A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil of resistance 25 ohms and inducrance 0.5 henry in paeallel with a purw resistance of 28 ohms and a pure capaciror of 60microfarads capacitance ,in each branch. Calculate a. The line currents The answer has to be 9.3A

Q: A voltage and current applied to a single phase load is v= 195 sin (300t+35°) and i= 175 sin (250t-…

A: Since frequency are different so  Net real power will be zero in single and 3 phase system.

Q: In a capacitive load, the current angle: Between 90 and -90. Leads the voltage by 90.

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance…

A:

Q: A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil…

A:

Q: The of air surrounding the power conductor is the phenomenon of corona. capacitors are used across…

A: Ionisation of air surrounding the power conductor is the phenomenon of corona    Synchronous…

Q: From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri…

A: Secondary voltage = primary voltage ×(secondary winding  turns /primary winding turns) I.e  Vsec=…

Q: A 10 ohm resistor and a 1 mF capacitor are connected in parallel to a 50 Hz ac source. Express the…

A: If a resistor of resistance R and a capacitor of capacitance C are connected in parallel to an ac…

Q: A load of 60 -j80 has a current of 9.60 A with a phase angle of 30°, the total reactive power is:

A:

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

A:

Q: Question 20 A parallel circuit consists of a 74 ohm resistor and an inductor having 80 ohm…

A:

Q: Find the impedance angle Each load on the left is 25.1972+j240.0237 ohms. Voltage source is 230V…

A:

Q: 22.) Compute the phasor voltage Vo using the voltage divider rule. The frequency is 60Hz. Answer:…

A:

Q: A voltage and current applied to a single phase load is v= 115 sin (300t+40°) and i= 115 sin (250t-…

A:

Q: If there is no fault, find the low power profile 1. Pr 2. QT 3. ST 4. pfr

A: The three-phase system is a cost-effective means to transmit large amounts of power across long…

Q: • 1. Determine the equivalent impedance and the equivalent admittance. Zeq -jion 1202 jisa M 652 :8…

A:

Q: During fast decoupled Method load flow analysis in one of the loads the calculated reactive power…

A: The power system analysis has non linear equations of power. The equations are  involving voltage…

Q: the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a…

A: In this question,   We need to choose the correct options What is shunt capacitance is a capacitor?…

Q: Question 6 Vs 20020°V L L S. rms In the circuit in the figure; Lload draws 15 kVA with lagging power…

A:

Q: A voltage and current applied to a single phase load is v= 26 cos (300t+25°) and i= 12 cos (250t-…

A: If a voltage v=v1 cos(wt -α) and current i=i1 cos(wt-β) flow through any load then the total active…

Q: balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil of…

A:

Q: Find the current through the capacitor of (-j5) capacitance reactance using NODAL ANALYSIS. Current…

A:

Q: There phase power supply load R is 1699 VA, S is 15584 VA and T is 12818 VA. Find (a) the…

A:

Q: 5. A 250 V phase voltage supplies power to an unbalanced star connected load where the impedances…

A: 5) To find the total power drawn by the a 3-phase unbalanced star connected load

Q: The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical…

A: Given: Load-1:P1=950Wcosϕ1=0.5 LaggingLoad-2:P2=1.14Wcosϕ2=1Load-3:P3=760Wcosϕ3=0.5 leadingline…

Q: Referring o figure shown below, determine the a. total impedance b. branch current IT, I1, and I2…

A:

Q: Explain why the phasor and the impedance have the same angle

A:

Q: The terminal voltage for cases where the cosQ value is reverse, forward and 1, respectively,…

A: It is asked to draw the phasor diagrams for the terminal voltage for case where power factor  is…

Q: 図2j20 J122 201 Zs 25 10-jloSL 回a 回 ZE 248-j6 CALGULATE (A) THE TOTAL IMPEDANGE, (B) THE GURRENT Z3…

A:

Q: n a parallel R-C circuit, the current flowing through the resistor and the capacitor are in phase.…

A:

Q: The total impedance of the circuit iz Lw Żtotal = R+ Žequiv = R – j- %3D w2 LC – 1

A: Z⏞total=R+Z⏞equivZ⏞total=R-jLωω2LC-1

Q: XL 100 0 A1 Q3 Xc R Vs 1 <0° Vrms AC 150 0 220 0

A: Phasor form

Q: A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil…

A:

Q: on A Load absorbs 10 KVA at a leading power factor of 0.6 The complex power is: Select one: O a…

A: The is a problem of circuits.  Given:- Load power |SL|= 10 kVA  Power factor, cos(phi)= 0.6 leading…

Q: The reactive factor is the cosine of the phase angle between the voltage and the current Select one:…

A:

Q: Delta to Wye Conversion with figure

A:

Q: what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms

A: The solution can be achieved as follows.

Q: Shunt and series generates can connected in parallel. O True O False

A: Generator:- It is used to convert mechanical energy to electrical energy. DC and AC generators are…

Q: A single phase inductive load draws 10 MW at 0.6 power factor lagging. What is the value of the…

A: Given data:Required information:

Q: A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos3000t- 0.5sin4000t) A is applied to the…

A: Given iT=2+1.5sin100t+1cos3000t-0.5sin4000t A

Q: Three impedances, Z1 =1000•Q, Z2 =63.2518.43.2 and Z3 =1002-90•Q are connected in star. Convert the…

A:

Q: 8A voltage of 25020 is ad pplied to Inquctive cirwit of mpedance q Sompedance (5+40) caleulate…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance…

Q: A 1602 resistor, an 8302 inductive reactance, and a 20 capacitive reactance are in series. A 120V…

A: Given: Resistance = 16Ω Inductive Reactance= 83Ω Capacitive Reactance= 20Ω

Q: Add the following two impedances (a) in series and (b) in parallel. Z1 = 4 + 3i and Z2 = 12 + 5i

A: The question is about finding equivalent impedance in series and parallel.Given, Z1 = 12+5i