A 20m x 20m grid is set out over a T shaped section. Levels are taken on teh grid, and RLscalculated, as below:425.2424.7424.7423.4425.3423.8424.4425.1424.3424.7424.2423.8If the area is then to be excavated to RL 421.0m, calculate the volume of cut using the gridlevelling formula.Volume of cut:

To find the total volume of excavation using the grid levelling method.

A 20m x 20m grid is set out over a T shaped section. Levels are taken on teh grid, and RLs calculated, as below: 425.2 424.7 424.7 423.4 425.3 423.8 424.4 425.1 AIE WAG MO ALA 424.3 424.7 424.2 423.8 If the area is then to be excavated to RL 421.0m, calculate the volume of cut using the grid levelling formula. Volume of cut:

A 20m x 20m grid is set out over a T shaped section. Levels are taken on teh grid, and RLs calculated, as below: 425.2 424.7 424.7 423.4 425.3 423.8 424.4 425.1 AIE WAG MO ALA 424.3 424.7 424.2 423.8 If the area is then to be excavated to RL 421.0m, calculate the volume of cut using the grid levelling formula. Volume of cut:

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

I need the answer as soon as possible
The earthworks data of a proposed highway shown on the tabulated data. Length of economic haul = 450 m Stationing of limits of economic haul = 2+498.03 and 2+948.03 Stationing of limits of free haul 2+713.12 and 2+763.12 Free haul distance is 50 m. Assume the ground surface to be uniformly sloping. Area Station Cut Fill 2+440 50 m2 2+740 0. Balancing Point 70 m2 3+040 a) Compute the overhaul volume. b) Compute the volume of waste. c) Compute the volume of borrow.
22.) Line MN, 251m long, was paced five times by the surveyor and recorded as follows: Trial No. Distance 1 121 2 122 3 120 4 124 5 122 Another line OP was paced four times again with the following results: Trial No. Distance 1 122 2 314 3 311 4 322 Determine the actual length of line OP.
The cross-section notes shown below are for a ground excavation for an 8-m wide roadway. Station 32+300 6.25 4.75 + 2.25 + 2.20 + 0.75 Station 32+420 7.20 5.25 + 3.20 + 0.75 + 1.25 m2 i. Find the area of the cross section at Station 32+300. m< ii. Find the area of the cross section at Station 32+420. m ii. Find the volume of excavation.
The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 19+2600 8.09 5 0 5 8.25 6.54 5 4 6 6.7 Determine the cross sectional area at STA 19+2600. Round your answer to 3 decimal places.
ROUTE Surveying
Q3: Figure (3) represent the plan of an area to be excavated, which have been leveled in the form of a square and triangle grid the surface levels are shown beside each point, the grid squares are 20 m on a side, and the required formation level is 20.00 m above datum .Compute the amount of excavation in cubic meters. 28.11 28.24 27-58 2769 27-32 20.00 2763 20.00 Figure (3) 20.00 87.76
Q2). Calculate volume of cut and fill, the elevation of natural ground shown on all nodes and design elevation is equal to 103 m, all dimension and elevations are in meter. hi h, 101 102.5 W₂ 104.2 ha 108.10 98.45 412 100.5 Wy -10 m 102.5 hey 105.7 12 97.35 99.80 101, hs 104 hi 10 m ha 104 106.5 hi Thi
Please correct answer
h₂ Q2). Calculate volume of cut and fill, the elevation of natural ground shown on all nodes and design elevation is equal to 103 m, all dimension and elevations are in meter. 101 102.5 W₂ 104.2 12 108.10 98.45 412 100.5 hy -10 m 102.5 he 105.7 h2 97.35 99.80 101, 104 hi 10 m h2 104 106.5 hi Thi
Q.1) A building (30 m x 20 m) in dimensions is to be built on a hilly terrain with foundation elevation (30 m), the areas bounded by contours were measured from a map (scale 1:500) and found to be: svode sb to snor (b) Contour elevation (m) 35 34 33 32 31 30 29 28 Area bounded cm² 6.2 7.4 9.6 10.8 13.2 15.4 17.6 19.4
The end areas along a proposed drainage ditch are shown below. Find the total volume of excavation between stations 16+220 and 17+820