A 600mm diameter pile is embedded in 3 layers of dense sand at a depth of 17m. Nq = 86. The groundwater table is situated between Layers 2 and 3. The layers have the following properties: Layer 1: γ = 16.9 kN/m3. 3m thick. Layer 2: γ = 17.6 kN/m3. 5.5m thick. Layer 3: γsat = 19.65 kN/m3. K is 0.9 and tan α = 0.37. The factor of safety is 3.0. What is the skin friction resistance of the pile in kN?

Q: A normally consolidated clay is consolidated under a triaxial chamber confining pressure of σ = o'₁…

A: Detailed solution is provided belowPlease read carefullyThank you. Explanation:Step 1:Step 2:Step 3:…

Q: A recently constructed long Embankment is shown in the figure. It was made from compacted (Rolled)…

A:

Q: Calculate total stress, pere wev s at B, A Dry Sand Void ratio = 0.52 3m %3D G, = 2.65 %3D Sand Void…

A: Given data : For Point B  Void ratio (e)=0.52Specific gravity (GS)=2.65

Q: Calculate the consolidation settlement in clay layer depending on an increment in stress level of…

A: Calculation will be done for upto mid layer of clayey soil.

Q: 85 kN/m2 25 kN/m2 Try solving the following problem: Practice Problem 1: (Repeat practice problem…

A: Given data  σx = -45 KN/m2 σy = -85 KN/m2 τxy = τyx = -25 KN/m2 θ = 90° - 40° = 60° (plane AB make…

Q: An embankment consists of clay fill for which c′ = 25 kN/m2 and φ = 27° (from consolidated undrained…

A:

Q: The lower sand layer in the soil profile shown below is in an artesian condition. Calculate: 2 a)…

A: Given data : It is a multipart problem from Soil Engineering/Mechanics or Geotechnical Engineering.…

Q: Problem No. 1 A circular foundation 2 m in diameter is shown in Figure. A normally consolidated clay…

A:

Q: • Thickness of sand layer = 6 m (i.e. X = 6 m) • Thickness of gravel layer = 5 m (i.e. Y = 5 m) •…

A:

Q: 7. Figure 6 shows a clay layer of thickness 2H = 8m contained between two sand layers and subjected…

A:

Q: Knowing that the compression index, Cc = 0.333, and the preconsolidation pressure s’c = 140 kPa with…

A:

Q: In a tri-axial test for a normally consolidated soil, the deviator stress is equal to 700 kPa and…

A:

Q: 7- In a triaxial test for the normally consolidated clay, chamber confining pressure = 50 kN/m2 and…

A:

Q: Q.23 A normally consolidated clay settled by 2cm when the effective stress was increased from 100kPa…

A: Given data- A normally consolidated clay- Settlement ∆H=2 cm, Initial effective stress -  σ'o=100…

Q: Problem1) According to the given soil profile, fill the table and plot the distribution of vertical…

A: Given data- Specific gravity Gs=2.7

Q: In a drained triaxial compression test, a saturated specimen of cohesionless sand fails at a…

A: To find angle of sharing resistance

Q: 10.17 Refer to Figure 10.47 A flexible rectangular area is subjected to a uniformly distributed load…

A: Introduction- Vertical stress is among the most significant pressures encountered by constrained…

Q: . The undrained cohesion of a remoulded clay soil is 10 kN/m². If the sensitivity of the clay is 20,…

A: Undrained cohesion C=10 kN/m2,Sensitivity of clay S=20,The value of the remoulded compressive…

Q: A clay layer of (4 m) thickness was subjected to a surface loading that caused an increase in the…

A:

Q: 1. Compute the effective stress at the mid-height the clay layer. a. 80.21 kPa c. 51.30 kPa b. 84.58…

A: All the given data presented in the figure itself below asneed to find The effective stress in the…

Q: Yu = 10 k N/m? J = 14 kN/u² clay Osat = 15,5 kN/ms Diagram 2 GWL -2.00 r = 16 kN/m³ sand I sut =…

A: Total stress = Y*h Pore pressure=Yw*h Effective stress = total stress-pore pressure

Q: SIT N. Assume a buried stratum of clay 1.83 m thick will be subjected to a stress increase of 33.6…

A:

Q: Determine the moment magnitude in a place where the length of the rupture was 550km, the slip was 2m…

A:

Q: Situation 6 - A consolidated drained triaxial test is conducted on a normally consolidated soil with…

A:

Q: An unconfined cylindrical specimen of clay fails under an axial stress of 240 kN/m. The failure…

A:

Q: The results of a three consolidated undrained tri-axial test on saturated clay are as follows:…

A:

Q: For a normally consolidated insensitive clay 0_CD= 30°. Deviator stress at failure of the same soil…

A:

Q: 1. Determine the total stress, porewater pressure, and effective stresses at the top and bottom, at…

A:

Q: A borehole. A clay layer is discovered 7m below a sandy soil. The groundwater table of the area is…

A:

Q: 1. At the bottom of the Lean Clay layer described below, find the total and effective horizontal…

A: Data given: First layer: Sand with silt (SP-SM) γt = 19 kN/m3 h1 = 9 m Second layer, Lean clay γt=…

Q: A deposit of silty clay is being considered for use in constructing a containment dyke. Vane shear…

A:

Q: 9 m 1 m 1 m 12 MN Pier: 3 m x 10 m 3 m 5 m Dense sand e = 0.45 E' = 55 MPa v' = 0.35 $ = 36°…

A: First of all we need to calculate the effective stress at the center of clay layer. then we will…

Q: determine the consolidation settlement

A:

Q: 7.9 A specimen of soil was collected from a depth of 12 m in a deposit of clay. The ground water…

A: Given Depth 12 mLiquid limit 68Plastic limit 29Saturated unit weight 17.8 kN/m3Preconsolidation…

Q: Pre-consolidation stress at sample depth (kPa) = | |.... No decimals needed Based on the o'z0 value…

A: The soil at a depth experiences stress due to presence of overburden or other loads. These stress…

Q: i. The following information is collected from rock coring process in which the total core advance…

A: Given data,total core advance 65cmcore recovery20761016FINDa)total core recoveryb)the core recovery…

Q: Qus: In a direct shear test on sand (C = 0) area of circular box was 50 cm ^ 2 normal load was 750…

A: Normal load (P) = 750 KN  Shear load (V) = 460 KN  Area of box = 50 cm2  Cohesion (C) = 0  Determine…

Q: A footing of size 2mx 2m transferring a pressure of 200 kN/m², is placed at a depth of 1.5 m below…

A: Given : Size of footing =2m×2mPressure on soil=200kN/m2Depth of footing or depth of soil…

Q: 7. Consider a stress state where p = 15 and q 12. The relevant soil properties are o = 35° and c= 3.…

A:

Q: Problem1) According to the given soil profile, fill the table and plot the distribution of vertical…

A:

Q: A soil has an angle of shearing of 30° and cohesion of 35 kN/m^2. If the specimen of this soil is…

A: Angle of shearing = 30o Cohesion = 35 kN/2 Total Stress = 300 kN/m2 To Find : The value of lateral…

Q: soil element shown in figure 1 where the magnitude stresses on σx= 10KN/m3 and τ= 40Kn/m3, σy =…

A:

Q: Consider the following hydraulic structure formed on sand: T 5m → E 5 m 5 m2m. -5m- 4 m The uplift…

A: Given structure: γw=10 kNm3.

Q: A 2.5m thick clay is to support a footing as shown below. Assume that the pressure increase Ao' is…

A:

Q: 1. At what depth would the total vertical stress in a deposit of clay (e = 0.9, Gs = assume,…

A:

Q: In a direct shear test on sand (C = 0), area of circular box was 50 cm², normal load was 750 kN and…

A: C= 0 Area of circular box = 50 cm2Normal load = 750 kNFailure load = 460 kNTo Find : ?

Q: For the layered soil shown in the figure, H1 = 5 m, H2 = 5 m, and H3 = 20 m. The soil densities are…

A:

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.