6) A sample of gas is compressed to one-third of its initial volume at a constant pressure of 1.25 × 105 Pa. During the compression 100J of work is done on the gas. What is the final volume of the gas?

6) A sample of gas is compressed to one-third of its initial volume at a constant pressure of 1.25 × 105 Pa. During the compression 100J of work is done on the gas. What is the final volume of the gas?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter3: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 53P: A gas in a cylindrical closed container is adiabatically and quasi-statically expanded from a state...

See similar textbooks

Related questions

Q: A convex mirror of focal length 5 cm produces an image on its axis 8 cm from the mirror. Determine…

Q: If an electron is subjected to a force of 10-25 N in an X-ray machine, then find out the time taken…

A: Here, we calculate the time taken by the electron to cover a distance as given follow;

Q: 6. Schematic diagram on how to use ammeter in a given circuit. 7. Schematic diagram on how to use…

A: Step1: Let us show how to use an ammeter in a circuit. An ammeter is connected in series with a…

Q: A uniform, 307.81-N rod is 11.65 n long carries a 257.98-N at its right end and an unknown weight W…

A: Given data: The weight of the rod is Wrod=307.81 N. The length of rod is L=11.65 cm. The weight on…

Q: The cell membrane is to be considered a thin layer enveloping a cell. In the static case, the…

A: Given: Charge distribution = σ = 2.5×10-6 C/m2

Q: The kinetic energy of an electron is 2.70 eV. What is its kinetic energy in joules?

A: The kinetic energy in joule is 4.32×10 ^-19 joule.

Q: A square coil of resistance 4 Ω, 50 turns and side length 5 cm is placed with its plane making an…

Q: 2. In order to take off, a 747 jetliner must reach a takeoff speed of approximately 95.0 m/s. If a…

A: Given: Initial speed,u=0 (as start from rest) Final speed, v=95.0 m/s Uniform acceleration, a=2.20…

Q: What is the focal length of the lens in your eye when you can focus on an object at your near point?…

A: u = -21 cm v = -(25-2) = -23 cm Since near point is 25 cm from eye

Q: Two infinite lines of current, one with current I = 1.5 A into the page and one with current I = 1.5…

Q: a on 3) A force of 300 N is applied across. 20kg box. The frictional force acting on the box is 200…

Q: 13 A 0.485 kg object connected to a light spring with a spring constant of 22.0 N/m oscillates on a…

Q: Direction: Draw a schematic diagram of the following:

Q: You open a restaurant and hope to entice customers by hanging out a sign. Cable Hinge GOOD EATS L…

A: Given data: The length of the beam is Lb=2.91 m. The mass of beam is mb=11.96 kg. The mass of sign…

Q: What is the cutoff frequency of light if the cathode in a photoelectric tube is made of iron? The…

Q: What is the total current if the total voltage is 180 V? R₁ 20 n ≥30~ 40 R2 R3 MWO

Q: A spring with original length of 35cm is pulled by a force 13N, stretching it to 38cm. Determine the…

Q: Problem Solving Directions: Read and analyze the given situation. Show your solution and box your…

Q: When a force F stretches a rope of mass per unit length p, the veloci wave in the rope is given by V…

A: Givenv=Fρwheremass per unit length ρ

Q: Earth has a mass of 6.0 x 1024 kg, a radius of 6.4 x 105 m, and an angular velocity of 1.2 x 105…

Q: You can handwritten but i wont upvote. The uniform horizontal beam supporting the sign is 1.39 m…

A: Given Data:- The length of the uniform horizontal beam b = 1.39 m The mass of the uniform…

Q: 1. When prescribing a corrective lens for a farsightedness, is it true that the larger the distance…

A: By lens formula P = 1/f = 1/v - 1/u If u is larger than power will be maximum

Q: the figure, two long straight wires are perpendicular to the page and separated by distance d₁ =…

Q: A uniform, 374.42-N rod is 10.63 n long carries a 203.39-N at its right end and an unknown weight W…

Q: A small metal sphere has a mass of 0.11 g and a charge of -21.0 nC. It is 10.0 cm directly above an…

Q: 9. A ball is thrown directly upward at a speed of 64 feet per second from a cliff that is 80 feet…

Q: What image is produced by placing an object 8 cm away from a convex lens of focal length 12 cm?

A: Given data :- distance between lens and the object u = 8 cm focal length of the lens f = 12 cm

Q: Consider electromagnetic waves propagating in air. Determine the frequency of a wave with a…

Q: Unpolarized light with an intensity of 100 W/m² passes through two polarizing filters that are…

A: If unpolarized light of intensity I0 passes through polarizer the intensity changes to I02. If…

Q: A proton is briefly accelerated in the direction of the arrow labeled å. At an observation location…

A: a1 = 1.8*10^17 * sin 68 = 1.66 *10^17 m/ s^2

Q: A stone of mass 0.4 kg is thrown vertically up ALE with a speed of 9.8 ms. Find the potential energy…

A: Given: The mass of the stone: m = 0.4 kg. The speed with which the stone is thrown vertically up: u…

Q: The time-averaged intensity of sunlight that is incident at the upper atmosphere of the earth is…

A: Correct option e. 1020 N/C

Q: Which wire will conduct electricity with lesser resistance? a. shorter in length b. larger…

Q: 6. An elevator is lifting two people at constant velocity from the first to the twentieth floor of…

Q: a lamp is moved from 30 cm to 90 cm above the pages of a book. Compare the illumination on the book…

A: Answer The distance of the book before the lamp is moved is given by The distance of the book after…

Q: An orienteer (a person who uses a map to find things) starts as point A, walks 300 meters North then…

Q: Two particles are fixed to an x axis: particle 1 of charge q₁ = 1.74 x 108 Catx=19.0 cm and particle…

A: Given q1= 1.74*10-8 C and X1= 19cm q2= -4.84*(1.74*10-8 ) C and X2= 67cm Aim : at what coordinate…

Q: In the figure R₁ = 4.560, R₂ = 13.70, and the ideal battery has emf & = 10.5 V. (a) What is the…

Q: An ancient club is found that contains 140 g of pure carbon and has an activity of 4 decays per…

A: Given Mass of carbon in ancient club = 140 gm Carbon activity = 4 decays /sec Living trees ratio of…

Q: A person lying on the bottom of a pool notices that he can see all of the above-water surroundings.…

A: Here we have to apply concept of total internal reflection That when light goes from denser to…

Q: Three capacitors with capacitances 4 µF, 8 μF, and 12 µF are connected in series. A voltage of 400 V…

Q: In a circus performance, a large 5.0 kg hoop of radius 3.0 m rolls without slipping. If the hoop is…

Q: How much work must be done to accelerate a baton from rest to an angular speed of 7.35 rad/s about…

A: Given angular speed =7.35 rad/s about its center baton to be a uniform rod of length = 0.517 m mass…

Q: A series circuit has an impedance of 61.0 2 and a power factor of 0.725 at a frequency of 53.0 Hz.…

Q: 17) In Ohm's law, where current= Voltage/ resistance, which variable are inversely proportional to…

A: Option (d) current and resistance .

Q: 45 V + 1 ΜΩ 1 Μ 3 μF

Q: re the wave patterns for various values of Awo and Ak same? If comment on the Phase velocity (Vp) of…

A: Given data:- 1) Are the wave patterns for various values of ∆w and ∆k the same? If not, why?2)…

Q: In an RL-circuit, the higher the value of the inductance the rate of change of the current stays the…

Q: A particle with charge q=1.4 mC moves 0.40 m along an equipotential surface of 10.0 V. How much work…

A: If a charge q moves under the influence of an electric field from one point to another point &…

Q: How much mass would need to be converted to energy in one hour to provide the sun with 1.378x10^30…

Concept explainers

First law of Thermodynamics

The word thermodynamics consists of two words: thermo- and dynamics. Dynamics means the study of motion. The field of thermodynamics is all about the study of the movement of heat. In a more meaningful way, it is stated as the study of the transfer of energy. Energy transfer is something that we encounter in day-to-day life. Automobiles, chemical reactions, refrigerators, and power generators work on the basis of thermodynamic principles.

Question

6) A sample of gas is compressed to one-third of its initial volume at a constant pressure of 1.25 × 105 Pa.
During the compression 100J of work is done on the gas. What is the final volume of the gas?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In a cylinder of an automobile engine, immediately after combustion the gas is confined to a volume of 50.0 cm3 and has an initial pressure of 3.00 106 Pa. The piston moves outward to a final volume of 300 cm3, and the gas expands without energy transfer by heat, (a) What is the final pressure of the gas? (b) How much work is done by the gas in expanding?
A hand—driven tire pump has a piston with a 2.50cm diameter and a maximum stroke of 30.0 cm. (a) How much work do you do in one stroke if the average gauge pressure is 2.40105N/m2 (about 35 psi)? (b) What average force do you exert on the piston, neglecting friction and gravitational force?
If a gas is compressed isothermally, which of the following statements is true? (a) Energy is transferred into the gas by heat. (b) No work is done on the gas. (c) The temperature of the gas increases. (d) The internal energy of the gas remains constant. (e) None of those statements is true.
A gas in a cylindrical closed container is adiabatically and quasi-statically expanded from a state A (3 MPa, 2 L) to a state B with volume of 6 L along the path 1.8pV= constant. (a) Plot the path in the pV plane. (b) Find the amount of work done by the gas and the change in the internal energy of the gas during the process.
When a gas undergoes a quasi-static isobaric change in volume from 10.0 to 2.0 L, 15 J of work from an external source are required. What is the pressure of the gas? `
(a) An ideal gas expands adiabatically from a volume of 2.0103 m3 to 2.5103 m3. If the initial pressure and temperature 5.0105 Pa and 300 K, respectively, what are the final pressure and temperature of the gas? Use =5/3 for the gas. (b) In an isothermal process, an ideal gas expands from a of 2.0103 m3 to 2.5103 m3. If the initial pressure and temperature were 5.0105 Pa and 300 K, respectively, what are the final pressure and temperature of the gas?
A gas expands from I to Fin Figure P20.58 (page 622). The energy added to the gas by heat is 418 J when the gas goes from I to F along the diagonal path, (a) What is the change in internal energy of the gas? (b) How much energy must be added to the gas by heat along the indirect path IAF?
A certain ideal gas has a molar specific heat of Cv = 72R. A 2.00-mol sample of the gas always starts at pressure 1.00 105 Pa and temperature 300 K. For each of the following processes, determine (a) the final pressure, (b) the final volume, (c) the final temperature, (d) the change in internal energy of the gas, (e) the energy added to the gas by heat, and (f) the work done on the gas. (i) The gas is heated at constant pressure to 400 K. (ii) The gas is heated at constant volume to 400 K. (iii) The gas is compressed at constant temperature to 1.20 105 Pa. (iv) The gas is compressed adiabatically to 1.20 105 Pa.
When a gas undergoes an adiabatic expansion, which of the following statements is true? (a) The temperature of the gas does not change. (b) No work is done by the gas. (c) No energy is transferred to the gas by heat. (d) The internal energy of the gas does not change. (e) The pressure increases.
Unreasonable Results (a) How many moles per cubic meter of an ideal gas are there at a pressure of 1.001014N/m2 and at 0C ? (b) What is unreasonable about this result? (c) Which premise or assumption is responsible?