A bracket is formed from two steel T sections welded together and supported as shown below. If the bracket carries a load of 10 kN. What are the maximum and minimum stresses in the section marked X-X? What is the radius of gyration? 5 mm 100 115 mm 5 mm Section X-X (Plan View) 10 kN

compute the maximum stress in the member, considering stress concentrations.

Determined the maximum normal stress experience by the entire axial member and determine the section, which maximum stress occurs(ie AB or BC or CD)

The frame in (Figure 1) supports a centrally applied distributed load of 1.8 kip/ft. The pins at C and D are at the same location as the neutral axis for the cross section. Figure 12 ft C A 5 ft- HH 3 in. 3 in. 1 in. B 1.5 in. 6 in. 16 ft 1.8 kip/ft D 1 of 1 > Part A Determine the state of stress at point A on member CD. Enter your answers in kilopounds per square inch to three significant figures separated by a comma. Enter negative value for the normal stress in the case of compression and positive value in the case of tension. A. TA 10.744,0 Submit Part B VAΣ 1 vec X Incorrect; Try Again; 5 attempts remaining OB. TB = Previous Answers Request Answer Submit Determine the state of stress at point B on member CD. Enter your answers in kilopounds per square inch to three significant figures separated by a comma. Enter negative value for the normal stress in the case of compression and positive value in the case of tension. VAΣo↓vec - 23.236,0 Previous Answers Request Answer X Incorrect;…