A 4 pole induction machine is working as an induction generator. The generator supply frequency is 60 Hz. The rotor current frequency is 5 Hz. The mechanical speed of the rotor in RPM is

Q: Figure 57 M₂ M, M₂ M₂ 3. A system has one input and three output streams. Let m₁, m₂2, M3 and m4…

A: Solution !! Please see the solution attached below  Explanation: In this question for one input…

Q: A projectile is fired with initial velocity 95 m/s at an angle of 50 degrees from the horizontal.…

A: Step-1-->    we have  initial velocity(u)=95 sin(50degree)m/s    time(t)=5 sec

Q: Find the z-transform of 3n u[-n-1]

A:

Q: A segment of the network where a single Ethernet packet can be transmitted is called Node O Hub O…

A: A segment of the network where a single Ethernet packet can be transmitted is called as Collision…

Q: 3. The following are the symmetrical components sequence of phase B current: Positive = 10 cis 45…

A:

Q: Q.6 a) Name and explain the process to join any electrical component on strip board. b) List the…

A: 6. (a) Soldering is the technique used to connect any electrical component to a strip of circuit…

Q: 15. A 100-pcs Christmas light, each with 1 ohm are arranged in a parallel circuit, and is plugged in…

A: When n resistors of resistance R are connected in series, then total resistance, RT = nR In case of…

Q: Use the Laplace transform of cos ot to find the Laplace transform of e Cos ot. -al

A:

Q: A] A transmitted signal travels a distance of 72 m during a time interval. If this distance is equal…

A: Given data, Distance travelled by signal d=72 m in a time period. The travelled distance is equal to…

Q: ompute the value of the apparent power, reactive power, real power and its power factor. 25-52 WWW.…

A: Given parameters: A Series RLC circuit, Resistor, R = 25 ohm Inductor, L = 0.08 H Capacitor, C = 42…

Q: i. ii. iii. iv. Suppose that a periodic signal is defined as 2 q(t) = cos(3mt) [ k=-2 j5 k+ Prove…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: An electric heater is connected to a constant 250-V source and absorbs 1000 W. Subsequently, this…

A: Given, For an electric heater, V1=250 VP1=1000 WV2=200 V

Q: Sketch the single-sided and double-sided spectra of (10nt-n) 6 x(t) = 2 sin (10nt

A:

Q: Replace: 18 w/ -4, 40 w/ -17, -30 w/ 11, -24 w/ -16, and 10 w/ -10. The fundamental frequency is…

A:

Q: 5. The use of telecommunication for automatically indicating or recording measurements at a distance…

A:

Q: What is the wave's (a) amplitude, (b) wavelength v (volts) AAA 2 3 4 5 6 7 8 9 10 0 x (cm)

A: Given: The wave is

Q: In the circuit given below, C = C1 = C2. Find the gain of the multiple-feedback band-pass filter

A: Given circuit,

Q: In an ideal op-amp, which is not true? a) Open loop voltage gain is infinite b) Input resistance is…

A: The correct option along with the explanation has been provided in the following section.

Q: Find Vout. Rin 10 ohm 8 VO R₁ 50 ohm A Vout Ov

A:

Q: (a) In the given capacitor circuit, if you found the equivalent capacitance Ceq and replaced each…

A: Circuit -1 is correct

Q: (a) Determine "V" for the configuration of the following figure. VO 5VO- Si * * Ge 0V。 2.2Kg

A: Given,

Q: 11. Given a transfer function for H(s) that has 4 poles and no zeros, how many dB (decibels) per…

A: The attenuation is based on the number of poles and zeros of the transfer function.

Q: Determine the all-day efficiency of a 10 KVA 2220/220V 60 Hz transformer. During a day of 24 hours,…

A:

Q: A load of 1700W and COS = 0.85 is to be taken from an ideal single-phase transformer. Determine how…

A:

Q: (b) The voltage (t) in the given source-free RC circuit can possibly be equal, for every t>0, to the…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Find Thevenin's equivalent between "a" and "b". 10V 50 30 70 852 ISV 1202 20V + b

A:

Q: The armature terminal voltage of a separately-excited DC motor increases while the field current and…

A: DC motors:- Direct current motors are used for the conversion of electrical energy into mechanical…

Q: a) i) Consider the AM signal s(t) = [4+3cos(1000mt)]cos (20000mt). Calculate its bandwidth and the…

A:

Q: In the circuit given below, C = C1 = C2. Find the gain of the multiple-feedback band-pass filter

A: Given circuit,

Q: Problem 3 The synchronous speed of a 60 Hz, three-phase induction motor is 900 rpm. What is the…

A: Given data, Three phase induction motor has f1=60 HzNs1=900 rpmf2=50 Hz

Q: Find the value of the voltage across the 30-microfarad capacitor. 120v 0 foot 10mH ·30MF

A: The given circuit is shown below. V=120 volt, L=10 mH, C= 30 μ F Find voltage across 30 μ F.

Q: 2. Consider buck-boost converter with the following parameters: Vin=40 V, V0 =60 V, R=20 Ω, and…

A:

Q: Find the a parameters for the circuit in (Figure 1). Suppose that R₁ = 0.8 ks, and R₂ = 41.2 kn. V₁…

A:

Q: An alternating voltage is given by v=282.8 sin 314 t volts. Find (a) the RMS voltage, (b) the…

A: Given that Alternating voltage=282.8 sin314t volts------1We have to find the a RMS voltage. (b) The…

Q: In the figure R₁ = 140 02, R₂ = R3 = 54.00, R4-76.10, and the ideal battery has emf ε = 6.00 V. (a)…

A: Given circuit, E=6.00 VR1=140 ΩR2=54.0 ΩR3=54.0 ΩR4=76.1 Ω

Q: In Figure 2, V1=-4V, V2=+2V and V3=8V, The power supplies of the op-amp are +15V and -15V. What…

A: The given amplifier circuit is a voltage summing amplifier. The required parameters can be…

Q: For the following circuit: a. Find the equivalent resistor of the resistors seen by the 10 V b. Use…

A:

Q: Show complete solution. Using Kirchhoff's circuit laws, find a. l₁ b. 1₂ C. 13 d. 14 e. 15 10.52 244…

A:

Q: b) In Y-Y connected balanced system has Van 230.0 Estimate Vcb? 24

A: Given data, Circuit diagram is given as,

Q: For the circuit in Figure, determine: (a) the total capacitance, (b) the total charge 120 V 2 μF 4…

A: Given, Circuit is,

Q: A conducting bar of length L-80 cm is rotated on a conducting circular platform as shown in the…

A: Given data, Magnetic field B=12×10-3 T Angular speed ω=5 rad/s Length L=0.80 m Capacitance C=40×10-6…

Q: For the circuit given below, the equivalent resistor ΜΜΕ 10Ω IF ΠΩ WIN Select one: a ΜΑΜ 15 Q2 SP Μ…

A: Given,

Q: a) Design 5th-order low-pass FIR filter with cut-off frequency we using the rectangular window. b)…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: An ammeter has a f.s.d. of 100 mA and a resistance of 50 2. The ammeter is used to meas- ure the…

A:

Q: 16. Two loads with different power factor are connected with the source through a transmission line…

A: The question is about source current and source voltage. It is ac circuit so source current is…

Q: 955. Given a zero-centered delta function of area 36 volt-seconds. Evaluate the Fourier transform at…

A:

Q: 8. `Given the following transfer function for H(s) where it is under damped, for a unit step input…

A:

Q: Calculate the current through 30 Resistor 8A O a. -6A b. 6A O c. 2A O d. 8A 192 352

A: Given circuit,

Q: Example: Sketch the single-sided and double-sided spectra of x(t) = 3 + 4 cos(20nt +30) + 2…

A: Fourier Transform convert time domain signal in to frequency domain. Spectra of function have…

Q: A four-pole, 50Hz induction motor has a full- load slip of 5 percent. The rotor speed of this motor…

A: Given data, Number of poles P =4 Frequency f = 50 Hz Slip s=5 % =0.05

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.