Consider the duct system shown in the following figure.7" x 10"7" x 10"30 ft/s30 ft/s14" x 12"Air flows through two 7 in. x 10 in. ducts that merge into a 14 in. x 12 in. duct. The average speed of the air in each of the 7" x 10" ducts is 30 ft/s.What is the cross-sectional area of flow of the 7" x 10" duct (in ft²)? What is the volume flow rate of air in each of the 7" x 10" ducts (in ft³/s)?ft³/sWhat is the volume flow rate of air in the 14" x 12" duct in ft³/s?ft³/sWhat is the volume flow rate of air in the 14" x 12" duct in ft³/min?ft³/minWhat is the volume flow rate of air in the 14" x 12" duct in m³/s?m³/sWhat is the cross-sectional area (in ft²) of flow of the 14" x 12" duct?ft²What is the average speed (in ft/s) of air in the 14" x 12" duct?ft/s

7" x 10" 7" x 10" 30 ft/s 30 ft/s 14" x 12" Ⓡ Air flows through two 7 in. x 10 in. ducts that merge into a 14 in. x 12 in. duct. The average speed of the air in each of the 7" x 10" ducts is 30 ft/s. What is the cross-sectional area of flow of the 7" x 10" duct (in ft²)?

7" x 10" 7" x 10" 30 ft/s 30 ft/s 14" x 12" Ⓡ Air flows through two 7 in. x 10 in. ducts that merge into a 14 in. x 12 in. duct. The average speed of the air in each of the 7" x 10" ducts is 30 ft/s. What is the cross-sectional area of flow of the 7" x 10" duct (in ft²)?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please answer question in detail subject is fluid mechanics
A fluid flows at 0.002 m³/s through a 150- mm - diameter pipe. Determine whether the flow is laminar or turbulent if the fluid is: a. Air (v = 1.48 x 10³ m²/s) b. Ans. laminar Water (p = 8.90 × 10^ Pa-s) Ans. turbulent Mercury (u = 1.53 x 10³ Pa-s) Ans. turbulent Glycerin (v = 1.18 x 10³ m²/s) d. e. Gasoline (v = 4.06 x 107 m²/s) Ans. laminar Ans. laminar
Air enters this square duct at section 1 with the velocity distribution as shown. Note that the velocity varies in the y direction only ( for a given value of y, the velocity is the same for all values of z). What is the volume rate of flow? What is the mean velocity in the duct? What is the mass rate of flow if the mass density of the air is 1.2 kg/m cube?
Problems for Practice 7. A fluid flows at 0.002 m³/s through a 150 - mm diameter pipe. Determine whether the flow is laminar or turbulent if the fluid is: a. Air (v = 1.48 × 105 m²/s) b. Water (μ = 8.90 × 104 Pa-s) Mercury (u = 1.53 × 10-3³ Pa-s) d. Glycerin (v = 1.18 × 10³ m²/s) Gasoline (v = 4.06 × 10-7 m²/s) C. e. Manila FB: @ReviewinnovationsOfficial
dont explain just give the solution
Water enters a one-inch diameter pipe at a pressure of 45 psi. Calculate the velocity of the water flowing through the pipe.
The flow of water in a pipe of about 3 meters in diameter can be measured by a. venturimeter b. orifice meter c. pitot tube d. rotameter
A circular air duct has a diameter of 21 centimeters. Find the cross-sectionalarea of the duct in square meters.
There is a pipe section with a 16 inch diameter and a pipe section with a 12 inch diameter. The flow rate through both pipes is 13 cubic feet per second. The velocity in the 16 inch pipe is 2 feet per second. What is the velocity in the 12 inch pipe?
4. A venturi meter with throat diameter of 37.5 mm and coefficient of discharge of 0.957 is connected to a 75 mm pipe to measure the discharge of oil with specific gravity of 0.853. A differential gage filled with liquid with specific gravity of 1.35 is connected. If there is a 415 mm difference in the height of the fluid in the meter, what is the flowrate of oil?
Water entering through 5 ft long and 1 inch diameter pipe has a flow rate of 100 kg/min at a temperature of 100 °C and pressure of 1.95 bar at exit. The density of water at these conditions is 961.5 kg/m3. Calculate the rate of work done at the exit of pipe.
22. In a bakery, water is forced through pipe A at 150 liters per second. Oil (sg = 0.8) is forced through pipe B at 30 liters per second. Assume ideal mixing of incompressible fluids and the mixture of oil and water form globules and exits through pipe C. Evaluate the specific gravity of the mixture exiting through the pipe C. a. 0.385 c. 0.976 b. 0.257 d. 0.865 23