7. An electric water heater has a rating of 1 Kw, 230 v. The coil used as the heating element is 10m long and has a resistivity of 1.724 x 10-6 ohm - cm. Determine the required diameter of the wire in mils? A. 2.43 mils В. 2.52 mils C. 3.21 mils D. 1.35 mils 8. A carbon resistor dissipates 60 W of power from a 120 V source at 20°C. How much power will be dissipated in the resistor at 120°C if connected across the same source? Assume the temperature coefficient of carbon at 20°C is -0.0005 per °C A. 61. 50 W B. 65.21 W C. 62.34 W D. 63.16 W 9. What is the total resistance of eleven 33kn resistors connected in parallel? A. 33 ko В. З кQ C. 363 kQ D. 11 kQ

7. An electric water heater has a rating of 1 Kw, 230 v. The coil used as the heating element is 10m long and has a resistivity of 1.724 x 10-6 ohm - cm. Determine the required diameter of the wire in mils? A. 2.43 mils В. 2.52 mils C. 3.21 mils D. 1.35 mils 8. A carbon resistor dissipates 60 W of power from a 120 V source at 20°C. How much power will be dissipated in the resistor at 120°C if connected across the same source? Assume the temperature coefficient of carbon at 20°C is -0.0005 per °C A. 61. 50 W B. 65.21 W C. 62.34 W D. 63.16 W 9. What is the total resistance of eleven 33kn resistors connected in parallel? A. 33 ko В. З кQ C. 363 kQ D. 11 kQ

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.7MCQ: Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a)...

See similar textbooks

Similar questions

A direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating current that will produce heat at the same rate in this resistance. Expresss answer to the nearest hundredths.
Ferromagnetic materials have this characteristic. A. A relative permeability slightly less than one. B. A relative permeability slightly greater than one. C. A very high resistivity. D. A high relative permeability.
8. The resistance of a copper at 30°C is 50 ohms. If the temperature coefficient of copper at 0°C is 0.00427. What is the resistance at 100°C? 9. A wire has a resistance R are cut into 2 pieces and the small pieces are connect in parallel resulting to a total resistance of 2 ohms. What is the value of R?
Asap
Which of the following is NOT a variable in voltametric methods? A. How the current is applied B. How the potential is applied C. The inclusion of convection D. All the above E. Type of working electrode
20. The resistance R and a 2 μF capacitor are connected in series across 200-V dc supply. Across the capacitor is a neon lamp that strikes at 120 volts. Calculate the value of R to make the lamp strikes 5 seconds after the switch has been closed. A. 4.89 kΩ B. 4.89 MΩ C. 2.73 MΩ D. 2.94 MΩ
10) A certain batch of copper wire was found to have a conductivity of 98% at 20°C. What is its resistivity in un-cm? www
There is a steel guide bar (According to figure), knowing that its conductivity is 7x106 (ohm - m)-1 . Determine the resistance at 45 ° C and the gauge of a copper wire for its connection.
10) A certain batch of copper wire was found to have a conductivity of 98% at 20°C. What is its resistivity in un-cm? 11) The resistance of a copper at 30°C is 500. If the temperature coefficient of copper at 0°C is 0.00427. What is the resistance at 100°C?
A certain batch of copper wire was found to have a conductivity of 98% at 20°C. What is its resistivity in u0-cm?
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
A tungsten filament has a temperature of 20.50 degrees Celsius and a resistance of 500 ohms when taking normal working current. Calculate the resistance of the filament when it has a temperature of 25 degrees Celsius . Given the RTC at O degree Celsius is 0.00501 per degree Celsius.