A 2.3kV, 3 phase Y-connected synchronous motor has a synchronous impedance of 0.1+j2 ohms per phase. The motor operates at 0.866 pf lagging while taking 350A from a 2.3kV, 3 phase source. Find the a) load angle in degrees under the above conditions and the b) excitation voltage per phase.

A 2.3kV, 3 phase Y-connected synchronous motor has a synchronous impedance of 0.1+j2 ohms per phase. The motor operates at 0.866 pf lagging while taking 350A from a 2.3kV, 3 phase source. Find the a) load angle in degrees under the above conditions and the b) excitation voltage per phase.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter39: Synchronous Motor Operation

Section: Chapter Questions

Problem 14SQ: Induction motors and welding transformers require magnetizing current, which causes a. lagging power...

See similar textbooks

Related questions

Q: Deber mine ID, Ves, VRS, VRD, Vos Vos + Vth = 2V Kn = 4mA)V? Rs Rp LOV 10v

A: We need to find out current and voltage for given circuit

Q: An engineer connects a resistor in parallel with an electric motor (a schematic of the circuit is…

A: The purpose of the resistor to limit the voltage across the armature coil only gets fulfilled when…

Q: Create a circuit that will display the sum of two 4-bit binary inputs in 7-segment display. Display…

A: The seven segment display is a component made up of 7 different LED's setup in a unique…

Q: 1. Find Vx using a. Maxwell b. Nodal Analysis

A: The required parameters can be calculated by using kirchhoff's voltage law and current law.

Q: three-phase, five-pole alternating current generator that runs at a speed of 1440rpm has a total…

Q: homework multista Homework: Consider the circuit shown in Figure below with transistor parameters B…

A: The required parameters can be calculated by using DC and AC analysis of the cascaded amplifier.

Q: 7. What system characteristics are being considered in the final form of the design that must…

A: While designing of any equipment few standard parameters needs to be taken care such as Flexibility…

Q: Question 2 5Ω 2F 12 3F Figure 2.1 Consider the system shown in figure 2.1 (a) (b) (c) (d) (e) Obtain…

Q: he amplitude plot rises as the frequency increases from 100 Hz until he is reached O input frequency…

Q: Design a BJT differential amplifier to amplify a differential input signal of 0.25 V and provide a…

A: The differential amplifier is used to amplify the input signal with a gain of more than 10. This aim…

Q: 1. Give the transfer function of the following diagram, both in impedance and RC form: R e, CT 2

Q: Cite the similarities of common-emitter, common-base and common-collector configurations

A: The circuit of common-emitter is given as- The circuit of common-base is given as- The circuit of…

Q: 2. Choose the values of Rp. Rs, and R for the JFET amplifier circuit of Fig. 3-11 that will result…

A: JFET: It is a semiconductor device, used as a transistor. It has three terminals and only one…

Q: A UJT employed for the triggering of an SCR, stand-off ratio = 0.61 and DC source voltage and VBB is…

Q: (b) Supposc that there are twa alternative electric motor that provide 100 HP output: 10 Beta Motor…

A: Consider the given Question, in it we have do the calculations based on the given data.

Q: )In the circuit of Fig.2, Z,=60 /-30° Q, and Z,=40 /45°. Calculate the total; a) apparent power,…

Q: 3. Find Vy using Nodal Analysis. 30 V 6 A 4 10 요 +. 10 V + Vy -

Q: If 20 µF, 30 µF, 15 µF and 150 µF capacitors are connected in parallel, then what is the total…

Q: 1. Find Vx using a. Maxwell b. Nodal Analysis

A: The Maxwell is nothing but the kirchhoff's voltage law and it can be used to find mesh current…

Q: Consider a straight conductor of length 7.7 cm. The conductor moves at right angles to a magnetic…

A: We need to find velocity

Q: A series RLC circuit is connected to a 25 V source of variable frequency. The circuit current is…

A: Given, that a series RLC circuit having, Supply voltage, Vs = 25 V Maximum current, Imax = 0.5 A For…

Q: 17. A circuit has an apparent power of 400OVA and a reactive power of 250VAR. Find the power factor…

A: power factor = active power Papparent power Sbut apparent power S = 400 VAreactive power Q = 250…

Q: 1-4 (a) Draw a connecting diagram for the electric power system in your area including major power…

A: Transmission line- The transmission lines are used to transmit high voltage power from one point to…

Q: apacito ngure shorts to ground, the voltage at the cathode of the PUT +18 V 470 ll AO OK 10LD 22.4…

A: On seeing the circuit of the PUT the cathode is connected to the capacitor on shorting the capacitor…

Q: Design a clipper circuit that clips any portion of the input AC waveform below 4 volts: 6 Vass

A: Given: Clipper circuit that clips any voltage below 4V.

Q: (d) Find the Thevenin equivalent of the circuit shown in figure 5, that is, evaluate the voltage…

A: In this question, We need to determine the Thevenin equivalent across the terminal.

Q: Express the value of H in rectangular components at P(2, 0, 0) in the field of: a. A current…

A: aH⇀=I2πρ aϕ→ρ=1-22+3-02+0-02=10 =3.1622H⇀=42π×3.1622 aϕ→=0.2013 aϕ→ the field is in aϕ→…

Q: Evaluate the minimised Boolean expressions required to implement the following 0-6 reset counter…

A: The counter can be designed with the help of three flip flops and the expression can be obtained by…

Q: 1. Solve for the loop currents 1,12 & 13. (a) what are the loop current equations. (b) use Cramer's…

A: Please refer the attached images for the complete answer..

Q: Compute for Zo. Vcc = 12V. %3D oVcc 4.7 k2 1 ΜΩ B= 90 To=002 O 1 Mohms 4.7 kohms infinite 2.8 kohms

Q: the correct response vill be zero ncrease decrease not change

A: Potentiometer is used to control the gate current magnitude so that appropriate amount of current…

Q: 5. Find the Thevenin's Equivalent Circuit 20 10 Q 2i,

Q: What is the difference between a digital and an analog system? Give appropriate examples.

Q: H.W. A three-phase wye-connected load is supplied by an abc-sequence balanced three- phase…

Q: i) Prove the following Boolean theorems algebraically: (a) X(X+Y)=XY (c) XY+XY' X (b) X+ XY= X (d)…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: EX. For Ene folloWin) stind S Source Carreht) Ide and i2, assume no initial Current ahA Charg e ish…

Q: 1) Determine the DOT PRODUCT of the two vectors shown in the figure whose magnitudes are 40ON and…

A: Diagram is given as, Forces are given as, F1=400 N, F2=820 N

Q: Find the equivalent capacitance of the collection below. SuF 14uF HH 3uF 3µF

A: Given circuit:

Q: 4. At motor start-up, the current will spike as the motor begins to turn. This spike is know as?…

A: Synchronous speed is the speed at which synchronous machine works and it depends on frequency and…

Q: The EMF and resistor voltage in a series RLC circuit are shown as functions

Q: Ex.2: Design a synchronous counter MOD-6, which follows the count sequence 000, 010, 011, 001, 100,…

Q: 6. A single-phase, 225-kVA, 460/120-V transformer has 6% impedance and 96% efficiency. Find its…

A: In this question we need to find series R and X of the given transformer

Q: · An 800-turn is the wound on the central limb of the cast-steel frame shown in Fig.4. Determine the…

Q: esign a simple matching network of your choice to match a 73 ohm load to a 50 ohm transmission line…

A: A Lumped element model is used to describe the behavior model of a circuit, lumped elements that can…

Q: 25. For the network of Fig. 170, sketch v, and determine Vde- 2 k V, = 120 V (ms) Ideal FIG. 170…

A: We need to find out output for given circuit

Q: For main weinding, Vm = 23 V Im P = 60 w Vm Im (os m =60 60 23x4 (os fm = (os Øm = 0.652 Øm = 49.29"

Q: 4. Find I, and R, for the circuit below

Q: Sketch or graph and then find the Fourier series for the given function f(x). Show the details of…

Q: D3. The current-voltage measurement of a photovoltaic device a. gives information about the…

A: The current voltage measurement characteristics of are very much helpful is knowing about the…

Q: In infinite line, the uniform line charge density is 10 uC/m.what is the electric field for line if…

A: Given, Infinite line charge of Uniform line charge density, λ=10 μC/m Radius, r=8 m

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

A 2.3kV, 3 phase Y-connected synchronous motor has a synchronous impedance of 0.1+j2 ohms per phase. The motor operates at 0.866 pf lagging while taking 350A from a 2.3kV, 3 phase source. Find the a) load angle in degrees under the above conditions and the b) excitation voltage per phase.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 50 Hz, 3-phase induction motor is working at a full load speed of 1440 r.p.m. The full load slip will be a. 0.12 b. 0.06 c. 0.08 d. 0.04
8. The synchronous speed of a 3-phase induc- tion motor having 20 poles and connected to a 50 Hz source is ........ (i) 600 r.p.m. (iii) 1200 r.p.m. (ii) 1000 r.p.m. (iv) 300 r.p.m.
4. An induction motor draws 4.5 A at a 0.75 lagging power factor from a 208V, 60 Hz source. a) What value of capacitance must be connected in parallel with the motor to raise the overall p.f. to 1. b) Calculate the magnitudes of the motor current, capacitor current and source current with the capacitor in place. 5. A 3-phase Y-connected motor is connected to a three phase Y-conected source with 440V line voltage. It draws a line current of 5A from the source. If the power factor of the motor is 0.8, calculate a) Active power and Reactive power absorbed by the load b) Total Apparent power
Permanent-split capacitor motor is in effect a 2-phase motor and at no load could attain the synchronous speed. True False
In 3 phase induction motor the greater number of poles give.. * speed high O Medium Low
A generating voltmeter is required to measure voltage between 15kV and 250kV. If the indicating meter reads a minimum current of 2uA and maximum of 35uA. Assume that the speed of driving synchronous motor is 1500rpm. Determine the capacitance of the generating voltmeter. A. 1,2 pF B. 6.5 pF C. 15,2pF D. 1 pF
A 3 phase AC induction motor is operating at no load. What is the power factor? Group of answer choices A) leading B) lagging C) neither leading nor lagging
In three-phase induction motor rotor speed is zero at the time of starting the induction motor. Select one: True False
The synchronous speed of a 3-phase induc- tion motor having 20 poles and connected to a 50 Hz source is .......
A 50 Hz, 3-phase induction motor is working at a full load speed of 1440 r.p.m. The number of poles in the motor is а. 4 b. 8 d. 12 C.
• - 1800 pm In a two pole 3-p synchronous generator, the peak flux of rotor magnetic field is o5Tand the rotor rate of rotation is 1800 rpm. The stator windings have a surface area of 0.1 m? and there are 50 turns per Bmax : 0.5T, 0.5T coil. The machine is A-connected. A: 0-1 m? N: 50 a) What is the RMS phase and line voltage of the generator? b) Write the three stator phase voltages as functions of time.
A 50 Hz, 3-phase induction motor is working at a full load speed of 1440 r.p.m. The full load slip will be