A 35 kg flow monitoring device is placed on a table in a laboratory. A pad of stiffness 2 x 105 N/m and damping ratio 0.08 is placed between the apparatus and the table. The table is bolted on the laboratory floor. Measurements indicate that the floor has a steady state vibration amplitude of 0.5 mm at a frequency of 30HZ. What is the amplitude of acceleration of the flow monitoring device? Select one: O 13.65 m/s? O 2 m/s? O 3 m/s? O 3.65 m/s?

A 35 kg flow monitoring device is placed on a table in a laboratory. A pad of stiffness 2 x 105 N/m and damping ratio 0.08 is placed between the apparatus and the table. The table is bolted on the laboratory floor. Measurements indicate that the floor has a steady state vibration amplitude of 0.5 mm at a frequency of 30HZ. What is the amplitude of acceleration of the flow monitoring device? Select one: O 13.65 m/s? O 2 m/s? O 3 m/s? O 3.65 m/s?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

How does a strain gauge work?
Note: Please do not handwritten.
TRUE OR FALSE. concurrent engineering is used to compare material, design, fabrication, and quality to different kinds of product and parts.
basic technique of operating a scrap machine
In your own words what is safety?
What are crumple zones in cars designed for? O absorbing the shock from bumpy roads changing the direction of the car during impact increasing the time it takes for a car to stop during a crash allowing the car to be scrapped and recycled easily
The following methods are used to distinguish between ferrous and nonferrous metals and alloys (Choose all that apply) Magnetic test Density test Chemical test Scratching Visual observation Heat treatment
What two things can happen when a flex item drops below its basis size?
Which one of these may increase the amount of contact resistance? Lower temperature during matching of materials decreasing pressure for pressing the materials together Higher surface roughness All of the above Using air as a fluid for the gap instead of liquids