A 400V, 3-phase Induction motor has input power of 14 KW and operates at power factor of 0.87 lagging with an efficiency of 98 %. Calculate the reading on each of the two wattmeter connected to measure the input. W1 W2

A 400V, 3-phase Induction motor has input power of 14 KW and operates at power factor of 0.87 lagging with an efficiency of 98 %. Calculate the reading on each of the two wattmeter connected to measure the input. W1 W2

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Related questions

Q: A series RLC circuit consists of an 852 resistor, a but capacitor 50 mH inductor as is shown. An…

A: A series RLC circuit is given We need to calculate a) resonant frequency. b) at half resonant…

Q: A 12kVA, 300V/150V transformer has been tested to determine its equivalent circuit. The open circuit…

A: open circuit data: current IOC = 1.8 A power loss POC = 100 W short circuit data : voltage applied…

Q: 5. 1) Find R; 2) Find R 3) Find voltage gain vo/ Vo gs Transconductance of MOSFET is gm and answer…

A: A common source MOSFET amplifier circuit is given . We need to determine the a) Input resistance Ri…

Q: 3.16 Eliminate the exclusive-OR, and then factor to obtain a minimum product of sums: (a) (KLO M) +…

A: here we have to eliminate the EX-OR and then factorise to obtain POS form. we know the some laws…

Q: Make the Routh table for the system and tell how many roots of the following polynomial are in the…

A: For the given characteristics equation the routh table needs to be formed and the number of poles…

Q: a. Draw the circuit t0 No need to solve it in time domain.

A: For the given circuit the value of initial voltage needs to be calculated and the node equation for…

Q: Consider the decaying exponential function x (t) illustrated in Figure 10. Find the Fourier…

Q: c) If in figure 2.1 the Q-point is given, VGs = -2 V, IG= 0 mA, VDs = 10 V, IDs = (4.XY) mA, then…

A: DC analysis of the amplifier will here XY=54,VGS=-2V,IG=0mA,VDS=10V,IDS=4.XY mA…

Q: Q14. Two circular conductor loops with radii R₁ and R2, respectively, having the same current I. If…

A: In the question 14, We need to choose the correct options What is magnetic field at the center if…

Q: antum Adder: a) Draw the quantum circuit for the Full Adder shown below: (label gates by name to…

Q: ( NEED ONLY HANDWRITTEN SOLUTION PLEASE OTHERWISE DOWNVOTE).Given a formula for…

Q: Question Figure shows a chopper operating from a 100 V dc input. The duty ratio of the main switch S…

A: given that buck converter has input voltage V = 100 V duty ratio D = 0.8 to find the average…

Q: Multiply out to obtain a sum of products: (a) (K' + M' + N)(K' + M)(L + M' + N')(K' + L + M)(M + N)…

Q: (b) A sinusoidal information signal of frequency 800Hz is used to frequency modulate a carrier…

Q: www 2

A: We need to draw the output voltage waveform of A1 and A2 for the given Circuit. R3=1.5 kohm, C1=10nF…

Q: Q1) For the control system shown in Figure bellow Derive the transfer function C(s)/R(s). G₁ G₂ H₁…

Q: Determine the frequency spectrum for n = 0, 11, 12, 13, 14, 15 for the signal x(t) T T? 2 TH x(1) 24…

A: The exponential Fourier series of the signal xt is given as, xt=1+∑n=-∞n=+∞jnπejnπt

Q: (a) Vs R1 R2 R3 R4 Vs=24V R1₁=452 R₂ = 60 Figure 1.1 For the circuit shown in Figure 1.1, calculate…

Q: 5. A three-phase rectification system has a voltage ripple of 14%. If the output kVp is 150, what is…

A: Given data, Output voltage VO=150 V. Ripple voltage Vr=14 %.

Q: 2 3 4 5 6 7 сл Outputs 1 2 4 8 ww mm 8 9 10 11 23 12 13 14 15 However, your first customer has a…

A: Given circuit of encoder: Encoder: A digital encoder is a device that converts a continuous…

Q: QUESTION 10 An amplifier has an output of 12.5 W. Calculate the dBm of the amplifier.…

Q: In reference to the circuit shown below (there are no initial current or charges): (a) Set-up the…

Q: For the following circu

Q: An LR circuit can be used as a "phase shifter." Assume that an "input" source voltage V = V₁…

A: Output voltage Vo=34 V. Frequency f = 125 Hz. Inductance L = 52 mH. Phase angle ϕ=270.

Q: State Boolean Algebra expression from the following logic gate circuit. Nyatakan persamaan Boolean…

Q: Q13. The graph represents the magnetic field at the center of a circular coil) as a function of the…

A: Step-1-> Ans(13)-> we have, μo=4π×10-7T.m/Aandi=1 AB=2×10-4

Q: A single-phase center-tapped transformer rectifier has an ac source of 240 V rms and 60 Hz. The…

Q: марл Using Karnaugh Map by step. Dengan menggunakan Peta Karnaugh (K-Map) ringkaskan persamaan di…

Q: Problem Solving A 3200/240-V, 60-Hz, 1-phase transformer is built on a core having an effective…

A: 1-phase transformer, E1E2=3200 V240 Vf=50 HzA = 125 cm2N2= 80

Q: A 100 kVA,3-phase, 50 Hz, 3,300/400 transformer is A-connected on HV side and Y- connected on LV…

A: It is given that: kVA=100f=50 HzV1=3300 VV2=400 VR1=3.5 Ω per phaseR2=0.02 Ω per…

Q: Use mesh analysis to determine current in the circuit below

A: In the given circuit the value of unknown current Io needs to be calculated by using the mesh…

Q: Question 6 Given a formula for i(t)=10sin(200pit+pi/8) across a capacitor (C=5microfarads). Find…

A: here we have to find the voltage across the capacitor.

Q: (NEED A NEAT HAND WRITING SOLUTION ONLY OTHERWISE WILL LEAVE A DOWNVOTE)

A: Given: A binary channel, with λ=0.5,Px=0=1-p, Px=1=p, To find: The value of p that achieves the…

Q: A long vertical wire le partially placed in a uniform magnetic field B-53 mT. The B-field is…

A: Given: I=3.7L=71θ=360

Q: Simplity z = ABC + ABC + ABC + ABC + ABC

A: It is given that: Z=A¯BC+AB¯.C¯+A¯.B¯.C¯+AB¯C+ABC

Q: 7. Consider the Laplace transfer function: H(s) = 3(s+1) (s+5) (s+3) i. Express H(s) under a…

Q: Z11 a' Z12 w www w A Z13 Z14 B Consider the balanced three-phase network. Z12-40, Z13-130.…

A: In this question We need to determine the voltage Van as shown the circuit. We are solving this…

Q: The correct order in which the following modulation schemes can be assigned, from greater than Lower…

A: here we have to give bandwidth relation between the AM, DSB, SSB, VSB.

Q: Describe thoroughly this free-running sawtooth generator that uses a Bootstrap ramp generator and a…

A: Bootstrap Ramp Generator: The Bootstrap ramp generator is responsible for generating a ramp…

Q: In a transformer that has 10 times more turns on the secondary side (side 2) than on the primary…

A: The above question is based on the EMF equation of a transformer.

Q: Consider a signal y(t) = x₁(t) * x₂(t). If x₁ (t) = 2 cos 4t u(t) and x₂(t) = sin 2t u(t). The value…

A: here we have to find the value of y(t) at t=π2 we know that L cosat u(t) =ss2+a2L sinat u(t)…

Q: 120 V ww 6Ω www 302 ΖΩ www ΔΩ D 12 Α

A: Circuit diagram is given as,

Q: You want to connect a capacitor as shown above to create a DAC. If the Arduino has a period of 5 ms…

A: For the given RC circuit connected with the Arduino for ADC application the value of capacitance…

Q: 1) Find the value of Vx. W 24V W 1.2 L W 502 W 400 105

A: NOTE: As per our company guidelines we are supposed to answer only one question. Kindly repost other…

Q: b) For correct operation as an ac amplifier a JFET must be correctly DC biased to establish an…

A: For the given circuit the role of the resistor needs to be provided.

Q: Q4: A: Draw only, a distributer (DC ring distributer) ABCDA is fed from point A with 300 v. The main…

A: Step-1->

Q: BO 300 600. 1200 1200 -ОА

A: The values of the resistances are: R1=600 ΩR2=1200 ΩR3=300 ΩR4=1200 Ω

Q: j1Ω 42 www ਨਵੀਂ 60/90°V(+ 1₁ j8 2 · j5 2 12 + 10 2

A: here we have to find the currents I1 , I2 and voltage V0 using mesh analysis.

Q: Given table 2 as below. Simplify the equation using Product Of Sum. Express your solution steps by…

Q: Convert the following block diagram to signal flow graph and find the total response C due to R, U₁,…

Question

Power factor please solve...

A 400V, 3-phase Induction motor has input power of 14 KW and operates at power factor of 0.87
lagging with an efficiency of 98 %. Calculate the reading on each of the two wattmeter connected
to measure the input.
W1
W2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given Data

VIEW

Step 2: Calculation of Wattmeter Readings W1, and W2

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An alternator has 6 poles. At what speed must it be driven to develop 120 cycles? Group of answer choices 400 rpm 4200 rpm 300 rpm 2400 rpm
In the three-phase alternator, explain why the voltage increases less rapidly as the DC current increases. please show your answer clean or readable. Thank you.
Can V curve be plotted for an alternator. If yes then what is the difference between V curve of an alternator and V curve of a motor.
The power supplied to a three-phase induction motor is 20kW and the stator losses are 1000W. If the slip is 4 %, the rotor copper loss is (a) 1520 (b) 760 (c) 800 (d) 1600
A mini-hydroelectric power plant is under a head of 275 feet. The turbine efficiency is 0.85 and the generator efficiency is 0.80. If the turbine speed is limited to 450 rpm, calculate the generator kW output.
A single phase AC motor draws 4.5 A from 220 V electricity. Three various power of the motor from the mains is 720 W. a) Calculation of the power factor of the engine. b) Calculating the Capacitance (C) and Power of the capacitor required to make the power coefficient of the motor 0,95
Three coils each having resistance of 17 Q are connected in star across 437 V, 50 Hz supply. Then the total power consumed is O 6485.84 W O 33700.41 w O 660.83 W O 756.93 W When the load on a series generator is decreased, then the flux produced will be decreased in direct proportion. Select one: O True OMIEE21 O False
(b) A 4-pole 3 phase alternator is driven at 1200 rpm. What is the frequency of the output voltage of the alternator? Explain how the same alternator can be used to generate voltage at 50 Hz.
10 kW, 230 V, d.c shunt generator is operating at rated condition with 80% efficiency. Input power and the total loss are respectively
The voltage generated by a dc generator is 230V, determine the generated emf if the speed is increased by 20% and the flux is simultaneously reduced by 10%.
What is the KW rating of a three phase 975 KVA generator at A) unity power factor B) 80% power factor C) 50% power factor
One single phase energy meter operating on 230 V and 5 A for 5 hours makes 1940 revolutions. Meter constant in revolution is 400. The power factor of the load will be: