8. The system shown in the following figure is static equilibrium and the angle 0 = 35º. Given that the mass m, is 8.30 kg and the coefficient of static friction between mass m, and the surface on which it rests is 0.31, what is the maximum mass that m2 can have for which the system will still remain in equilibrium?

8. The system shown in the following figure is static equilibrium and the angle 0 = 35º. Given that the mass m, is 8.30 kg and the coefficient of static friction between mass m, and the surface on which it rests is 0.31, what is the maximum mass that m2 can have for which the system will still remain in equilibrium?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

1. A 90-kg smooth circular cylinder A with a radius of 0.6 m is held in equilibrium by a cord CD and a bar BC of negligible mass. The length of bar BC is 2.4 m. a) Draw the FBD of the circular cylinder 60° and the bar BC. b) Determine the tension in the cord CD. 9,0.6 m 250 50°
1 A person exercises the quadriceps as shown. The diagram on the right shows a model of the leg, where the person's lower leg of length L = 0.60 m is held at an angle 0₁ = 60° with respect to the horizontal. The quadriceps muscle exerts a force FM via the tendon that attaches to the tibia at a distance d = 0.10 m from the knee, in order to lift a weight of mass m₁ = 5.91 kg that is attached to the foot. The tendon makes an angle of 0₂ = 11.5° with respect to the tibia. 2 What is the force required to hold the weight at the position shown in the diagram? Assume the person's lower leg weighs 150 N and its centre of mass is located at a distance L/2 from the knee. Round your answer to the nearest Newton. FM M d- 02 01 m₁
70. A pencil rests against a corner, as shown below. The sharpened end of the pencil touches a smooth vertical surface and the eraser end touches a rough horizontal floor. The coefficient of static friction between the eraser and the floor is u, = 0.7. The center of mass of the pencil is located.7cm from the tip of the eraser and(3 .0 cm from the tip of the pencil lead. Find the minimum angle 0 for which the pencil does not slip. Dlease ente your Auswer in 13 3 ст degrees CM 8.7 cm
11. The diagram below shows a ladder that is 6.0 m long and has a mass of 20.0 kg. The ladder rests on a level floor and against a wall at an angle of 15° to the wall. The coefficient of static friction between the ladder and the floor is 0.232. A person with a mass of 60.0 kg begins to climb the ladder. The base of the ladder will begin to slide away from the wall when the person reaches which distance interval from the base of the ladder? A. 0 m–1.5 mB. 1.5 m–3.0 mC. 3.0 m–4.5 mD. 4.5 m–6.0 m
Part 1: For each set of values for F₁, F2, 201, 20₂ in Table 1, determine the values of F3 and Ze, which will produce equilibrium. (See Figure 6) Record the values in Table 1. 3 0⁰ 1 2 3 4 F₁ gm 200 200 250 100 90°... F₂ F₁ gm 200 0₂ 300 150 300 180° Figure 6 Table 1 0₁ Deg 30⁰ 60° 90° 03 50° 0₁ deg 120° 300° 210° 120° F3 -270° F, Gm 290 280 230 350 0, deg 250° 163° 303 0 280
A 7-kg mass (m1) hangs from a cord that runs through a pulley and back down to attach to a 6-kg mass (m2) that is hanging from the other side. The pulley has a mass of 5.00-kg and a diameter of 20-cm. Find: A) the tension in the cord supporting m1 and the tension in the cord supporting m2; B) the tension in the cord supporting the pulley. C) Why is the answer to B) not equal to the sum of tensions in A)? Why is it not equal to the sum of the three weights?
Fg 120000 N FA+FB 165000 %3D FA+120000= 165000 FA=45000 N Ex : What is the value of the force (F) required to balance the system in the figure? M = 5 kg and F makes and angle (0 =37°) below 3 m 2 m OM Answer: ET about center 0 ITMl+ITpl 0 %3D 71Page
A 7-kg mass (m1) hangs from a cord that runs through a pulley and back down to attach to a 6-kg mass (m2) that is hanging from the other side. The pulley has a mass of 5.00-kg and a diameter of 20-cm. Find: A) the tension in the cord supporting m1 and the tension in the cord supporting m2; B) the tension in the cord supporting the pulley. C) Why is the answer to B) not equal to the sum of tensions in A)? Why is it not equal to the sum of the three weights?
Answer 1-10 , no need for solutions
I need Part A and Part B
39
2. Use the equilibrium conditions to find the weights w1, w2, and w; required to balance the mobile. Hint: start from the bottom rung and apply the conditions for equilibrium, then work your way up. 4 cm 8 cm 5 cm 1 cm W3 2 cm 4 cm w2 W1 0.5 N