A 6.5 micro-Farad capacitor was initially charged to 10V and connected to a 6.2 kilo-Ohm resistor and a switch. The switch is then closed at t=0 allowing the capacitor to discharge. The time constant (in milli-seconds) for the circuit is: a. 0.95 O b. 0.62 C. 40.30 O d. 0.02 e. 1.05 Your answer is correct. The correct answer is: 40.30

A 6.5 micro-Farad capacitor was initially charged to 10V and connected to a 6.2 kilo-Ohm resistor and a switch. The switch is then closed at t=0 allowing the capacitor to discharge. The time constant (in milli-seconds) for the circuit is: a. 0.95 O b. 0.62 C. 40.30 O d. 0.02 e. 1.05 Your answer is correct. The correct answer is: 40.30

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter18: Direct-Current Circuits

Section: Chapter Questions

Problem 18P: (a) Find the current in each resistor of Figure P18.18 by using the rules for resistors in series...

See similar textbooks

Similar questions

(a) Find the current in each resistor of Figure P18.18 by using the rules for resistors in series and parallel. (b) Write three independent equations for the three currents using Kirchhoffs laws: one with the node rule; a second using the loop rule through the battery, the 6.0- resistor, and the 24.0- resistor; and the third using the loop rule through the 12.0- and 24.0- resistors. Solve to check the answers found in part (a). Figure Pl8.18
(a) Find the current in each resistor of Figure P18.18 by using the rules for resistors in series and parallel. (b) Write three independent equations for the three currents using Kirchhoffs laws: one with the node rule; a second using the loop rule through the battery, the 6.0- resistor, and the 24.0- resistor; and the third using the loop rule through the 12.0- and 24.0- resistors. Solve to check the answers found in part (a). Figure Pl8.18
01701&cmid=97298page38 For the following circuit in the figure below. Determine V,-V, (in units of V) for E = 48.5 V. a t of estion 20 20 50 9. Select one: OA. 8.08 OB. -40.42 OC. -9.70 OD. -8.08 OE 9.70 ous page brt sc delete backsoace ent
The capacitor in the circuit shown was charged to 9 µC. After one second of closing the switch S, the charge on 5uF the capacitor will be: in µC) 100KQ Select one: O a. zero O b. 1.08 O c. 1.22 O d. 1.62 O e. 1.353
Calculate the rate of the flashlight’s energy consumption. Suppose a flashlight has 6.8 × 102 C of charge pass through it during time 0.35 h. A. What is the rate of the flashlight’s energy consumption, in watts, if it operates at a voltage of 3.00 V?
A power supply with a DC voltage of 5.0 V discharges 500.0 J of energy through a 25 Ohm resistor. How much total electric charge must flow between the battery's terminals to discharge this much energy? a. 0.05 C b. 0.01 C c. 100 C d. 0.2 C e. 2500 C
0. An electric power station is producing 1.40 x 10 W of power that is to be sen o* town located 60.0 km away. Each of the two wires that comprise the trannion e resistance per kilometer of length of 400 x 10 Olpe/km. Find the power lont in beatin the wires if the voltage is stepped up from 2200 V to 20000 V using an ideal tranlorr. a) 1.21 x 10 Watts b) 2.32 x 10 Watts c) 1.12 x 10 Watts d) 5.59 x 10 Watts e) 1.16 x 10 Watts nhilo L4.00 yu which have their tratis
The capacitor shown below has an initial voltage of 0.15 V before the switch is closed. The resistance is 8.5 x 106 ohms and the capacitance is 2.0 microfarads. How long after the switch is closed in seconds does it take for the voltage across the resistor to drop to 0.083 V? R CH B A D
A 1000. µ F uncharged capacitor is connected in series with a 2.00KN resistor. The capacitor will be charged using a 5 V battery such that the whole circuit is connected in series. At t = 0, the switch is closed. What will be the charge when t= 1.57? A. 1.12μC B. 3.88 mC c. 3.88μC D. 1.12 mC
In the circuit below, C1 = 1.64 x 10-6 F and R1 = 41.0 Ohms. The capacitor is initially charged , how much time passes after the switch is closed before the capacitor reaches 8.5 % of its initial value? Please give your answer in microseconds, 1 microsecond= 10-6 s.
6 mC. What is the total energy stored in the circuit 7. Suppose the initiai Clarge on the capacitor in O e. 6 mC. What is the total energy stored in the circ initially? VWhat is the total energy at later time?
A 5.5-kW water heater operates at 240 V.Should the heater circuit have a 20A or a 30A circuit breaker?ii.Assuming 85%efficiency,how long will the heater take to heat the water ina 0.2085-m3 tank from 20C to 80C?The density of water is 1,000 kg/m3and the specific heat capacity is 4,200 J/kg/C.