet moving at 380 m/s strikes a ballistic pendulum of mass 3.5 kg. The bullet emerges with…

A:

Q: A proton moving in a uniform magnetic field with 7₁ = 1.24 x 106 î m/s experiences force F₁ = 1.83 ×…

A:

Q: A 2°C temperature increase is closest to an increase of O 1/2 °F 0 1 °F O 2 °F ○ 4 °F 34 °F

A: The increase in temperature is Find:The equivalent increment in temperature in degrees Fahrenheit.

Q: Determine the current in each resistor of the circuit shown in Fig. 26–9015. Figure 26-90 12.00 V ——…

A:

Q: Question 3: a. Draw a circuit with a battery and two identical light bulbs (same resistance) in…

A: Registance  of two identical bulbs is same.The two bulbs are connected in parallel.

Q: A particle is traveling in a straight line. Its position at time t in seconds is given by s(t) = 5vt…

A:

Q: An air-track glider attached to a spring oscillates with a period of 1.50 s. At t=0 s the glider is…

A: time period = T = 1.5 secat t= 0 position of glider = X0 = -4.7 cm ( - ve is left direction )speed =…

Q: The figure shows wire 1 in cross section; the wire is long and straight, carries a current of 4.02…

A:

Q: The cross section of a steel rod is 10 cm^2. What is the least force that will prevent it from…

A: To calculate the force =  F=   ------------------(1)Cross section of rod = A= 10cm2Change in…

Q: You are designing the section of a roller coaster ride shown in the figure. Previous sections of the…

A:

Q: A skier slides straight down an incline of 25 degrees without using her poles.  The slope itself is…

A:

Q: trest pulls 0.10 kg of water into its mantle, then ejects this water at a emarkable 45 m/s.

A: Given data:Mass of squid, Mass of water, Velocity due to ejection of water,

Q: spring is hanging from the ceiling. Attaching a 590 g physics book to the spring causes it to…

A:

Q: ure k = 80,000 N/m m = 100 kg 10 m 130⁰ 1 of 1

A:

Q: (a) The engineer designing the release mechanism shown in the figure wants the normal force exerted…

A:

Q: A cart of mass M1 = 3.0 kg and initial speed = 3.0 m/s collides head on with a second cart of mass…

A: In the question, it is given thatCALCULATION OF

Q: A comet's momentum is in the direction of the arrow labeled e below. What arrow best describes the…

A: Momentum is a vector quantity representing an object's mass times its velocity. The direction of…

Q: One half of a kilogram of liquid water at 273 K (0°C) is placed outside on a day when the…

A:

Q: How much work (in J) is done for an object moving from x=1m to x=5m?

A: As we  know work done(W) is given by the formula - W = Fd,F - Force, d - displacement.We also know…

Q: If the only force acting on the rock is its weight, what is the magnitude of the rate of change of…

A:

Q: If 750-nm and 660-nm light passes through two slits 0.66 mm apart, how far apart are the…

A: Wavelengths are  and Separation between slits is Distance between slits and screen is…

Q: Learning Goal: To find some of the parameters characterizing an object moving in a circular orbit.…

A:

Q: i need help with part e

A:

Q: Find the three longest wavelengths (call them A₁, A₂, and A3) that "fit" on the string, that is,…

A:

Q: The mass density of a semicircular wire of radius (Figure 3) varies directly as the distance from…

A:

Q: A particle of mass m1 = 3 kg moving along the x axis collides with a particle of mass m2 = 4.5 kg…

A:

Q: A current loop is in the magnetic field as shown. Which way will this current loop rotate? the loop…

A:

Q: The figure shows an object and its image formed by a mirror. Assume that d1 = 0.552 m, d2 = 0.398 m,…

A: d1 = 0.552 m, d2 = 0.398 m, and h = 7.50E-2 m.

Q: A vertical wheel with a diameter of 50 cm starts from rest and rotates with a constant angular…

A:

Q: Which of the following statements are true?   options:   The rest length of a spring is where it…

A: We know, spring is an object that exerts force depending on the displacement of it compresion or…

Q: Two ropes are attached to a wagon, one horizontal to the west with a tension force of 30N, and the…

A:

Q: ar coll of radius 32.0 cm decreases from The component of the external magnetic held along the…

A: Number of turns = N = 18radius = r = 0.32 mArea = A =  = 0.3215 m2change in magnetic field = dB =…

Q: x(t) = at x(t) = 8t² [2] 7 x(t) = at³ + ßt² + yt+8 L CLO x(t) = a sin(Bt) x(t) = a exp(yt³)

A: In a valid equation, the dimensions on both sides must be consistent. This means that the dimensions…

Q: Two point charges Q1 = 3.27 nC and Q2 = -3.02 nC are shown in the figure. Q₁ is located at (-2.1 cm,…

A: And

Q: If a negative sign appears in front of the wt term with no negative sign in front of kx in the…

A: Negative sign appears in front of ωt. No negative sign in front of kx. Direction of propagation of…

Q: In the figure, point P₂ is at perpendicular distance R = 25.8 cm from one end of straight wire of…

A:

Q: A soap bubble is 120 nm thick and illuminated by white light incident perpendicular to its surface.…

A: Given Data:The thickness of a soap bubble is, The index of refraction of a soap bubble is, The…

Q: Jane took 10 minutes to drive her boat upstream to water-ski at her favorite spot. Coming back later…

A:

Q: How many antinodes will there be if the frequency is increased to 7 fo? n= 15. ΑΣΦ Ć Dome ?…

A: There are n antinodes for nth harmonic.

Q: A flywheel in a motor is spinning at 530.0 rpm when a power failure suddenly occurs. The flywheel…

A:

Q: Suppose light falls on double slits separated by 131 μm. Randomized Variablesd = 131 μm θ = 0.67°…

A: Slit separation, d = 131 μmθ = 0.67°Order, n = 3

Q: A 6.00 kg sled is pulled across a frictionless horizontal surface by a rope that makes a 42 degree…

A:

Q: A 1kg round object (radius 0.2 m), initially at rest, rolls down a ramp without slipping. The object…

A: Mass, m = 1 kgRadius, r = 0.2 mHeight, h = 1 mVelocity, v = 1 m/sMoment of inertia, I = ?

Q: Suppose the first-order maximum for monochromatic light falling on a double slit is at an angle of…

A:

Q: You ski straight down a 40.6 degree slope, starting from rest and traveling a distance of 11.3m…

A:

Q: The figure shows an object and its image formed by a thin lens. Assume that d₁ = 0.202 m, d2 = 0.903…

A:

Q: 1. Greg throws a small lump of clay at a larger block of clay, which is at reston a horizontal…

A: Given:Mass of clay, Mass of block, Initial velocity of block = 0Distance moved by block before…

Q: ▼ What is the magnetic field B at point a in (Figure 1)? Give your answer as a vector. Express your…

A:

Q: Feeling lazy, John tries to slide a box 3.5 m across the floor to his co-worker. If the coefficient…

A: Distance between box and his co-worker, d = 3.5 mCoefficient of friction, Initial speed of the box =…

Q: The two conditions for equilibrium often result in a system of equations such as F1 + F2 = 42.0 N…

A: At equilibrium conditions, the relations between forces isand Find:(a) Force (b) Force

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.