A 2m^2 wall of 1010steel is 8 mm thick. If the outside of the wall is100 °C, andyou measure aheat flux of 80 kW/m2coming off the wall, what is the temperature of the insideof thewall? Properties at 20°CCpkMetal(kg/m³) (J/kg-K) (W/m-K) (10-5 m² /s)Pure Copper8,95419,32038439811.57Gold12931812.76Steels (C < 1.5%)||AISI 1010†+7,830434641.88

Answered: Image /qna-images/answer/84f9a804-4826-4101-9cee-701b3f85df46.jpg

Answered: A 2m^2 wall of 1010steel is 8 mm thick.…

A 2m^2 wall of 1010steel is 8 mm thick. If the outside of the wall is100 °C, andyou measure aheat flux of 80 kW/m2coming off the wall, what is the temperature of the insideof thewall?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: An electrical wire 2 m long and 0.3 cm in diameter extends through a room at 15 °C, as shown in the…

Q: A modern cabin has a concrete floor that is 4.50 inches thick. A roaring fire keeps the interior of…

Q: 500 GIMPa. The ルプ now coulo down the entropy

A: from steam tableat 1000 kpa & 500°cv1=0.35411 m3/kg h1=3479.1 kj/kgs1=7.7642 kj/kgk

Q: A family enters a winter vacation cabin has been unheated for such a long time the interior…

A: Given Data: Heater rating, P=2 kW

Q: Q2) A plate having a thickness of 4.0 mm has an internal heat generation of 100MW/m³ and a thermal…

Q: there any relation between heat capacity at constant pressure and heat capacity at constant volume ?…

A: For solution refer below images.

Q: When the system is completely isolated from its surroundings so that there is no heat transfer, this…

A: Open thermodynamic system is a system in which both energy and mass can cross the boundary of the…

Q: The heat transfer through a wall 25’x10’ is 8750 Btu/ hr. The outdoor air and surface temperature =…

A: Given Data→ Dimensions of wall 25'×10' Heat Transfer through a wall Q=8750 Btuhr Outdoor air and…

Q: any years will it be five times as much ? Assume at the tate of increase is proportional to the…

Q: If the Lacrange equation for a given system is as follows:. What are the equations of motion for…

A: Option A is correct.

Q: Q2) A stainless steel plate with k =20 W/m C generates heat uniformly. The plate is 1.0 cm thick,…

Q: smi-infinite cylinder in a steady state with the environment of radius 3-units. If the surrounding…

A: Heat transfer is a thermal engineering field that concerns thermal energy (including heat) across…

Q: The bottom of a 50mm diameter, 2mm thick metallic induction heater is 120C while its thermal…

A: Given Diameter, d = 50 mm Thermal conductivity, k = 60 W/mK…

Q: Convection heat transfer from a plate (2 m x 2 m) is 450 W. If surface temperature of plate is 450 K…

A: Given, Area of plate = A = 2 m x 2 m = 4 m2 Heat transferred = Q = 450 W Surface temperature = Ts =…

Q: 3. In your understanding, how does torsion happen?

A: Torsion: It is the twisting of any member under the action of a torque. Torque or twisting couple:…

Q: The ratio of heat flow Q/Q2 from two walls of having same thickness their thermal conductivities as…

Q: A family enters a winter vacation cabin has been unheated for such a long time the interior…

A: Given data: Ti=0°CTf=24°CP=2 kW Need to determine the time taken to reach the temperature of the…

Q: A 4-inch insulated arctic pipe is used for a construction camp. The lake source is 1500 meters away.…

Q: A house, for cooling purposes, consists of two zones: the attic area zone A and the living area zone…

A: Solution: Given Data: K1 = 1/4 K2 = 1/8

Q: Convection heat transfer through the plate is 180 w/m?k. Find convection heat transfer coefficient…

Q: An フち 2/0P, and compresses if to 1400 nPa o of 889 and it luser energy by heat é of the irentrapic…

Q: Let us consider an ultralight airplane (mass 350 kg), which is standing on the runway of an airport.…

A: Mass of airplane 350 kg Energy provided to engine = 20000 KJ Heat energy loss = 5000 KJ At a height…

Q: P3. After a particularly cold night, Alice leaves a tub of water outside. You may consider the…

A: Given: Ground temperature Tc=-10°CAir temperature (Th)=10°CInitial thickness of water (h0)=10cm or…

Q: 15°C to 40°C and it is free to expand. The bar wil A steel bar of 5m induce :

A: Given data : Length (L)=5 mmCoefficient of thermal expansion (α)=1.2×10-5Initial temperature…

Q: Q: A large plane wall of thickness (L= 0.3 m), thermal conductivity ( k = 40 W/m-°C), and surface…

A: Given, L = 0.3 mk = 40 W/m °CA = 0.4 m2T(0) = 70 °Cq' = 1200kk + 20L=1200 (40)40 + 20 (0.3)=1043.48…

Q: -A per fectly sealed room metors height 10 meters wide, 12 meter? long and 3 Is composed of 49…

A: Calculate the total volume of the room. Here, w, l, and h stand for the width, length, and height…

Q: Q6 a) A 10-cm dia. copper ball is to be heated from 100 *C to till average temperature of 150 °C in…

A: Part A) Now find the total heat transfer as follows.

Q: Air surrounding a light bulb is moving at 25 m/sec. The surrounding conditions are kept at…

A: For forced convective heat transfer across a sphere we use the Whittaker correlation Nu¯=h¯Dk=2+ 0.4…

Q: A wall thickness is 0.05. If the temperature of the inner surface is 40°C and the outer surface is…

Q: Since the correlation given in the textbook is so complicated, Dr. Roy wants to come up with a new…

Q: A 20-çm diameter sphere has a surface temperature of 500 K. The sphere is suspended in 300 K still…

A: Given data as per question Diameter of the sphere =20 cm =0.2 m The surface temperature of sphere…

Q: the expression for temperature distribution in the plate

A: Given; Uniform heat=80MWm3 having a thickness=20mm=0.2 mTleft=1600 CTright=1200 CK=200 W m-1k-1

Q: A plate having a thickness of 4.0 mm has an internal heat generation of 100MW/m and a thermal…

Q: The measure used in a weight-measurement unit in the world is expressed by Q=kadT/dr. Here, A is the…

Q: Heat is being generated within a 6 m long stainless steel cylinder with the amount of 2kW. The…

A: Radius was not given so 1 mm is assumed (0.1 cm radius = 0.2 cm diameter) formula for surface…

Q: 3. The roof of a house consists of a 15-cm-thick slab (k = 2 W/m - °C) that is 15 m wide and 20 m…

Q: The measure used in a weight-measurement unit in the world is expressed and k is the heat. A steam…

A: we are to determine the net heat transferred and and the temperature profile in the radial direction…

Q: What is the heat loss through the windows of a passenger train left outside a station in winter,…

Q: Hi, can you help me with the following problem? A thermally insulated tank of water 2 m x 2 m, depth…

A: Step 1: Step 2: Step 3: Step 4:

Q: An air-cooled condenser has an expected U value of 30 W/m2-K based on the airside. The condenser is…

Q: Answer for heat transfer is not correct. Please provide another answer

Question

A 2m^2 wall of 1010steel is 8 mm thick. If the outside of the wall is100 °C, andyou measure aheat flux of 80 kW/m2coming off the wall, what is the temperature of the insideof thewall?

Properties at 20°C
Cp
k
Metal
(kg/m³) (J/kg-K) (W/m-K) (10-5 m² /s)
Pure Copper
8,954
19,320
384
398
11.57
Gold
129
318
12.76
Steels (C < 1.5%)||
AISI 1010†+
7,830
434
64
1.88

Expert Solution

Step 1

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Calculate the specific heat capacity of 10 000 kg of sea water if the rise in temperature is 0.00255 ℃ and heat supplied is 100 000 J
i need the answer quickly
Pls answer asap
Temperature differences for Thermal efficiencies do not have to be converted to absolute temperature. true or false?
give two example and explanation of thermal energy transformation at constant volume, pressure and heat that happen in daily
Unit of thermal conductivity in S.I. units is (a) J/m2 sec (b) J/m °K sec (c) W/m °K (d) (a) and (c) above (e) (b) and (c) above.
Pls answer q3(as I am still not sure whether or not I did q2 correctly)
Heat is lost through the glass pane of a window. The thickness of the glass is 3 mm, and the window is 0.9 m by 1.8 m. The thermal conductivity of glass is 0.8 W/mK. If the temperature difference across the glass is 17 K, what is the total heat transfer through the pane of glass? Give your answer in Watts to the nearest integer.
3. The bottom of a 50mm diameter, 2mm thick metallic induction heater is 120C while its thermal conductivity is 60 W/m-C. The voltage and current flowing into the heater are 220V and 5A, respectively. Find the temperature at the top portion of the pan.
The wall of a furnace comprises three layers as shown in the figuie. The first layer is tery (whose maximum allowable temperature is 1400°C) while the second laver is Tracto:y Chose maximum allowable temperature is 1093°C). The third layer is a plate of 6 35 od thermal contact. Steet plare To 6.35x3 45A 1370 C Concerntiation veluciy 37.8 C mass Siynes Figure. Layers in a composite furnace wall. e temperature To on the inside of the refractory is 1370°C, while the temperature T; on the side of the steel plate is 37.8° The heat loss through the furnace HnIlisexpectet tobe
As the temperature increases, the thermal conductivity of a gas... (A) increases (B) decreases (C) remains constant (D) increases up to a certain temperature and then decrease
Q1) A polished metal pipe (8 cm) owtside diameter and 350 K temperature at the outer surface is exposed to ambient conditions at 285 K temperature. The emissivity of the surface is 0.3 and the convection coefficient of heat transfer is 13.5 Wim2-deg. What would be the overall coefficient of heat transfer by the combined mode of convection and radiation” Q2 find the pressure point (1) if the amospheric pressure is(70kpajihl =0 2,h2=0.4,h3=0. ‘)(p. =13600kg/m3. poil=850kg/m3)