Answered: 6.30. The passage is 1.2 m wide normal…

6.30. The passage is 1.2 m wide normal to the paper. What will be the horizontal component of force exerted by the water on the structure?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: table is located 3m. below the ground surface and the saturated unit weight of the soil below the…

A: Given data Height of wall = 3 m Unit weight of soil upto 3 m =16 kN/m3 Angle of internal friction,…

Q: inverted

Q: Examine the rotational stability of the wall below 3 m 32 y=20 kN/m' $ = 36° For the right side: 6 =…

A: Given: A retaining wall as shown below Required: To examine rotational stability

Q: Redo problem la assuming the wall cannot yield or bend, use Jaky's 1944 approach to lateral earth…

A: Given: A retaining wall that cannot yield or bend Soil profile consists of two layers Required: To…

Q: There is a body of water behind a 10 m high wall. If a hydrostatic pressure force of 3 000 kN is…

A: Given data in question Hydrostatic force Total height Water as fluid To find out Width of wall

Q: 3.a. A buried cable installation will use a duct with a diameter of 8 cm. Three cables, each with a…

A: KINDLY NOTE: As per our guidelines we are supposed to answer the first question n case multiple…

Q: 4 m * 3 m 5m Wall Base Y sat = 17 kN/m³ cs = 20° Y sat = 18 kN/m³ $ = 30° Y sat = 17.8 kN/m³ cs =…

A: The coefficient of Rankine's active earth pressure is calculated by the following formula:The…

Q: (a) Check for stability of the wall with respect to sliding. (b) Check for overturning stability.…

Q: As shown in Fig. determine the submerged depth of concrete cylinder (h), for equilibrium the gate…

Q: 3.5 m, determine an show the resultan hat water exert on the overhang sea wall along ABC, as shown…

A: To find resultant force

Q: Design the vertical stem of a T-shaped retaining wall for a height of 3 m above the ground level.…

Q: A rectangular concrete beam 120 × 300 mm is prestressed by straight cable, effective force 180 kN at…

A: Given that :- A rectangular concrete beam B = 120 mm D = 300 mm Effective force = P = 180 kN…

Q: Draw a schematic or an FBD of the retaining structure. Indicate all the forces acting on it that…

A: 1 gravity force 2 active earth pressure force 3 friction force 4 normal force

Q: The reduced level of a floor is 99.995 m, the staff reading on the floor is 1.505 m. If the inverted…

A: From the given date it is required to find the floor level below the slab.

Q: ▪ Determine the magnitude of the at-rest lateral earth force, Rankine active/pass unit length of the…

A: H=7m Y=17kN/m3

Q: the two sides are held together by a cable placed every 3 m along the length of the trough.…

Q: PROBLEM 5 A residential reinforced masonry foundation wall is 12 feet tall and supports a SM-SC…

A: Given data A residential reinforced foundation wall is 12 feet tall and support a SM-SC soil The…

Q: The gravity wall is made of concrete. Determine the location of the center of gravity (G) for the…

A: To determine the centroid of the dam.

Q: A long retaining wall is braced by wood shores set at an angle of 30° and supported by concrete…

Q: a.) calculate the total active force on the wall in KN/m, neglecting cohesion above the water table…

A: Dry unit weight of sand = dry weight of sand/Initial Volume of soilDry unit weight of sand =…

Q: Calculate the factor of safety of this stone wall against sliding and then check for eccentricity

A: given φ=31°ka=1-sinφ1+sinφKa=1-sin311+sin31Ka=0.32inclination to horizontal fill is given as…

Q: Determine the lateral earth force at rest per unit length of the retaining wall when the ground…

A: Introduction : The horizontal pressure exerted by soil is known as lateral earth pressure. The…

Q: The structure is worked up by El-Centro earthquake with zeta=five%. it's far required to investigate…

Q: 4) The 1000-kg horizontal wall section is sunpoted hy the three vertical cables, A., ant en What are…

A: To determine the tension in the cables supporting a wall section of given mass. Given, Mass of the…

Q: Calculate the total stress, pore water pressure, and effective stress at the center of the strata.…

A: To find effective stress at center of strata

Q: 3. A tank wall has the "boot" shape shown below. Determine the horizontal and vertical components of…

A: Given :

Q: Determine the resultant active lateral earth force acting on of the wall shown and its location. 2.…

A: Solution: Given: Height of wall (H)=4m Surcharge (q)=10kN/m2 γ=18kN ϕ=40 We will solve the given…

Q: or the circular arch shown in Figure TH – 085, compute the axial force, shear, and ment at section…

A: As per guidelines we need to answer only first question so please repost rest questions separately.

Q: Pi= 1200 KN P = 1200KN %3D +3m Find the location of the point of inflection from the left end of the…

A: A footing is a part of the foundation that needs support the foundation so that the structure does…

Q: b. Lateral pressure due to soil (in kN/m2 per meter length of wall): @ point R = @ just above point…

Q: Check the wall below for sliding and overturning. Does it work? The wall thickness at the top reads…

Q: 25m 'o.4m find the Length of given figur Albove Wall thickness =0.4m Sol Ve by Centerline Method and…

A: Center line method: The total centre line length of a building's walls is computed, then multiplied…

Q: Lateral force of soil on the retaining wall acts at ½ the backfill height. True or False

Q: answer should be in MPa

Q: The reduced level of a floor is 99.9 m, the staff reading on the floor 1.505 m. If the inverted…

Q: Y-15 kN/m '-28° 4m G.WT. Yu 20 kN/m 4-33° c'0 4m The above figure shows a concrete gravity retaining…

Q: In a normal fault, the a. hanging wall moves upward relative to the footwall b. hanging wall…

A: Normal Fault or Dip-slip fault- It is also known as Gravity fault or tensional fault. This fault…

Q: A channel has a section of uniform thickness as shown in the figure. b = 100 mm, t = 4 mm and h= 150…

Q: 6M A 3M 24 kN/M 3M 3M A. Draw the free body diagram B. Determine support reactions B 3M 1.5M 1.75M…

A: Free body diagram is the diagram , in which we shows the various forces acting on member thus it is…

Q: Calculate the active and passive earth pressures . And the distance at which the net active force…

A: ka = 1-sin∅1+sin∅ kp = 1/ka

Q: Compute the hydrostatic force acting on surface ABC exerted by water. Given wall width as 2 m.

A: Question is based on the surface ABC covered with water . Width of wall and depth from surface are…

Q: The maximum shear force in the beam is 37.50 KN. If the beam is 5-meter channel section, C200 x…

A: The maximum shear force in the beam is 37.50 KN. Ifthe beam is 5-meter channel section, C * 200 *…

Q: Y = 18 kN/m3 O = 30° 8 = 15° %3D H. H. CS

A: Draw FBD of case 1: Draw FBD of case 2:

Q: Determine the weight of block A so that the 2-ft-radius circular gate BC begins to open when the…

A: Given : Radius of circular gate = 2 ft h = 4 ft To find : Weight of block A ? Figure given :

Concept explainers

System of Forces

A force is an external influence or agent that changes the state of a system. According to Newton's second law, the force applied to a body is proportional to the change in momentum of a body. Hence, whenever a force is applied to a body, its momentum changes. If the body is at rest, under the action of force, its state of rest changes to motion. In other words, the magnitude of the momentum of the body changes from zero to a measurable value. Similarly, if the body possesses some initial velocity, it has some associated momentum, the effect of force can cause the body to halt or come to rest, that is, the momentum reduces to zero.

Question

6.30. The passage is 1.2 m wide normal to the paper. What
will be the horizontal component of force exerted by the water
on the structure?
1.5 m
0.6 m
Problem 6.30
0.9 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

4. The backfill behind the concrete retaining wall weighs 100pcf with an internal friction of 25º. The surcharge load on the surface of the horizontal backfill is 200psf. a. Calculate its total active force acting on the wall per unit widthb. Determine its factor of safety against overturning.
5. A 13-m-high, 7-m-wide rectangular plate blocks the end of a 12m-deep freshwater channel, as shown in the figure. The plate is hinged about a horizontal axis along its upper edge through a point A and is restrained from opening by a fixed ridge at point B. Determine the force exerted on the plate by the ridge. I'm 12 m
Refer to the braced cut shown in the figure for which y= 20 kN/m², o'=23°, and c' = 0. 2.0000 The struts are located 5 m on center in the plan. Determine the strut load at B. 3.0000 B. 3.0000 2.0000 A 47.46 B 474.6 C 94.92 D 237.3
60 kN-m A C |--1.2m- Fig. P5.59 80 kN/m D 12 kN.m 1.2 m 1.6 m 1.2 m B 0600 I W250 × 80 show each cut section and the forced snd moments associated with each cut, find the graphs for v(x) and moment(x) and determine max normal stress
The reduced level of a floor is 99.995 m, the staff reading on the floor is 1.505 m. If the inverted staff reading against the roof is 1.795 m, the floor level below the slab, is 3.290 m O 2.790 m O 3.275 m O 3.300 m O
Problem#2 A level scaffold is to be supported at the center of a 12-ft ladder, as shown below. 1. Determine the required length x 2. Determine the angle 0. Required length x 1. 4.53 2. 6.63 3. 3.56 4. 7.58 Angle 0 1. 36.4 2. 40.6 3. 56.4 4. 50.8 X 0 12' ladder - Scaffold 5'
Describe the role of each of the structural features circled in red of theretaining wall (arm or stem, heel, key and toe) depicted in Figure Q2(b)aimed at resisting the pressures/stresses being imposed on the retainingwall by the mass of soil, mass of the retaining wall and any moisturecontained in the soil. Make particular references to the actions of normalstresses, shear stresses and bending moments.
A vertical rectangular plate 2m by 3m is submerged with its 2m edge on the same level with water surface. Find the total hydrostatic force acting on one face of the plate. a. 52.5 kNb. 88.29 kNc. 36.5 kNd. 40.5 kN
Q5: In the case of the retaining wall depicted below. Calculate the lateral earth fore at rest per unit length of the wall. Determine the location of the resulting force as well as its magnitude. [25] y = 16.5 kN/m $ = 30 C = 0 Ground v Water table 2.5m Yur = 19.3 kN/m 0 = 30 C = 0 2.5m Good Luck
ANALYZE THE FOLLOWING 3 HINGED ARCHES.