8.a. Which of the following most accurately describes the difference between a contactor and a starter? A. A starter contains a contactor and some additional protective circuitry. B. A starter is always mounted in an enclosure. C. A starter contains reversing contacts. D. A starter is always three-phase while a contactor may be single-phase or three-phase.

Q: 1. What is mean by sequencly connectión. 2. What is the benefit of using the, connectors (C], C2} in…

A:

Q: When you're taking a PM motor apart you should exercise special care not to damage the A. end…

A: In this question we need to choose a correct option.

Q: 1. What is the Phase Locked Loop (PLL) block and what is its purpose in the experiment circuit?

A: We are authorized to answer only 1 question at a time since you have not mentioned which question…

Q: 1. When is the counter EMF at a minimum?

A:

Q: Rotor eccentricity can be caused by A. high motor loads. B. excessive voltage. C. poor motor…

A: A rotor eccentricity is a condition of unequal air gap that exists between the stator and the rotor.…

Q: A 460VAC rated, 60 Hz, 125-Hp Three-phase induction type motor is to be connected for…

A:

Q: Your Answers may be presented through Discussions, Drawings/Figures/Diagrams, Reference to NEC/PEC…

A:

Q: approximate equivalent (type L) circuit parameters; There is a 3 phase, star connected, 50 Hz…

A: Given information about a three phase,bipolar,squirrel cage induction motor operated from 50 Hz…

Q: 1.) Variable frequency drive (VFD) is an electrical equipment used to control__________ of AC…

A: To select correct answers from given options

Q: a. it is the force exerted by the motor to perform a task b. it is a type of motor which is…

A: A motor is a device used for converting electrical to mechanical energy, they are three types of…

Q: Draw an electrical diagram for a Star Delta starter with a forward rotation and reverse rotation…

A: It is asked to draw an electrical diagram for a star-delta starter with a forward rotation and…

Q: 1. What will happen if the shunt field circuit is suddenly cut off when the d.c. motor is running at…

A: Since you have posted the multiple questions. So we are supposed to answer 1st one.1)In the given…

Q: 5. How are larger control transformers supplying a motor control center usually cooled?

A: The explanation is as follows.

Q: / choose the correct answer The back emf in a dc motor is ___________________?. 1-opposes the…

A: Acccording to lenz's law effect oppose its cause.

Q: Figure 24(1.) Compute the efficiency of the motor, if windage and friction losses neglected, for the…

A: In this question , we will find efficiency of motor..

Q: 4. What precautions concerning, the field circuit.b) The armature current must be taken when…

A: During the operation of DC shunt motor:

Q: 4. A d.c. series motor is driven by a DC variable-speed drive. The motor field and armature…

A: Given data: Ra=Rse=0.2 ΩN=3000 rev/minIa=8 AV=48 V

Q: 17.A. The arrangement which can NOT be used to control the speed of a universal motor operating from…

A: Here we discuss about the universal motor & a 1phase ac motor.

Q: 2. When multiple start stop pushbuttons are required the stop buttons are connected in and the start…

A:

Q: 4.a. The stop control in a three-wire control scheme stops the motor by A. increasing the resistance…

A: DOL starter : A direct on line starter (sometimes known as an across the line starter) is a way of…

Q: Draw the circuit diagram for the squirrel cage motor and name all the components too.

A: The circuit diagram for the squirrel cage induction motor:

Q: Part 3 Draw the power and control circuit of a forward-reverse starter for a 3-phase motor. Add 4…

A: It is asked to draw the power and control circuit of a forward-reverse starter for a 3-phase motor.…

Q: Advance Motor Control 1. Why are contacts often disconnected in series when controlling small…

A: consider the given question;

Q: If the starter resistance is 1.9 ohms, what current does the motor take at the instant of starting…

A: At starting back emf is zero. So armature current at starting =( terminal voltage- brush voltage…

Q: Identify the DC Motor used in Conveyor belt system. With a neat sketch explain its working. List…

A: Brushless DC motor used in the conveyor belt system. In Brushless DC motor mechanical Brushes are…

Q: A starting resistor will most likely be needed in a/ an A. line starter. B. reduced-voltage…

A: Induction motors and other high-power electrical equipment are started and have their rotation…

Q: What safely feature does the conbination starter provide that individual motor starting assemblies…

A: The combination starter consists of an across-the-line starter and a disconnect switch. It has a…

Q: By looking at which part of the motor, it can be easily confirmed that a particular motor is a DC…

A: In this question we need to choose a correct option

Q: 03-: Draw the SFC solution for: a- Unidirectional star delta starter. b- On delay direct on line…

A:

Q: QUESTION 12 The proper way to determine the required over-current protection is to: determine the…

A: There are several ways to determine the requirement of overcurrent protection as there should be an…

Q: provide advantages, disadvantages and then discuss different applications of the DOL motor starter…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again. The…

Q: Where can you find the low/high voltage connection diagram of a motor?

A: As per the NEMA, the low/high voltage connection of the motor can be classified by the number of…

Q: Select suitable three-phase motors for various given application giving details of ratings, starter…

A: A motor is required for an industrial air extraction system.The fan speed should be constant between…

Q: 3.a. Which one of the following motor types uses permanent magnets in the armature or rotor? A.…

A:

Q: How to avoid the effect of the high current at starting of the Motor? a. variable resistor is…

A: The induction motor takes a very high starting current so it is required to minimize the starting…

Q: 3. The armature of a 120 volts DC motor has resistance of 1.5 ohm and takes 4 ampere when operating…

A:

Q: 19. You’re powering up a new motor in a brushless motor control system. After moving the shaft of…

A: It is being given that : after moving the shaft of the motor slightly left to right, the motor…

Q: b) Determine the contactor and overload rating for DOL starter of the 93 kW three- phase squirrel…

A: As per our policy, I can solve only one question at a time. Given, P=93 kWV=415 Vf=50 HzN=1450…