A bandpass filer of bandwidth 4 KHz is required to constracted from a highpaas filter of cutoff frequency SkHz und a lowpass filter. Calculate:

Q: Vm(t)=Vmsin(2pi*1000t) and an unmodulated carrier Vc(t)=15sin(2pi*500t),determine number of set of…

A: GIVEN:                vm(t)=vmsin(2π1000t)vc(t)=15sin(2π500t) FIND: (a) number of set of sideband…

Q: Obtain DFT of the following sequence: x(n)= (0.5,0.5,0.5,0.5,0,0,0) using decimation in frequency…

A:

Q: 3.7 A modulating signal is of the form: m(t) = 5 sin (2000nt) and the carrier signal c(t) = 10 sin…

A:

Q: A parallel LC circuit with a Q of 60 is used to select the VHF output signal. What is the…

A: We know that; Attenuation = 1Q

Q: Given w(f)=2e−1/10||−f||. (a) plot W(f) (b) find the 6dB bandwidth of the signal

A:

Q: A transmitter has a power of 207 mW and transmits at 2.4 GHz to a receiver at the distance of 101…

A: The solution is given below

Q: Assess the value of representing signals in the frequency domain. Determine the internal noise power…

A: Given T = 140k, Bw = 500Mhz Find noise power

Q: Determine the resonant frequency wr, resonant peak Mp and bandwidth for the system whose transfer…

A: The given transfer function is: G(jω)=14(jω)2+j3ω+14 The standard form of the transfer function is…

Q: Discussion: 1. Compute the Band Width and Power of AM-SSB? 2. Which side the filter is select (upper…

A: We need to tell about amplitude SSB modulation

Q: For the DTFT spectrum shown in figure, find the value of centre of gravity of the signal x (n) ↑…

A: According to the question, for the DTFT spectrum, as shown below, we need to find the center of…

Q: Discrete signal x[n] is given by the following graph. Plot the filtered output signal y[n] when a…

A:

Q: A Carrier of 450 W,1MHz is amplitude modulated by sinusoidal signal of 15 KHz to a depth of 50%.…

A: Given: In an Amplitude modulation PC=450 WAC=1 MHzfm=15 kHzμ=50%=0.5

Q: Tow does the bandwidth change in relation to increasing signal amplitude ? Vhat are the tynes

A: We are authorized to answer one question at a time, since you have not mentioned which question…

Q: For R1=3k, C=0.1uF, and R2=12k, what is the type, passband gain and corner frequency of this filter?…

A: Filters are the device used to obtain the desired part of the signal or remove the unwanted part of…

Q: Consider an angle-modulated signal that is given by p(1) = 10cos(20000007 +10sin(2000z1) +…

A:

Q: Derive the frequency response H(w) = for the following active filter. %3D

A:

Q: 1. If the Q factor of a bandpass filter with fixed resonance frequency increases, A. what would…

A: " Since you have asked multiple questions, we will solve the first question for you. If you want an…

Q: 2- for The high pass filter Shown bellow derive the R

A:

Q: Designband pass filter T section with cut off at 5 kHz and 10 kHz operating into a load of 500 2.

A: Given parameters

Q: 1. When a low-pass filter is used, what sideband is being filtered? the lower or the upper sideband?…

A: 1) Low pass filter is used when we want to remove the higher frequencies. So if we use Low pass…

Q: What is the normalized passband edge frequency wp in Hz (to 2 decimal places), when the following…

A: Types of filters Low pass filter  High pass filter  Band pass filter  Band stop filter

Q: For the network transfer function, draw the Bode magnitude plot: 25 (jw + 1000) H(jw) : (jw + 10)(jw…

A: Solve

Q: 6. A400W, 1MHZ carrier is amplitude-modulated with a sinusoidal signal Of 2500HZ. The depth of…

A: We will find out the lower side band and upper side band frequency and power for both side band and…

Q: Q.4: (a) Consider a digital sequence sampled with sampling time equal to 0.Imsec. If the size of the…

A: Given that, N=1024 Ts=0.1 msec   Frequency resolution is calculated as ΔF=1/NTs=1/(1024*0.1…

Q: A400W, 1MHZ carrier is amplitude-modulated with a sinusoidal signal Of 2500HZ. The depth of…

A: Here we will calculate side band Frequency and bandwidth and power in amplitude modulation.

Q: 1) Calculate the bandwidth and baud rate for an FSK signal with mark frequency 34 kHz, space…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Given this transfer fuction of a low-pass filter. Find the cut frequency (image attached below)

A: Cut off frequency of low Pass filter is the frequency at which gain of the filter is 12× gain at…

Q: Low eass filter |-for The Shown below derive the (Hess), (Hejws), (Wc),(Vort) 272 1v louf

A:

Q: P(t)=30cos[ 10'nt+6sin(2x10°nt)| If the modulation is FM, determine: 1. Carrier and information…

A:

Q: Find the transfer function for the circuit shown in figure 1. Plot the amplitude graph of 2logh10hw…

A: Let us review the impedance offered by passive elements.  The impedance of a capacitor reduces with…

Q: Calculate of the modulation index and power sidebands of the waveform X(1)= 10 [1+ Cos2krt +…

A:

Q: For an AM commercial broadcast band receiver (535 kHz to 1605 kHz) with an input filter Q-factor of…

A:

Q: Using a 15-k(ohm) resistance, design an RC high-pass filter with a breakpoint at 200-kHz.

A: Breakpoint frequency for RC high-pass filter is given by: fc=12πRC Given:fc=200 kHzR=15 kΩNow…

Q: Discussion: 1. Compute the Band Width and Power of AM-SSB? 2. Which side the filter is select (upper…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: 1. What is the advantage of angle modulation for (noise and interference), the bandwidth of…

A: Angle modulation: It is a technique where the phase or frequency of the carrier signal changes in…

Q: Microwave and Antenna Lab. Q2. The experiment results in the table below which measured for the…

A: 1- The graph below is based upon the experiment result :   For close spacing the above graph looks…

Q: Draw frequency response curve of a bandpass filter whose end frequencies are 0.1 MHz and 0.4 MHz…

A: According to the given question, it is required to sketch the frequency response curve of a bandpass…

Q: Q2) Design a normalized linear phase low pass FIR filter with a proper window type which having a M=…

A: Finite Impulse Response (FIR) filters have finite number of terms in its impulse response. It does…

Q: B) A telephone line carries both voice band (0-4 kHz) and data band (2.5/kHz to 1 MHz). Design a…

A: The Given is a telephone line carries both voice band 0-4kHz and data band 2.5kHz to 1MHz

Q: What is the noise power for a band with of 13.5 kHz at 20°C? Determine the noise power density when…

A:

Q: In a baseband system with an SNR of 20 dB, the bandwidth is 1 kHz, the input noise power is 10'-18…

A: There are some typing mistakes. The transmitter power should be 36 kW. The input noise power should…

Q: If a filter is non ideal, the gain in the passband (0 ≤ w ≤ wc) is one for the entire band, and the…

A: In this question  we have analyse the behaviour of non ideal filter. So here is given that : If a…

Q: Consider a passive RC low-pass filter created by combining a 1 kQ resistor and a 50 nF capacitor.…

A:

Q: A signal was represented using Bipolar RZ with a bandwidth of 40 kHz, then the bandwidth will be…

A: The given bandwidth is 40 Hz.

Q: INSTRUCTION: USE 5 DECIMAL PLACES A filter circuit consisting of a capacitor C, in series with a…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: For a receiver with IF, RF and Local Oscillator Frequencies of 455 kHz, 900 kHz and 1355 kHz…

A:

Q: C. i. A communication network has a bandwidth of 10 kHz. Calculate the signal-to-noise ratio in dB…

A:

Q: -(d) Sketch the pole-zero map. Is this a stable system? Why? Is this a filter? If so, of what type?…

A:

Q: Gf Consider the Circuit of Jow pass filter ?

A: The filter circuits in electronics are needed to clear the unwanted irregularities from a signal.…

Q: Determine the order N of a Butterworth filter for which Amax = 1 dB,

A: Note  “Since you have asked multiple questions, we will solve the first question for you. If you…