6 m -1.5 m 2 m m 2.5 m The balloon shown in the figure is being held in place by the hooks placed in B, C, and D. If F = 495 N, determine the tension in cable AB (in N). ROUND OFF TO TWO DECIMAL PLACES.

6 m -1.5 m 2 m m 2.5 m The balloon shown in the figure is being held in place by the hooks placed in B, C, and D. If F = 495 N, determine the tension in cable AB (in N). ROUND OFF TO TWO DECIMAL PLACES.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Figure Q1(b) shows a flexible cable AC and a rigid member BC is holding a load P at the end of point…

A: Given AB= 500 mm BC= 100 mm And AC is a flexible member while BC Is a rigid member Strain AC =…

Q: 3.17 The 3200-lb weight is supported by two cables. Knowing that the resultant of the cable tensions…

Q: The balloon shown in the figure is being held in place by the hooks placed in B, C, and D. If F =…

A: A0,0,6B-1.5,-2,0C2,-3,0D0,2.5,0Position vectors :rAB=-1.5i-2j-6krAC=2i-3j-6krAD=2.5j-6kForce…

Q: C 3 4. 45° В

Q: A winch at point B is used to slide a box up a chute CD in a warehouse. If the component of the…

Q: e= 30° B 1000 lb

A: Draw FBD:

Q: Problem #4: A 6 = 10+C (degrees) D В The street-lights at A and B are suspended from the two poles…

Q: C A 3 4. 45° В D

A: From the above figure Inclination of BC to Horizontal= 45° Similarly inclination of AB=…

Q: Determine the mass (kg) of the heaviest cylinder that can be supported without exceeding a stress of…

Q: If the tension in cable DE is 620 N, determine the moments of this tensile force (as it acts at…

Q: From the given cable shown. Use the general cable theorem. P is in kips. Let P = 20 24 24° NH D…

Q: A cable weighing 40N per meter of length is suspended from point A and passes over a small…

Q: Q.13.9 Figure below show a cable suspended through simple supports. Assuming point A as origin, the…

Q: Q.3) Consider the pedestrian bridge shown in figure below. The magnitudes of tensions in cables 2,…

A: Given:- T2=T3=T4=T To find:- T1 P

Q: Very urgent. The box in the figure is connected by a cable from point A to point B. If the stress T…

Q: Та Tb 15° 30° Td Tc 60° 75° W

Q: Q2: The cylinder A weighs 450 N and it is supported by the vertical smooth wall and the cable system…

A: Given that: Weight of cylinder, W = 450 N

Q: 100 m 3. A cable supports a load of 50 kg/m uniformly distributed along the horizontal and is…

A: First, calculate the distance of the lowest point from each end. Then calculate the horizontal…

Q: Box A of 200 N starts from rest and slides down from the inclined plane. The rollers are…

A: Given,Weight of box A, WA = mAg = 200 NFriction force between the box A and the inclined plane, Fs =…

Q: From the given cable shown. Use the general cable theorem. P is in kips. Let P=20 [Select] [ Select]…

Q: 4. Based on the figure above, solve for the tension force on cable 3. 11m 3 12 KN 2 16 KN

Q: Determine the tensions in cables A, B, C and D of the cable system supporting a weight of 100 N as…

A: Given data Find force in member A, B, C and D.

Q: 6- A cable, of uniform weight per unit length (w=1 kN/m), is suspended between two points A and B…

Q: 2.3 The cable stays AB and AD help support pole AC. Knowing that the tension is 120 lb in AB and 40…

A: Schematic diagram of the given problem:

Q: The sphere of weight, W = 49.05 N, is suspended by a cable with length, a = 3 m as shown. If it…

Q: Determine the tension in each segment of the cable shown in Figure 1. Also, what is the dimension h?…

A: Introduction- A cable-stayed bridge features one or more towers from which the bridge deck is…

Q: 3–7. The man attempts to pull down the tree using the cable and small pulley arrangement shown. If…

A: Step 1

Q: A crane boom of mass 450 kg with its center of mass at C is stabilized by two cables AQ and BQ (A, =…

Q: A crane is oriented so that the end of the 25-m boom AO lies in the yz plane. At the instant shown,…

A: Tension on cable AB = 4.6 kN From the figure OC=252-152 =20 m

Q: Consider that the catenary cable in the figure is anchored between supports A and B and is…

A: Consider the free body diagram of the given symmetrical parabolic cable as shown below. d=20 m…

Q: Problem 3 (a) Calculate the support reactions and the maximum tension in the cable shown. Skif (b)…

Q: A water trough of semi-circular cross-section of radius 0.6m consists of two symmetric parts hinged…

Q: 1. Calculate the tension in each cable in kilo-Newtons. 4 m 3m 3 m 2.5 KN 5000 N 3 m 30°

Q: Consider the three-dimensional structure shown in the figure, fixed to the ground at point O, and…

Q: y The tension in cable AB is 150 N. The 5m tension in cable AC is 100 N. Determine the sum of the…

Q: A winch at point B is used to slide a box up a chute CD in a warehouse. If the component of the…

A: Force: Force is a external pull or push that can be applied on a body for the movement of the body…

Q: A load W is to be lifted using the crane BC which is hinge at B as shown in the figure. Neglecting…

A: To find Largest weight W?

Q: Note: Rep number by Problem #4: 8 = 10+C (degrees) D В Use The street-lights at A and B are…

Q: 1. Pis a cube with 300mm sides and weighs 45kg per cubic meter. Rope CB is 20mm in diameter and can…

Q: The Resultant of the concurrent forces in the figure below is R = 201 N. pointing up along y-axis.…

A: The components of a force can be seen with horizontal and vertical change when looking at the…

Q: Situation 2: Find the minimum force P required to just pull out box B. Also, find the tension of the…

Q: The 52-kg cylinder is suspended from a clamping collar at C which can be positioned at any…

Q: A uniform steel bar of length 10 m is supported at point A and B using two cables as shown in the…

Q: Q3): For the cable subjected to a uniform load of (last two digits of your student Number in KN/m)…

A: Note - Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: Q.3 B/ Consider a cable hanging under its weight between two supports rks) as shown below, deduce…

A: Solution When a cable hangs due to its self-weight, it is called as Catenary the maximum sag in…

Q: Determine the sag at points C and E on the cable in the figure below (Sag at point D is given), and…

A: GIVEN- L=160ft

Q: 2/93 SS If the tension in the gantry-crane hoisting cable is T = 14 kN, determine the unit vector n…

A: Given data:- The given tension in the cable T=14 kN

Q: A winch at point B is used to slide a box up a chute CD in a warehouse. If the component of the…

A: Given :

Concept explainers

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.

Question

6 m
(1.5 m
m
B
m
D
-3 m.
2.5 m
The balloon shown in the figure is being held in place by the hooks placed in B, C, and D. If F = 495 N, determine the tension in cable AB (in N).
ROUND OFF TO TWO DECIMAL PLACES.
2.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

igure 1), F = {500i - 300j + 350k} N. Determine the magnitude of the projection of the force F acting along the cable BA. Express your answer to three significant figures and include the appropriate units. 2m Fon BA= Submit B -1m S Value Request Answer 1m μА D 6 m 3m Units ?
Question 17 F A 6 m -1.5 m 2 m B D 3 m 2.5 m The balloon shown in the figure is being held in place by the hooks placed in B, C, and D. If F = 272 N, determine the tension in cable AB (in N). ROUND OFF TO TWO DECIMAL PLACES.
A Fa C P = 900N, a = 42°, B = 40°,0 = 14° A load P is supported by two cables as shown, considering the equilibrium at point-C, estimate the tension in the cables. (Answer upto 1 decimal place) N. Tension in cable AC:
T(t) Cable B. Fe) 600 N - 360 N M t=12s t=24s The winch, shown in the figure, delivers a horizontal towing force, T(t), to its cable at D. The force varies with time as shown in the graph. Determine the speed of the 80-kg mass when 't reaches 24 s. Assume that at t=0, the mass has zero velocity. Also assume that the pulleys and cables are massless.
The 540-1b cylinder at A is hoisted using the motor and the pulley system shown. The speed of point B on the cable is increased at a constant rate from zero to vB = 30 ft/s in t = 8 s. (Figure 1) Figure 1₁ A B 1 of 1 Part A Determine the tension in the cable at B to cause the motion. Express your answer to three significant figures and include the appropriate units. T = Value Submit μA Provide Feedback Request Answer Units ?
View Policies Current Attempt in Progress The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB is 7.5 kN. Determine the required tension Tin cable AC such that the net effect of the two cables is a downward force at point A. Determine the magnitude R of this downward force. Assume a = 33 m, b = 42 m, c = 22 m, and d = 32 m. L B Answers: T = i KN H R = i Save for Later Attempts: 0 of 1 used Submit Answer KN
In (Figure 1), F = {300i - 100j+700k} N. Figure 2 m B 220 m Z -1 m 6 m 3 m < 1 of 1 Part A Determine the magnitude of the projection of the force F acting along the cable B.A. Express your answer to three significant figures and include the appropriate units. Fon BA = Submit Provide Feedback μÀ Value 5 Request Answer Units ?
Example1: The block has a mass of 90 kg and it is supported by the cable system shown in figure. Determine the tensile force in cable DE. Solution: E.B.D. of ring at B F.B.D. of ring at D EB.D. of block TBD TAB TBC Три 40 30 45 TDE 40 Wolock = 90. 9.81 = 882.9 N TAB Block TBD
A water supply pipeline crossing a wide river is to be supported by a flexible wire cable with an allowable tensile load of 40000 kg. The pipe weighs 100 kg per meter and has a total length of 100m. Determine the tension the Lowest point of the cable if the sag is to be 3.5m. a.) None of the above b.) 36600.368 kg c.) 36060.836 kg d.) 36600.863 kg e.) 36006. 368 kg
A system of cables is shown and in a state of equilibrium. Using equilibrium equations, solve for the absolute value of P (in kN). A 1 C 1 3 B 4 P+60KN
The 60-kg cylinder is suspended from a clamping collar at Cwhich can be positioned at any horizontal position x between the fixed supports at A and B. The cable is 14 m in length. Determine and plot the tensions in cable segments AC and BC as a function of x over the interval 0 < x < 13. Do your plot on a separate piece of paper. Then answer the questions to check your results. 13 m x B C 60 kg Questions: N (a) If x= 3.6 m, the tension in cable AC is i N (b) If x= 8.7 m, the tension in cable BC is A MANTENE IN i
The 59-kg cylinder is suspended from a clamping collar at C which can be positioned at any horizontal position x between the fixed supports at A and B. The cable is 14 m in length. Determine and plot the tensions in cable segments AC and BC as a function of x over the interval 0 ≤ x ≤ 12. Do your plot on a separate piece of paper. Then answer the questions to check your results. A 12 m C 59 kg B