A 120 V shunt generator running at 850 rpm has its armature and shunt field resistance of 0.15 ohm and 50 ohm respectively. It supplies 200 lamps each rated at 60 W, 100 V. The friction and windage and core loss of the machine is 400 W. its armature copper * loss on full load and shunt field loss is 2156.7 W, 240 W O 2232.6 W, 240 W O 2232.6 W, 200 W O 2156.7 W, 200 W O

A short shunt compound generator delivers 150A at a terminal voltage is 230V. The shunt field current is 2.5A. The resistances of the armature, series field and diverter are 0.032-ohm, 0.015 ohm and 0.03 ohm, respectively. Calculate the electrical efficiency of the generator at this load.

An Armature runs at 250 r.p.m. and generates an e.m.f. at 50 Hz. There are 216 slots each containing 5 conductors. The winding is distributed and full pitch. All the conductors of each phase are in series and flux per pole is 30 mWb which is sinusoidal distributed.Calculate the number of pole.

and t A common base of 100 MVA and 25 KV is selected. What is the current base (Ig) Select one: O a. 4 KA O b. None of these O c. 6.25 kA O d. 2.309 KA A 100-MVA, 60-kV, three-phase synchronous generator has a synchronous reactance of armature resistance. The generator is operating with an excitation per phase E= 47.116 power before losing synchronism (stability limit). and the armature c Thus, the maximum generated power is Pmax =

A 6-pole ,3 phase , 60 cycle alternator has 12 slots per pole and four conductor per slot. The winding is 5/6 pitch. There are 2,500,000 Maxwell ( 0.025 weber ) entering the armature from each north pole, and this flux sinusoidally distributed along the air gap. The armature coils are all connected in series , The winding is wye connected. Determine the open circuit emf of the alternator.

A single phase, 2000 V alternator has armature resistance and reactance of 0.8 ohms and 4.94 ohms respectively. The voltage regulation of the alternator at 100 A load at 0.8 leading power factor is ??

Why is it necessary to conduct polarity tests on transformers?

A 4 pole dc generator with duplex wave winding has 48 slots and four elements per slot. The flux perpole is 2.5 x 10 Maxwells and the speed of the prime mover is 30 rpm. What is the average generatedarmature voltage? Neglecting brush drop.

A 4 pole dc shunt generator with a shunt field resistance of 100 ohm and an armature resistance of 1 ohm has 378 wave connected conductor in its armature. the flux per pole is 0.02wb, if the load resistance of 10 ohm is connexted across the aemature terminal and the generator driven at 1000rpm, calculate the power obsorbed by load

In a certain sub-station, there are 5 d.c. shunt generators in parallel, ench having an armature resistance of 0.1 0, running at the same speed and excited to give equal inducnd emfs Each generator supplies an equal share of a total load of 250 kW at a terminal voltage of 500 V into a load of fixed resistance. If the field current of one generator is raised by 4%, the others remaining unchanged, calculate the power output of each machine and their terminal voltages under these conditions Assume that the speeds remain constant and flux is proportional to field current