A 60 Hz sinusoidal voltage is applied to an SCR full-wave rectifier. If the DC output voltage is 58 V and the firing angle of the SCR is 135 degrees, the RMS voltage at the output would be: O A. 98 V O B. None of the other choices are correct O C. 266 V O D. 399 V O E. 133 V

A 60 Hz sinusoidal voltage is applied to an SCR full-wave rectifier. If the DC output voltage is 58 V and the firing angle of the SCR is 135 degrees, the RMS voltage at the output would be: O A. 98 V O B. None of the other choices are correct O C. 266 V O D. 399 V O E. 133 V

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 3RQ: Diodes and rectifiers allow current to _________. flow in one direction only flow in both...

See similar textbooks

Related questions

Q: If a 25μH inductor is connected to a voltage shown in the figure below: The current through the…

A: The mathematical expression of the given waveform can be obtained by using the line equation and…

Q: The series circuit has Vsupply 12Volts, R₁ =1K2, R₂ =2 K R3 = 3 KM; • What is the total current of…

Q: Find the closed-loop, optimal control law u*(t) in terms of the states x* (t) as u* (t) = -KLQRX*…

A: Given: Performance index: J=∫0∞x12t+x22t+u12t+u22tdt. System equations: x˙1t=x2t+u1t,x˙2t=u2t.…

Q: The series circuit has Vsupply 12Volts, R₁ =1K2, R₂ =2 KQ R3 = 3 KQ; • What is the power dissipater…

Q: Required information Problem 06.037 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS The current…

A: We need to find out the energy stored by inductor.

Q: 1. Determine and sketch the following signal if : a. x[-n] b. x[n+2] c. x[-n + 3] x[n] = { 3, 2, -2,…

Q: Voltage Across Resistor - using node Analysis, determine the Voltage Vo in [V] for the Circuit Shown…

A: To analyze the network circuit and find the voltage or current through any component Kirchoff's law…

Q: A parallel-plate air capacitor with a capacitance of 257 PF has a charge of magnitude 0.140 μC on…

Q: What are the benefits of CHP(combined heat & power) application?

Q: 1. 10 I2 13 102 H

Q: Reduce the system shown in Figure 1 to a single block represented by the transfer function. R(s)- G₁…

Q: How can you replace a diode with a BJT. Could you also draw an example of circuit where the diode…

A: There are many situations when we can replace diode with BJT.

Q: 1.2 kΩ R3 is parallel to 1.8 kΩ R2 . This parallel connection is in series with 200 Ω R1 , 680 Ω R4…

Q: A strain gauge transducer is constructed in a Wheatstone bridge circuit configuration. In the null…

Q: Find the Transfer Function of the block diagram drawn in Figure 3 using Block Diagram Reduction…

A: The transfer function can be obtained by reducing the series and parallel connected block reduction…

Q: Vm= 50 mV o- wwwwww R, 100 ΚΩ 10 ΚΩ R3 10 ΚΩ R₁ ww all choices apply bandwidth decreases As the…

A: Types of operational amplifier Inverting operational amplifier Non inverting operational…

Q: The single-phase half-wave controlled rectifier supplies a resistive load drawsan average current of…

A: Given data, Average current i0=1.62 A. Supply voltage V = 240 V. Frequency f = 50 Hz. Average output…

Q: Two voltages v₁ and v2 appear in series so that their sum is v= V₁ + V₂. If v₁ = 12 cos(50t - T/3) V…

Q: What is the difference between engine, generator and motor ?

A: We have to give the difference between engine, generator and motor.

Q: Required information Problem 05.001 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS The equivalent…

A: We need to find out the output impedance for given circuit.

Q: total Impedance - for the circut shown assume that the Voltage Sowee angular frequency is W = 500D…

Q: ! Required information The oscillation circuit shown below uses an ideal op amp, where R₁ = 130 k…

Q: 7A( + )3A V, () >42 62 (4) k +₁

A: Note: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits.…

Q: 50 Ω. 3. Determine Zin of a lossless 50 2 transmission line N/4 long having a ZL =

Q: 5. An ideal Si MOS capacitor at room temperature is shown in figure Q5. When Ve is applied to the…

A: The Energy band diagram of the MOSFET is given as

Q: A three-phase, three wire, CBA system with a line voltage of 120 Volt, has three impedances of 30…

A: Note: In R Load, the current voltage will be in phase In Inductive load, current lag voltage In…

Q: A transmission line is being built to bring power to a remote community, which is 40 miles from the…

Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…

A: Given, Critical frequency,fc = 12.5 MHz Angle of incidence, θi = 66° We need to determine the…

Q: following data refers to a 500 hp rolling mill induction motor equipped with a flywheel. No-load…

Q: A 250 V dc motor has an armature resistance of 0.5 0. It is drawing an armature current of 25 A,…

A: Types of DC Motor Seperetely excited DC Motor Self excited DC Motor DC Shunt Motor DC series…

Q: Minimize the logic function Y(A,B,C,D) = ∑(0,1,2,3,5,7,8,9,11,14) . Use Karnaugh map. Draw logic…

Q: Assuming a signal at the input of the circuit with a frequency of 1Khz, what would be the clock…

Q: Solve for the value of the capacitance (in nF unit) if R2-1017 ohms and Xc = 2316 ohms. Round your…

A: The question is about finding capacitance value.

Q: From the response below, determine the values of Mp, Tp and T§. Amplitude 1.8 1.6 1.4 1.2 0.8 0.6…

Q: Determine the forward voltage drop across the diode whose characteristics appear in Fig. 1.19 at…

A: According to the question, for the given V-I characteristics as shown below We need to determine…

Q: By using mesh analysis, find I, and I, in the circuit depicted in Fig. 1 j4Ω m 3 Ω ww I, 30/20° V ww…

Q: Given the circuit below, determine the Q of the network and calculate the phas voltage Vo as well as…

Q: 9. In a circuit with a 12 volt supply and 40 resistance, the power consumed is watts.

A: Given data, Supply voltage V = 12 V. Resistance R=4 Ω.

Q: The signal x(t)=sinc (5t) is applied at the input of the following LPF with = 2 . Determine (a) X…

Q: 80 dB is 40 10 100 80 20 OL

Q: Consider the RC circuit in the figure. Take R = 10. + V₁ 10 R 20 nF + V₂ Calculate the phase shift…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: in 20 mV, 1 kHz PP wwwwww 294 kHz 256 kHz 265 kHz 244 kHz 218 kHz out R • 82 ΚΩ ER * 10 ΚΩ Vin= 20…

A: The given inverting amplifier is shown below: The closed-loop voltage gain of the above inverting…

Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…

A: Given: Critical frequency, fc=12.5 MHz Angle of incidence,i=650

Q: 001 ohms 100 V 230 ohms 020 ohms 424 ohms io = 18 mA. R www 4 ΚΩ Find R. 3 ΚΩ ww + AI V₂ +AI

A: In this question We need to determine the value of Resistance R. We know Resistance R= V/I

Q: 1A ΣΩΤ 202 ΙΩ 24 b ΙΩ

Q: 2. Explain working principle of 3-bit digital to analog converter.

A: Digital system is used for computer, control, communication, Instrumentation. Analog signal is…

Q: 32V 4Ω | 24 1Ω a Ο

A: Fir given circuit it is asked to find the thevenin's equivalent circuit from left to the terminals…

Q: A 60 Hz sinusoidal voltage with an RMS value of 120 V is applied to a single-phase full-wave SCR…

A: it is asked to find the dc output voltage of single phase full wave scr rectifier

Q: Q1 In digital signal processing technique, beside analog and digital signal there are continuous and…

A: 1)a) Given, The continuous time signal is x(t) = 2 cos(2πt+0.1) -5 cos(6πt-0.1) Sampling frequency,…

Q: four resistors having a value of 100 ohms each are connected parallel. what is the total resistance…

A: The resistances of the given circuit are: R1=100 ΩR2=100 ΩR3=100 ΩR4=100 Ω Since the resistances…

Question

A 60 Hz sinusoidal voltage is applied to an SCR full-wave rectifier. If the DC output voltage is 58 V and the firing angle of the SCR is 135 degrees, the RMS voltage at the output would be:
O A. 98 V
O B. None of the other choices are correct
O C. 266 V
O D. 399 V
O E. 133 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
What is the difference between a diode and rectifier?
A 60 Hz sinusoidal voltage is applied to an SCR full-wave rectifier. If the DC output voltage is 74 V and the firing angle of the SCR is 60 degrees, the RMS voltage at the input would be: O A. 220 V O B.99 V O C. None of the other choices are correct OD. 110 V O E.256 V
Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Thyristor Crout Probe Pulse Generator VC, pulses Probe Scope Thy Orso v Joad O R: 1 The output voltage across R is depicted in 0.5 0.0- b) 0.2 0.0 d)
The power output of the half-wave rectifier is rated at 102.4 W with a load resistor of 40 ohms. The RMS voltage at the output is: O A. None of the other choices are correct O B. 12.5 V O C. 102 V O D. 25.5 V O E. 51 V
A three phase full wave rectifier is shown below. The input phase voltage peak is Vm=311.128 V. The load is purely resistive of value 52. The DC and RMS output voltages are respectively equal to: Secondary 太D太D,太D, 太D。太De太D, b. Select one: O a. 180V, 240.2V O b. 514.6V, 515.04V O c. 180V, 197.2V O d. 220V, 249.2V
A three phase full wave rectifier is shown below along with peak phase voltage Vm-169.7V. The load is purely resistive. The rectifier delivers Ipc = 100 A and the source frequency is 60 Hz. The DC output voltage is %3D VDc=280.7V and the output RMS voltage is equal to VRMS=280.93V. The efficiency, FF and RF are respectively equal to: Secondary D D D, R AD. Z D. D, Select one: O a. 99.83%, 100.08%, 4% O b. 99.83%, 55.08%, 4% O C. 99.83%, 100.08%, 16% O d. 87.83%, 100.08%, 4%
if a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage drop model, the average output voltage is equal to 108.04 V 107.8 V 152.79 V 76.17 V
What is the peak load voltage in a full-wave rectifier if the secondary voltage is 20 V rms? * 28.3 V O ov O 14.1 V O 0.7 V
In a half wave rectifier, the input sine wave is 300 sin 100 TTt Volts. The average output voltage is a. 31.4 V b.95.54 V C. 102.52 V d. 150 V
When a sinusoidal voltage at 60 Hz is applied to the input of a half-wave rectifier, the output frequency is: (a) 120Hz (b) 30Hz (c) 60Hz (d) 0Hz
Zener Diode conducts current in a. reverse direction O b. both reverse and forward O c forward direction Od. Depend of the voltage