Answered: A 100-μF capacitor has a voltage given…

A 100-μF capacitor has a voltage given by v( t )=10−10 exp( −2t ) V. Find the power at t=0 and state whether the power flow is into or out of the capacitor. Repeat for t 2 =0.5 s.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Define inductance and capacitance and describe on what physical parameters they depend. Determine…

A: 1) To define inductance and capacitance And determine the energy stored in the capacitor and…

Q: 1. The capacitor in the figure is charged with vc (0) = 10 V. Find the mathematical expressions for…

A: Here we discuss about the procedure of the transient analysis of RC circuit.

Q: An air filled capacitor of Co-2.0 µF is fully charged with Qo-51.0 µC using an electromotive force…

A: It is given in the question that an air-filled capacitor is charged with a charge Qo using an…

Q: Problem 2 The voltage across a 2-F capacitor is shown in the given figure. Sketch versus time the…

Q: A 5-μF capacitor is charged to 1000 V. Determine the initial stored charge and energy. Ifthis…

A: Write the expression for the initial charge stored on the capacitor.

Q: 2F 100V 4F C, C3 1.5P 6F

A: Given, We have the circuit. We have to find equivalent capacitance. And energy. Please find the…

Q: A capacitor with capacitance C = 1.0 pF is charged to a potential of Vo = 9.0 V. The charged…

Q: Solve for the following: a. Equivalent capacitance b. Magnitude of charges c. Potential…

Q: The voltage at the terminals of the 0.6 µF capacitor shown is 0 for t 0. Find a) the current i(0);…

Q: A certain parallel-plate capacitor consists of two plates, each with area 200 cm2, separated by a…

A: If two metal plates are connected across a battery, then due to the charges of plates an electric…

Q: to discharge it. Sketch a graph of the current I in the resistor as a function of time,

A: The charging and the discharging function of a capacitor is an exponential function. When the…

Q: The capacitor in the circuit shown is charged to 20 V at the time the switch is closed. If the…

A: Given data: The voltage across capacitor is: 20 V The below circuit at t > 0, The value of…

Q: Ideal capacitors do not dissipate energy; they store it for use in the circuit. True False

A: An ideal capacitor is a purely reactive device, containing absolutely zero resistive effects. As a…

Q: Suppose that we have a 1000-pF parallel-plate capacitor with air dielectric charged to 1000 V. The…

A: Stored energy of parallel plate capacitor charged to 1000 V is: If the plates are moved and…

Q: Capacitors in Figure Ql(a) has been charged up to its steady state condition. For each of the…

Q: The voltage across a 10-μ H inductance is given by v( t )=5 sin( 10 6 t ) V. The initial current is…

A: The current through the inductor is expressed as:

Q: EXAMPLE 6. The waveform for the current in a 1nF capacitor is shown. If the capacitor has an initial…

A: Given data:

Q: A capacitor of capacitance 180 µF is charged to a potential difference of 9V. It is then discharged…

Q: A capacitor of capacity C is discharged through a resistance of value R. If the charge of this…

Q: 15. One design challenge for a capacitor-powered electric car is that the voltage would change with…

A: Energy U= 1/2 CV^2 V is the voltage C is the capacitance

Q: (e) An ideal 1 mF capacitor has a voltage of 10 V across its terminals for time, t 0, what is the…

A: The solution is as follows.

Q: The Table 1 below shows the voltage a cross a 36μF capacitor from 0s to 23s. Evaluate and plot the…

Q: A capacitor is charged with 50 mC in a time of 20 uS. If the energy stored in the capacitor is 5 J,…

Q: 22. You are being asked to design a parallel-plate capacitor having a capacitance of 1.00F and a…

A: For a parallel plate capacitor, the capacitance is given by the following formula: C = ε 0A/d Where…

Q: Use MATLAB to generate a plot of this charge as a function of time, where t = time 0 to 0.8, go =…

A: clearclct=0:0.01:0.8;q_0=10;%intial charge)R=60 ; %ResistanceL=9 ; %InductanceC=0.00005; %…

Q: A capacitor is made with a dielectric layer of mylar film that is 12μm thick. The effective area of…

Q: A capacitor is charged to a potential of 12.0 V and then connected to a voltmeter having an internal…

A: Given: Initial potential of capacitor V0=12 V Internal resistance of voltmeter R=3.4 MΩ At time t=4…

Q: A 0.8-F capacitor is connected in series with a 7-ohm resistor. If the connection is energized from…

A: find the voltage across capacitor at t = 2.5ms ?

Q: PROBLEM 2: In the circuit shown, capacitor C1 has an initial charge qo = 300 x 10-6 Coulombs. If the…

Q: Example: Three inductors have values L₁ = 10 mH, L₂ = 100 MH, and L3 = 500 MH. Determine the total…

Q: For a resistor, what resistance corresponds to a short circuit? For an uncharged capacitor, what…

A: For short circuit, Resistor The expression of ohm's law is, V=IR, for short circuit V = 0…

Q: 1. A current of 6 sin 4t A flows through a 2-F capacitor. Find the voltage v(t) across the capacitor…

A: In this question we need to find a voltage across capacitor.

Q: Consider the circuit below. The capacitor has a capacitance of 21 mF and starts out uncharged. The…

A: a) At time t=0, the switch is closed, the capacitor is replaced by short-circuit, the simplified…

Q: 2. A capacitor that has air between its plates is connected across a potential difference of 12.0 V…

Q: A capacitor with air between its plates is connected to a potential difference of 12 V and stores a…

Q: Q1 (a) (i) (ii) (iii) (iv) In your own words, explain how a capacitor appears to pass alternating…

A: Stray capacitance: This is unwanted capacitance that present in the circuit when the frequency is…

Q: The voltage across a 5 mF capacitor is shown in Figure Q1(b). (1) Draw the current waveform through…

Q: The parallel-plate capacitor of Figure shown below is quarter-filled with mica (Er= 6). Find the…

Q: The plates of a parallel-plate capacitor have areas of 10 cm each and are separated by 1 cm. The…

Q: A. Find the equivalent capacitance of the circuit. B. What is the charge stored by the 5 µF…

Q: The switch has been in position a for a long time, completely charging the capacitor. At t = 0 the…

A: (a): When the switch is in position a, the capacitor starts charging and it charges to the battery…

Q: Q2. The current at the terminals of the two capacitors shown in Figure 2 is 240e-10t µA for t 2 0.…

A: The given circuit is shown below: The voltage across the first capacitor is given by the…

Q: 4. If the current flowing through a 75 mH inductor has the waveform shown in figure 3, (a)sketch the…

A: In this question, We need to draw the voltage across the inductor V= L di/dt Where current I(t)…

Q: How would you relate the function of a capacitor to your personal life in terms of saving money?…

A: Capacitor is knowing for increasing power factor or correcting power factor if it is lower than the…

Q: In the circuit shown, assume that the capacitors were initially uncharged and that the current…

Q: Problem 2) The current in a 50 mH inductor is given as the following: i(t)= 2t D0 Determine the…

Q: The current () through a 40-mH inductor is equal, in magnitude, to the voltage across it for all…

Q: Att= 0, a 2.3 uF capacitance is pre-charged to an unknown voltage V. The capacitance is in parallel…

Q: . Energy stored in a capacitor: One application for capacitors is to store energy. Capacitors have…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A 100-μF capacitor has a voltage given by v( t )=10−10 exp( −2t ) V. Find the power at t=0
and state whether the power flow is into or out of the capacitor. Repeat for t 2 =0.5 s.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
List the five capacitor replacement rules.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
CONSIDER THE CIRCUT BELOW.SUPPOSE V1=10V AND V2=1V BEFORE THE SWITCH IS CLOSED,WHAT IS THE COOMN VOLTAGE ACROSS THE CAPACITOR AFTER THE SWITCH CLOSED.
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage