A 300 mm x 150 mm venturimeter is provided in a vertical pipeline carrying oil of specific gravity 0.9, flowing upward. The difference in elevation of the throat section and entrance section of the venturimeter is 300 mm. The differential U – tube manometer shows a gauge deflection of 250 mm. Calculate i) The discharge of oil ii) The pressure difference between entrance and Throat section. Take : coefficient of discharge of venturimeter is 0.98

A horizontal venturimeter with inlet and throat diameter of 160 mm and 60 mm respectivelyis used measure the flow of an oil of specific gravity 0.8. if the discharge of oil is 0.05 m3/s, find the deflection of oil mercury differential manometer. Take venturimeter constant=1.

Hi, I unfortunately cant see the full explanation, is there any way the writing could be condensed to show all of it on the screen?

1. A pressure gauge attached to a pipe is reading 1.34 m of Hg at a place where the atmospheric pressure is 10.33 m of water. The approximate absolute pressure at the mountain isa. 930 kPab. 181 kPac. 280 kPad. 100 kPa   2. The flow is said to be unsteady and non-uniform when,a. The flow velocity is not changing with time but changing with spaceb. The flow velocity is changing with both time and spacec. The flow velocity is changing with time but not changing with spaced. The flow velocity is not changing with both time and space   3. The below figure shows a pipe with a circular cross section of diameter D mm on the left end and a square cross section with side D mm on the right end. Mercury enters the left end with a velocity 1 cm/s and leaves the right end with a velocity V2. Find V2 (neglect losses in the pipe).a. Cannot be find since length is not givenb. Cannot be find since diameter is not givenc. 7.85 mm/sd. 12.73 mm/s   4. 1 kg water is flowing through an inclined pipe at…