A balanced star-connected source has phase voltage Vab 416 230° V and a positive phase %3D sequence. If this is connected to a balanced delta-connected load, find the line and phase currents. Take the load impedance per phase as "D" Q and line impedance per phase as "E" Q.

A balanced star-connected source has phase voltage Vab 416 230° V and a positive phase %3D sequence. If this is connected to a balanced delta-connected load, find the line and phase currents. Take the load impedance per phase as "D" Q and line impedance per phase as "E" Q.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: A balanced three-phase source supplies a balanced delta load having 39 angle -40° Q per phase. The…

A: The solution is given below

Q: 6. Magnitude of line voltages is V3 times the magnitude of phase voltages V= V3 V,, what Phasor…

A: For star connection, Line voltage = sqrt(3)×phase voltage. Given VL =sqrt(3)×Vp. So we will draw…

Q: Question No. 1: Figure below gives the general D-Y transformation, (a) Show that the general…

A: The general transformation reduces to as given in figure for a balanced three phase loadFor ∆-…

Q: A symmetrical delta-connected 415V three-phase supply is feed to an asymmetrical d connected load as…

A: The solution can be achieved as follows.

Q: Example: A balanced positive-sequence wye-connected 60 Hz three-phase source has line-to- line…

A: The solution can be achieved as follows.

Q: Note: It is expected from student to develop impedance matrices of three phase power system. Develop…

A: From the given power system network Impedance matrix is develop as shown below

Q: In abalanced Three Phase System The Source is balanced Wye With an abc – Phase Sequence and Vab =…

Q: In a balanced three-phase system, the abc-phase- sequence source is wye connected and Va 120/20 V…

Q: (b) A symmetrical delta-connected 415V three-phase supply is feed to an asymmetrical delta-…

Q: Apply single-phase equivalency to determine the line currents in the Y-Δ network in the figure…

Q: A balanced delta-connected load with impedance per phase of 30/30° 2 is connected to an abc-sequence…

A: According to given question ,Given :

Q: 3. A balanced star-connected source has phase voltage Vab = 416 ∠30º V and a positive phase…

A: Given data: Vab=416∠30° V

Q: A positive-sequence, balanced delta-connected source supplies a balanced delta- connected load. If…

Q: Derive an expression for the input impedance Zin in terms of the load impedance Z₁ and the…

A: Given We need to derive an expression for input impedance in transmission line. Please find the…

Q: A balanced three-phase source supplies balanced delta load having 39 angle -40 ohms per phase. The…

Q: . Calculate the line currents for phase a, b and c. 2. Calculate the line-to-neutral voltages at the…

A: From the given circuit Van = 120 ∠0 V V bn = 120∠-120 V V cn = 120 ∠-240 V R a=R b=R c=…

Q: balanced three-phase Delta connected voltage source supplies Delta connected three-phase symmetrical…

A: In the question the source is balanced and connected to balanced load through transmission line. For…

Q: Note: It is expected from student to develop impedance matrices ofthree phase power system. Develop…

A: Given: Pwer sytem network Z-bus can be build by the 4 types of modification:Type-1: New to…

Q: 2. In an unbalanced system, the phase voltages are: Vna = 13240 What is the line to line voltage…

A: In this question, Unbalanced voltages are given. Find the line voltage VCB ? VCB = Vnb -Vnc

Q: A balanced star-connected source has phase voltage Vab = 416 ∠30o V and a positive phase sequence.…

A: The source phase voltage is given as:

Q: A delta-connected load whose phase impedances are ZAB = 50 Ω, ZBC = −j50 Ω, and ZCA = j50 Ω is fed…

A: This is perhaps the most practical three-phase system, as the three-phase sources are usually…

Q: Illustrate the phasor diagram of the phase and line voltage of the given data below. VL230° VLZ -…

A: In the question, Draw the phasor diagram of the given data. We are solving this problem assume…

Q: A three-phase load impedance consists of a balanced wye in parallel with a balanced delta. What is…

Q: Q4. The magnitude of the phase voltage of an ideal balanced three-phase Y-connected source is 125 V.…

Q: Consider a three-phase Y-connected source feeding a balanced-Δ load. The phasor sum of the line…

A: Please find your answer below in step 2.

Q: Given a balanced three-phase system - Δ-connected load with an impedance of 12 + j9 Ω/ϕ -…

A: Power system problem Look below for the detailed explanation..

Q: Find the total impedance, total current drawn by the system, total power (apparent) delivered by the…

Q: Pzi-The of abalanced Y connested load is-- Each phase of the load Consist of loL30 S Find the active…

A: Star connect balance load. Line voltage VLL = 100∠0V Per phase impedance = 10∠30 ohm Find the…

Q: low voltage systems In the circuit given below, single-phase powers connected to the single-phase…

A: V= 220 at angle 0° Load 1 is capacitor and load 2 is inductor Then

Q: 7 8. A three-phase balanced load is supplied by VCB = 300 sin (wt - 25°) V, CAB circuit where the…

A: The solution is given below

Q: An unbalanced delta-connected load is supplied from a 400-V, 3-ph, delta-connected alternator…

A: Delta connection is a mesh type connection made to the electrical apparatus and the three phase…

Q: rom the given circuit, take V₁ = 240, Z₁ = 20 - j3 ohms. Find the phase currents and line urrents.…

A: The given three phase system is balance. So we can analyse the circuit by per phase analysis.

Q: A 3-phase, 208V system supplies a delta load with impedances ZAB = 150 235°, ZBC %3D - 12Ω /20ο and…

A: In this question, Three phase Delta unbalanced impedance is given. Find the line currents, active…

Q: 11.47 In a three-phase balanced delta-delta system, the source has an abc-phase sequence. The line…

Q: Three Impedances each of (9 - j18)N are connected in mesh across a three-phase 415V ac supply.…

Q: Note: It is expected from student to develop impedance matrices of three phase power system. Develop…

Q: A balanced star-connected source has phase voltage Vab = 416 230° V and a positive phase %3D…

Q: In abalanced Three Phase System The Source is balanced Wye With an abc – Phase Sequence and Vab =…

Q: In the balanced positive sequence three phase system shown, if Van = 120 z15° v and ZA (4+j3 ) Ω.…

Q: Consider the following three Phase balanced Circuit 210 20⁰ Vrms jasn 210/120⁰ Vrms 24-321 jost mm…

A: The three-phase delta connected load is shown below: The per-phase equivalent load impedance will…

Q: Find the RMS line voltage VL at the source of the circuit. As shown the RMS load phase voltage is…

A: 3 phase balance load connected to balance system Voltage across load 100V Then find source…

Q: (d) In a balanced three-phase wye-wye (Y-Y) system, V;< = 200210° Vrms. The load impedance per phase…

Q: Given at the load: What are the real and reactive power and power factor at the load? Exclude the…

A: We need to find out the power of given voltage and current

Q: A positive-sequence, balanced ∆-connected source supplies a balanced a ∆-connected load. If the…

Q: A balanced 3-phase power supply is connected to a balanced Y load of impedance Z1 R+j92 and a A load…

Q: For the circuit shown above, what is the magnitude of the load impedance Z₁ that will result in…

A: According to question, given circuit is for maximum power transfer Load impedance= Zth* where Zth…

Q: 3. Consider a three-wire Y-Y circuit. The voltages of the source a 208 120° Vrms, and Ven = 2120°…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: shown below, de following: a) The impedance Zi that results in maximum average power transferred to…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: For a 3-phase Y-connected balanced load, at the terminals the following are given: Vea = 4804170°V…

A: It is given that: Vca=480∠170°VIb=40∠-130°A

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

D= 10 <30degree

E= 3+j8

3. A balanced star-connected source has phase voltage Vab
416 230° V and a positive phase
sequence. If this is connected to a balanced delta-connected load, find the line and phase currents.
Take the load impedance per phase as "D" Q and line impedance per phase as "E" Q.
4. (a) What is leading and lagging power factor? and discuss about the reasons for the low power
factor.
(b) Discuss about the power factor improvement methods

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

6.5% ans ex A so kvA. 2o00/20 V, So He single-phase transformar has impedance drof of8% and resistance drop of 4%. Caleulate. The Requlation of the Thams former at full- Load o8 P.s Legging. also find The Power factor at which Voltage requlation will Be Zero. Sols 0.5 leading. s alculate The % Noltege Requlation af atransformar in w hich the Percantage resistance drof is 1% and Percentage dre is 6% when The Power fador is 0.8 lagging ) > unity aMS 38 % ans 1 % (シ→ 0.8 leading . amS - 2.2%
Please help with this balanced three-phase circuit problem.
Explain current divider rule in ac circuits with two parallel impedances Z1 and Z2. Calculate the currents I1 and I2 in phasor form for the circuit given in figure.
The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
(b) A symmetrical delta-connected 415V three-phase supply is feed to an asymmetrical delta- connected load as shown in Figure Q2(b). Assume that it is a RYB sequence. The impedances of the load are ZRY = 50 +j50 Q , ZYB = 150 + j0 Q and ZBR= 50 – j50 N. (i) Determine and draw the phasor diagram of phase currents in the load. (ii) Determine and draw the phasor diagram of line currents in the system.
In the 3-phase circuit in the figure, f = 2000 Hz. Find line and phase voltages and currents for the load.(in amplitude and phase).
Consider the circuit shown. Find the following: a. Total load impedance seen by the voltage source. b. Complex power delivered by the source. c. Average power delivered by the source. d. Reactive power delivered by the source. e. Load power factor and power factor angle.
Q5/B: Explain delta-star connection of 3 ph transformers. What its advantages and disadvantages?
2) A 30- resistor, a 15-0 inductive reactance, and a 12- capacitive reactance are connected in parallel across a 120-V 60-Hz line. Find (a) the phasor branch currents, (b) total current and phase angle, (c) impedance, and (d) power drawn by the circuit.
Two 7970-V:230-V single-phase transformers with impedance with respect to their secondaries of 1.5 + j3 and 2 + j4.5 ohms are connected in parallel to a 7900-V source. Their secondaries are supplying a common load of 30 + j40 ohms. What is the magnitude of the voltage across the load in volts? (2 decimal places)
The section bus-bars A and B are linked by a bus-bar reactor rated at 6000 kVA with 12% reactance. On bus-bar-A, there are two generators each of 10 MVA with 8% reactance and on bus-bar-B, two generators each of 6000 kVA with 10% reactance. Find the steady MVA fed into a dead short circuit all phases on B with bus-bar reactor in the circuit.
One side of a transformer has What is the voltage (in V rms) at the secondary? 1,800 turns while the other side has 450 turns. The high voltage side is connected to a 240 Vrms source. The low What is the current (in A rms) at the secondary? What is the current (in A rms) out of the source? What is the value of the load impedance when referred to the primary? • Referred impedance = voltage side (secondary) is connected to an impedance ZL = 20 + j10 Q. Provide at least 4 digits after the decimal point. +j_ N What is the value of the source voltage (in V rms) when referred to the secondary?