A 30 cm diameter well completely 15 points penetrates a confined aquifer of permeability of 45 m/day. The thickness of the aquifer is 20 m. Under steady state of pumping the drawdown at the well found to be 3.0 m and the radius of influence was 300 m. Calculate the discharge of the well * Pumping well dia = 2r Original piezometríc surface Aquiclude Piezometric surface under pumping Flow Confined aquifer Aquiclude Well Operating in a Confined Aquifer 1.548 m^3/min 0.0258 m^3/min 0.258 m^3/min 0.0851 m^3/min

A 30 cm diameter well completely 15 points penetrates a confined aquifer of permeability of 45 m/day. The thickness of the aquifer is 20 m. Under steady state of pumping the drawdown at the well found to be 3.0 m and the radius of influence was 300 m. Calculate the discharge of the well * Pumping well dia = 2r Original piezometríc surface Aquiclude Piezometric surface under pumping Flow Confined aquifer Aquiclude Well Operating in a Confined Aquifer 1.548 m^3/min 0.0258 m^3/min 0.258 m^3/min 0.0851 m^3/min

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Pumping with a radius of 25 cm opened in an aquifer with an average thickness of 33 m with a free surfaceWhen the flow rate of 39.57416734 lt/sec is withdrawn from the well for a very long time, one of the pumping wells is 43 m and the otherThe water levels in the observation wells at a distance of 183 m are 30.66859298 m and 32.2787432 m, respectively.determined. The hydraulic conductivity of the aquifer (m/s) according to the data given in the Question 4 data sheet,the pumping well descent (m), optimum level descent (m) and optimum flow (lt/s)calculate.
Give me right solution according to the question. Urgent please A 20-cm diameter well completely penetrates a confined aquifer of permeability 0.088 cm/sec. The length of the aquifer is 34 m. When pumping was kept constant at 78 L/sec, the drawdown at an observation well, 112 meters from the pumping well, was found to be 0.79 meters. Determine the drawdown at the face of the pumping well (in meters).
With an observation well situated is 69.7 ft away from the pumping well (which is pumping at the rate of 305 gal/min). The aquifer is confined, and the depth has been measured from well logs and is 150 ft. t (min) s (ft) 0.072 0.003 0.105 0.006 0.155 0.012 0.222 0.02 0.322 0.026 0.472 0.03 0.688 0.034 1.005 0.037 1.472 0.041 2.238 0.047 3.238 0.052 4.738 0.062 6.738 0.072 10.072 0.087 15.905 0.107 21.905 0.116 31.905 0.129 46.905 0.149 67.905 0.171 100.91 0.203 150.91 0.239 220.91 0.276 351.9 0.33 500.9 0.36 687.9 0.39 1001.9 0.43 1481.9 0.46 2202.9 0.49 3103.9 0.51 4336.9 0.54 Could someone please show using this data how to calculate transmissivity (T), the hydraulic conductivity (K) and Storativity (S) for the aquifer. Thank You
Pleaseeeeeeee urgenttttttttt Question: what effect on the pumping well drawdown does the lake have when using Theim equation? (Superposition of Theim equation)
Design a well ( find the diameter and drawdown of well ) witch is penetrating in un confined aquifer with depth 12 m to discharge the water at rate 3 cumcs from a land , the hydraulic conductivity is 10 m/day , the storag coefficent of medium sand soil is 20 , the drawdown of testing well awy 510 m is 1 m ? Then explain your design . i need solutions in 30 minutes please
A 2 ft diameter well penetrates vertically through a confined aquifer 50 ft thick. Whenthe well is pumped at 500 gpm in 1 day, the drawdown in a well 50 ft away is 10 ft andin another well 100 ft away is 3 ft. The storativity of aquifer is 0.0005. What is the valuefor transmissivity and drawdown? Note; the piezometric head is 100ft from datum.Combination of thiem & thies equation
Design the pipe that will connect two reservoirs for a water distribution system of a certain sitio. It was found out that the water source can sustain the water demand of the place for the next 25 years. Data: Elev. Of Reservoir A = 1050 m Elev. Of Reservoir B = 1000 m Total length of pipe (corrugated G.I.) = 2.5 km Current Population = 150 Design Period = 25 years Annual Population Growth Rate = 2.5% Per Capita Water Consumption (PCWC) = 100 liters/person-day You may use any method that is most suitable for the problem. (PLEASE INCLUDE COMPLETE SOLUTION AND DRAWING)
) A pumping test carried out in a 50 m thick confined aquifer resulted in a flow rate of 600l/min. The thickness of the impermeable layer above the aquifer is 20 m and the originalwater level in the well was 2 mm below the ground surface (which is also the top of theimpermeable layer). Drawdowns in two observation wells located 50 m and 100 m fromthe well are 3 and 1 m respectively. Calculate:i) The coefficient of permeability of the aquifer, ii) The drawdown in the well, iii) The radius of influence. The diameter of the well is 0.6 m.
TELEGRAM Q2: A well is located in a 25 m confined aquifer of permeability 30 m/day and storage coefficient 0.005. If the well is being pumped at the rate of 1750 lpm, calculate the drawdown at a distance of (a) 100 m and (b) 50 m from the well after 20 hours of pumping.
ENVIRONMENTAL ENGINEERING ( Practice Questions) a). Suppose a well 0.36m in diameter has been pumped at a rate of 3,000cu.m/day for a long enough time that steady-state conditions apply. An observation well located 30m from the pumped well has been drawn down by 1.0m, and another well at 120m is drawn down by 0.4m. The pumped well extends completely through an unconfined aquifer 60.0m thick. GIVEN: For an unconconfined aquifer, Q = πK(h2c1 – h2c2) / [Ln(r1 / r2)] Determine the hydraulic conductivity, K. (7 marks) (ii) Estimate the drawdown at the pumped well. State any assumptions made. b). A confined aquifer 40.0 m thick has two monitoring wells spaced 400m apart along the direction of groundwater flow. The difference in water level in the wells is 4.0m (the difference in piezometric head). The hydraulic conductivity is 40m/day. Estimate the rate of flow per meter of distance perpendicular to the flow. C). Suppose the aquifer, which has a…
Hydrology Question Can you show me how to calculate specific storage S=Ssb. well is 0.3 m in diameter and is fully screened for the entire 12 m depth of the aquifer, which is composed of coarse sand having a bulk density of 2 g/cm3, K of 0.1 cm/sec, porosity of 0.25 and organic content of 0.5%.+ radius of influence of this well can be taken as 3,000 m. What is the steady state drawdown of the well, if the average water use by the factory is 360 L/min. b = 12m S = 360L/m do I have this correct? Ss =
A well that is screened in a confined aquifer is to be pumped at a rate of 165,000 ft3/d for 30d. If the aquifer transmissivity is 5320 ft2/day, and the storativity is 0.0007, what is the drawdown at distances of 50, 150, 250, 500, 1000, 3000, 5000, 10000 ft?