53 Pour point define as. OA-Lowest temperature at which fuel will flow under cooling. OB-Lowest temperature at which fuel will flow under heating. 54 Sulphur content

Q: 2.) What is the value of Keq for the reaction CH4(g) + H₂O(g) CO(g) + 3H2(g)

A: Unknown: Keq = ? Assume:  Total Pressure = P At equilibrium, Mole fraction of CH4 = [CH4] Mole…

Q: A rectangular gate (length 3m, wide 1m) inclined at 50 with the horizontal level and hinged at point…

A:

Q: Q5) Explain the major and minor losses? Then solve for the parallel pipes system shown below, a pump…

A:

Q: Find the drop in pressure due to friction in a glazed porcelain pipe 300 m long and 150 mm diameter…

A: Given, Volumetric flow rate, Q = 0.05 m3/s Refer Moody's chart and explanation is given below

Q: Need the flow diagram and solution. A hot air drier is used to reduce the moisture content of 56…

A:

Q: A fuel consisting of 50% ethane and the balance propane is burned using 173% excess air. Complete…

A:

Q: 25- General formula of alkyne compounds are. O A CnH2n+2 OB - CnH2n-2 OC - CnH2n 26 - Methane…

A: Alkyne are compound which contains triple bond. General formula is CnH2n-2  From alkane remove 4…

Q: A rectification column is fed 100 kmol/h of a mixture of 50 mol% benzene and 50 mol% toluene at…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: Q3/A/ During AJM, the mass ratio is 0.75, Calculate mixing ratio, if the ratio of density of…

A:

Q: Gage pressure is measured relative to the atmosphere, whereas absolute pressure is measured relative…

A: Gauge pressure is may be positive or negative depends upon atmospheric Pressure. If the Pressure is…

Q: Three hundred gallons of a mixture (sg = 0.877) containing 75.0 wt% ethanol and 25.00% water and a…

A: GIVEN:  Mixture 1 Stream = M1 = 300 gallons = 2195 lbm Mixture 2 Stream = M2   Product Stream = M3

Q: Air at 41% relative humidity at 30C is cooled to 10C at a constant pressure of 100 kPa, For 41 m3 of…

A:

Q: Calculate the temperature at which a fog with droplet sizes of 300 nm in diameter will evaporate.…

A: Given Interfacial tension γ=72 mN/m Diameter d=300 nm Room temperature=25°C Enthalpy of evaporation…

Q: Calculate the enthalpy change of the products. H₂+ MgCl2 AH products =((-641.8) + 0 =

A: Enthalpy change of the product is to be calculated.

Q: Identify the maximum and minimum range of ATmin for the chemical plant and justify your answer with…

A: Consider two measuring points and make a temperature difference. This temperature difference is…

Q: The following table gives the numbr of milliliter (V) of nitrogen (reduced to 0 °C and 1 bar)…

A:

Q: In the two-tank mixing process shown in Figure below, x varies from 0 lb salt/ft3 to 1 lb salt/ft3…

A:

Q: Find Cau/ap CP-V-T). Show

A: We know that U=H-PV                        1by partially differentiateing this equation with respect…

Q: 150 moles of gaseous acetylene are stored in a rigid 15.5 L tank. The temperature is 160°C.…

A:

Q: The behaviour of fluid in motion is very complex due to the large :number of variables involved like…

A: Given: Behavior of fluid in motion is very complex due to the present of which variable? Select the…

Q: (Chemical Engineering Thermodynamics) Determine Z and V for steam at 250°C and 1800 kPa using A.…

A:

Q: 4.25 A rotational viscometer contains a fluid that gives a dial reading of 20 at a rotor speed of…

A:

Q: Find Cau/ap), in terms of measurable CP-V-T)- Show the mathematical derivation.

A: Ideal gas equation, PV= RT

Q: Sketch the cross flow induced-draft cooling tower and illustrate all its parts.

A: Induced draft cooling towers Induced draft cooling towers are of two types based on the nature of…

Q: 2. A plant discharges 4,000 gal/min of treated wastewater that contains 0.25 mg/L of PCB,…

A: Given, Discharge rate = 4000 gal/min

Q: What is the melting point of commercial sulfuric acid, in °C? Also cite your specific reference in…

A: Answer the following questions. Find the melting point of commercial sulfuric acid in C.

Q: Need the flow diagram A fuel consisting of 44% ethane and balance propane is burned using 163%…

A:

Q: Q3: The flowrate of a fluid in a pipe is measured using a pitot tube which gives a pressure…

A: Perform force balances for streamline flow in pipe:

Q: At 25 deg. API specific gravity, what is the heating value of oil in BTU/lb

A: Given, The temperature, T = 25 °C   Write the equation for specific gravity in terms of temperature…

Q: Q5) Explain the major and minor losses? Then solve for the parallel pipes system shown below, a pump…

A:

Q: In the fig. shown find discharge (Q). note that :Pwater = 1 kg/m3; Pmerciry = 13.6 kg/m3 D=150mm D =…

A:

Q: Q3:A) List the devises that used to measure the velocity, pressure, volume flow rate and sketch each…

A: We have to provide the sketch of the measuring device for velocity, pressure, and flow rates with…

Q: an Ideal gas is Compressed from 2m²³ OF lookig to 200kPa.. As a result of the process, the internal…

A: Given that for an ideal gas, Initial volume, V1= 2m3 Initial pressure, P1= 100 kPa Final pressure,…

Q: Consider a microfluidic Y-channel in which we have a co-flow of two aqueous suspensions as in the…

A: Given that- Channel width, w=300μm= 3.0×10-4m Channel height, h=100 μm=1.0×10-4m Average flow…

Q: Directions: Solve and show your solution. Write the interpretation of your answer. 1.) Consider the…

A: Given:  CH4(g) + H2O​(g)⇌CO​(g) + 3H2(g)

Q: A gas contains 75.0 wt% methane, 10.00 wt% ethane, 5.00 wt% ethylene, and the balance water.…

A: Given The gas have 75wt% of CH₄ 10wt% of C₂H₆ 5wt% of C₂H₄ Find Molar composition of gas on a wet…

Q: h) You are employed in an industrial bakery and are tasked with mixing a range of foods: i. Water…

A:

Q: In the figure shown, if an air film of 5-mm thickness is above the benzene, calculate the rate of…

A:

Q: Problem 1: A clean and dry core sample weighting 425 g was 100% saturated with 1.07 specific gravity…

A: Given, Specific gravity = 1.07

Q: One mole of dry gas is isometrically cooled from 707 to 315 K at an initial pressure of 5 bar. The…

A:

Q: A gas contains 55.0 wt% methane, 5.00 wt% ethane, 35.0 wt% ethylene, and the balance water.…

A:

Q: A step change of magnitude 3 is introduced into the transfer function 10 Y(s) X(s) 16s²+2s+0.5…

A:

Q: (a) If a countercurrent multiple contact process is adopted and 0.5 kg/s of the solution feed is…

A: Given, F=0.5 kg/s

Q: d. Give five benefits of changing colour/paint of the laboratories and auditoriums?  e. Explain in…

A: To answer subpart d and e , based on the original solution to related subparts a, b and c

Q: A gas contains 65.0 wt% methane, 5.00 wt% ethane, 20.0 wt% ethylene, and the balance water.…

A:

Q: Q3:A) List the devises that used to measure the velocity, pressure, volume flow rate and sketch each…

A: As per guidelines, one question can be answered only. Please repost the second question as a…

Q: Camper between Sorption and Surface tension

A: Sorption is basically combination of absorption and adsorption. Absorption phenomenon is used for…

Q: Derive the species transport equation in terms of the molar fraction to demonstrate the result doxa…

A: We are asked to derive the transport equation for the mole fraction of A in order to get the…

Q: The elementary reversible liquid phase reaction: A + B + 2C occurs in an isothermal mixed flow…

A:

Q: :/Find the following of the element (Mg 12). 1- Write the electronic arrangement for the element…

A: Given element is Magnesium (Mg) with atomic number 12. Since, Atomic number (Z)= number of protons=…