Answered: A Buck-Boost converter has an output of…

A Buck-Boost converter has an output of 24 V from a 5 V input with diode ripple current of 2.4 A and switching frequency of 100 kHz. Find the duty cycle and the inductance of the converter.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Using silicon diode, design a clamper circuit that will produce output Vo = 12Sinwt-6 V when the…

Q: A 20-V-rms 60-Hz ac source is in series with an ideal diode and a 100-Ω resistance. Determine the…

A: Draw the mentioned circuit diagram.

Q: The impedance of Zener diode in the Circuit when the reverse current in the diode increases from 20…

Q: For the an input waveform of -10.25 V to the given circuit, what is the peak value (in V) of the…

Q: Determine the ripple factor for the filtered rectifier circuit below when RL= 4KN. Then explain…

A: Given : Load resistance RL = 4 K ohm Capacitance C = 50 u F They are interested in the…

Q: solve d-f

A: In this question we need to draw the voltage waveform across RL , find peak current through diode…

Q: the voltage regulator circuit shown below the power rating of Zener diode is 400 mW. The value of RL…

A: Zener diode is heavily doped semiconductor that conduct in forward and reverse direction In forward…

Q: Find the applied voltage on a forward biased diode if the current is 1mA and reverse saturation…

Q: 1. Analyze the circuit given in Figure; obtain all the currents properly. State all the assumptions…

A: Its a simple diode circuit problem. Given , v1=5v, v2=3v R1=5kohm R2=3kohm cutt in voltage=0.7v We…

Q: What is the nominal potential of a Zener diode with maximum dissipation power rating of 250mW and…

Q: a. Using the simplified diode model, simulate the action of the circuit when the Germanium diode is…

A: Clamper circuit: This circuit consists of a diode, resistor, and capacitor. This is used to shift…

Q: Find the maximum zener current for the zener diode as shown in figure. Given, V₂=6V, R₂ = 1.52,…

Q: Vout and current IL through the load resistor separately one below the other. Assume an ideal diode.

Q: A full-wave rectifier is connected to a single-phase source and supplying an inductive load. For the…

A: Part (1): For the full-wave rectifier, four diodes are required in the bridge connection. To remove…

Q: In the voltage regulator circuit shown below the power rating of Zener diode is 400 mW. The value of…

A: Zener diode is heavily doped semiconductor that conduct in forward and reverse direction In forward…

Q: input voltage. The diode in circui: has cutin voltage Consider the given a circuit and waveform for…

A: The diode is ON when the voltage across anode is more than the cathode voltage. It is known as…

Q: Da D

A: (1a) In forward-biasing of a P-N junction, the positive terminal of the battery is connected to the…

Q: erse the diode and replace the positive DC supply with negative DC supply and repeat Does the output…

A: Here i have solved it.

Q: H.W3 The single-phase full wave controlled rectifier has a R-L load with R= 0.52 and L= 6.5mH. The…

A: Since you have posted multiple subparts so we will solve the first 3 parts for you,The resistor,…

Q: C. In the circuit shown below the knee current for the ideal Zener diode is 10 mA Calculate the…

Q: - 本 D₁ A 芈 D₂ 2 六

A: Answer: given that diodes are Zener diodes are with the break down voltage of 5.1 Volts input…

Q: Where can you find a Diode in Multisim Live Online Circuit Simulator? O a. Passive O b. Diodes O c.…

A: b) Diodes There is a seperate section for diodes and zemer diodes

Q: Find the level of Vo for each circuit shown in the Figure below. Also, determine the status of each…

Q: R, +E ww Output D VF VE Input -(E-1,R,) -E

A: The given figure is shown below: It is given that: E=±5 VIo=5 mA=5×10-3 AVo=-4.5 V

Q: Sketch and explain the output wave shape for the circuit. The generator signal is a sine wave with a…

A: In this question, We need to Sketch and explain the output wave shape for the circuit. Assume…

Q: (c ). Design a Diodes Limiting Circuit to limit a 120 Vrms Sinusoidal Voltage Signal to a Maximum…

A: Clipper circuits are voltage limiter circuits that limit the voltage at some particular dc voltage…

Q: Explain briefly the l-V characteristic of the real diode under the effect of the forward biasing.

A: to explain briefly the I-V characteristics of the real diode under the effect of the forward biasing

Q: b. Suggest a circuit that eliminates the negative portion of an AC waveform, leaving the positive…

A: Note:As discussed in the question, we are required to answer only part (b). we are required:To…

Q: I need some help with this problem. I need to create a power supply from 110v 60hz to regulated an…

A: According to the question, we need to design the circuit as shown below The desired output is 6 - 9…

Q: In a given circuit below is connected to an AC signal with 240V peak in a 4:1 transformer. Sketch…

A: It is given that:

Q: 4. For the circuit shown in the figure below uses a transformer of 230V/12V-0-12V and all diodes are…

A: centre tapped Full bridge rectifier A transformer is used with centre tapped winding Two diodes…

Q: In the voltage regulator circuit shown below the power rating of Zener diode is 400 mW. The value of…

A: Zener diode is heavily doped semiconductor that conduct in forward and reverse direction. In forward…

Q: In the voltage regulator circuit shown below the power rating of Zener diode is 400 mW. The value of…

A: Zener diode is heavily doped semiconductor that conduct in forward and reverse direction In forward…

Q: A buck converter has a duty cycle of 0.8. It has and inductor resistance of 20 and a resistance load…

Q: A nominal Zener voltage is usally specified in datasheet of Zener diode at a value of reevrs current…

A: To answer above question one should know what Zener diode. It is a special purpose P-N junction…

Q: 10 V - 10 V T/2 Vin C 2V R₁ Vout

Q: The single phase half-wave uncontrolled rectifier has a freewheeling diode and a ripple free average…

A: Given, Load current, Io = 20 A Source voltage, Vs = 220 V Frequency, f = 50 Hz

Question

b) A Buck-Boost converter has an output of 24 V from a 5 V input with diode ripple
current of 2.4 A and switching frequency of 100 kHz. Find the duty cycle and the
inductance of the converter.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A silicon diode with a forward resistance of 100 is connected in series with a 5000 resistor. If an a.c voltage of 20V peak is connected across the series combination of the diode and the resistor what will be the peak value of the current through the diode and the peak output voltage? What will be the peak value of the current through the diode and the peak output voltage if the diode were ideal?
..
Solution of this question is required. Urgently please.
What is a zener diode? Draw the I - V characteristics of a zener diode and explain how it is different from a normal diode?
For a sinusoidal input of 40 V (p-p) to the given circuit, what is the minimum value of the output waveform? NOTE: * use ideal diode
1 Draw the output waveform of the following Clamper’s circuits while the input is given below and biasing voltage (V=5v) is 5 v. Practical silicon diode is to be considered for analysis to draw output waveform.
Find the applied voltage on a forward biased diode if the current is 1mA and reverse saturation current is 10-10. Temperature is 25°C and takes ideality factor as 1.5.
electronic
!
There are two LEDs that can be used as a polarity detector. Apply a positive source voltage and a green light results. Negative supplies result in a red light. Packages of such combinations are commercially available.Find the resistor R to ensure a current of 20 mA through the “on” diode for the configuration. Both diodes have a reverse breakdown voltage of 3 V and an average turn-on voltage of 2 V
An AC voltage peak value of 20 Volts is connected in series with a silicon diode and load resistance of 500 ohms. if the forward resistance of diode is 10 ohms. Find the peak current through the diode and the peak output voltage? Vin 500 2 out O 32 mA, 25 V O 30 mA, 15 V O 37.8 mA, 18.9 V O 40 mA, 20 V
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to IL-DC =0:5A RL VL-DC =20V 220V omsb O 001 F O 0.02 F O 0.0167F O None of the above Activate