7 Water flows through a horizontal pipe at the rate of 800 gal per min. What is the difference in pressure between a point where the diameter is 2 in. and a point where the diameter is 1 in.?

Q: The figure belows shows a closed tank holding air and oil to which is connected a U-tube mercury…

A: L1 = 2 ftL2 = 0.5 ftL3 =1.25 ftThe density of oil, ρoil =55 lb/ft3 The density of mercury, ρmercury…

Q: AU-tube manometer filled with water, density 62.4 lbm/ft3, shows a height difference of 10 in. The…

A:

Q: , what is the volume flow rate?

A:

Q: You fill a 7.0 x 10-3 m3 bucket with water that flows from a pipe of radius 1.30 cm. If it takes…

A: given: volume of bucket=7*10-3 m3 radius of pipe=1.30cm time it takes to fill the tank=48 secs…

Q: Pressure = weight density x depth What is the water pressure at the bottom of a building that has a…

A:

Q: 3.) Points A & B are measuring the pressure at two points in a stagnant water column. What is the…

A:

Q: A tank that is 5.00 m deep is filled with an unknown fluid on an alien planet. Assume g = 12.0 m/s2.…

A:

Q: 7. A large container, 122 cm deep is filled with water. If a small hole is punched in its side 79.0…

A:

Q: sure sensor is used to measure the water level in a tank. The water density is 1000 kg/m3. What…

A:

Q: The inside diameters of the larger portions of the horizontal pipe are 2.50 cm. Water flows to the…

A: Let d1 be the inner diameter of the cross-section of the larger horizontal pipe, and R be the flow…

Q: Calculate the absolute pressure at an ocean depth of 1.0 km. Assume that the density of Water Pwater…

A: Given that-Depth of ocean, h= 1 km=1×103mDensity of water, ρ= 1.025×103 kg/m3Atmospheric pressure,…

Q: water hose is used to fill a 35.0 liter bucket. If it takes one minute and a half to fill the…

A: Given  Volume of bucket, V = 35.0 liter = 35.0×10-3 m3 Time to fill, T = 1.5 min = 90 sec  Flow…

Q: Fresh water moves at a constant speed through a pipe. The pipe bends upward, but the diameter does…

A:

Q: 1.6 A manometer connects an oil pipeline and a water pipeline, as shown. Determine the difference in…

A: Pressure due a column of fluid is given by P = ρgh, where ρ = the density of the fluid, g =…

Q: (Figure 1) shows a tank of 20°C water with a nozzle h = 25 cm below the surface. Bernoulli's…

A: Given:  The constant height, h = 25 cm Diameter of nozzle, d = 1.0 mm   To Find:  Volume flow rate…

Q: The flow through a 2.0 inch inside diameter pipe is 5000 liters per hour. What would the velocity of…

A: The discharge of the flow is, Q=5000 lt/hr=0.049 ft3/s The diameter of the pipe is, d=2 in=0.167 ft

Q: The entrance opening of a horizontal pipe has a radius of 6 cm and water is flowing at .35 m/s. The…

A:

Q: Oil is flowing through a pipeline at a speed of 1.4 m/s. If the diameter of the pipe is 0.12 m, what…

A: Given Speed = 1.4 m/s Diameter of the pipe = 0.12 m Radius of pipe = 0.06 m = 6 x 10-2 m

Q: The volume flow rate in a small rubber water pipe is 7.99 x10−6 m3/s. If the radius of the pipe is…

A:

Q: synthesis problems SP1. Suppose that the input piston of a hydraulic jack has a diameter of 2 cm and…

A:

Q: Pressure in the spinal fluid is measured as shown in the figure, by connecting a small tube between…

A: The objective of this question is to convert the pressure in the spinal fluid from mm Hg to cm of…

Q: A hydraulic lift consists of an enclosed fluid with two pistons with circular cross sections -…

A: Pascal's Law : Equal Pressure is transmitted for incompressible fluid  in all directions . Given :…

Q: In a hydraulic press the small cylinder has a diameter of 8.0 cm, while the large piston has a…

A:

Q: Water travels through a pipe at 12.3 m/s. The pipe contracts from a crossectional area of 1.4 m² to…

A:

Q: To suck lemonade of density 1000 kg/m3 up a straw to a maximum height of 85 mm, what is the minimum…

A: The density of lemonade is given as The maximum height is

Q: Water enters a pipe with a cross-section of 1.6 m2 and a velocity of 4.7 m/s.  What is the velocity…

A:

Q: As shown in the figure below, a hydraulic system has two pistons of different diameter and uses a…

A:

Q: A horizontal pipeline enlarges from a diameter of 6 in. at point A to a diameter of 12 in. at p B.…

A: Given that;At A:Diameter of pipe = 6 in.Water flow rate vA = 20 cu.ft per sec, 34560 cu. in. per…

Q: The volume flow rate in a small rubber water pipe is 7.53 x10−6 m3/s. If the radius of the pipe is…

A: Volume flow rate,  Radius of the pipe,

Q: What is the weight of the oil raised, 5.5 cm height, in the capillary tube, diameter of 0.50 mm. The…

A: Height (h) = 5.5 cm = 0.055 m diameter (d) = 0.5 mm = 0.0005 m Density (ρ) = 920 kgm3

Q: Water flows with a constant speed through  pipe of constant cross-sectional area in the ground floor…

A: Part a: The pressure difference between top (P1) and bottom (P2) is given in terms of density of…

Q: What is the flow rate of a horizontal pipe whose intake diameter is 20 cm, and the constriction…

A:

Q: Calculate the absolute pressure at an ocean depth of 2.8 km. Assume that the density Water Pwater is…

A:

Q: A horizontal pipe has diameter of 3.00 cm in one portion in which the pressure is 5,423 Pa and the…

A: From Bernoulli's principle, P+12ρv2+hρg=constant, where P is pressure, v is velocity of fluid, h is…

Q: The input piston on a hydraulic lift has area A. =1.5×10-4m? and the lift plunger has area…

A: From pascal law  The pressure within a liquid is constant  Using this we increase the area the force…

Q: in PAin (a) 2014 Pearson Education, Inc. Aout P out out A hydraulic lift is being used to elevate a…

A: Input force (F) = 327 NInput area (A) = 0.03 m²Output area (a) = 0.23 m²Output pressure (Po) =…

Q: 2. A cylindrical tank with a diameter of 1.5 meters contains a fluid with specific gravity of 9.0.…

A:

Q: A hydraulic lift is designed with an input (smaller) cylinder that has a diameter= 4 cm. The output…

A: In the question given the value of force F1 input diameter d1 and output diameter d2 then we have to…

Q: crate with a total mass of 11560kg has dimensions 2.0m by 1.4m across the bottom and is 1.10m tall.…

A: Given:- m=11560 kg Dimensions of crate 2.0m by 1.4m across the bottom and is 1.10m  Find:- a) The…

Q: Please, find pressure on the bottom of the reservoir if Po=114305.57 Pa, density 1 = 907.99 kg/m^3,…

A: Given:-  We have given that the reservoir filled with the different densities of liquid for…

Q: In Niagara falls 5800 m3 of water flows every minute. What is the flow rate ( Q)?

A: Given data:     Volume of the Niagara falls, V = 5800 m 3       Time. t = 1 min = 60 sec