A 502 transmission line is terminated with a 502 resistor on series with a 2 * 10 H inductor. If thefrequency of the operation is 60 10° MHz find the reflection coefficient at the load.*Select one:O a. 0.36e56О .1O c.0.45e22O d. 0.6e 37Oe. 0

Answered: Image /qna-images/answer/c2dc379b-579f-494b-8a87-e1f89e185b9b.jpg

500 transmission line is terminated with a 500 resistor on series with a 2 * 10 H inductor. If the equency of the operation is 60 * 10° MHz find the reflection coefficient at the load. elect one: O a. 0.36e50 O b. 1 O c. 0.45e2 O d. 0.6e 37 O e. 0

500 transmission line is terminated with a 500 resistor on series with a 2 * 10 H inductor. If the equency of the operation is 60 * 10° MHz find the reflection coefficient at the load. elect one: O a. 0.36e50 O b. 1 O c. 0.45e2 O d. 0.6e 37 O e. 0

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The following lossless network is powered by a f=9 GHz microwave source. A matching circuit is…

Q: w is excited with a microwave source having frequency f=8 GHz. For the unknown dielectric…

Q: 11. The impedance on the Smith chart can be repeated for each half wavelength . length of the…

A: Lembda/2 line of the transmission line is called as impedance reflector because the value of…

Q: The following lossless network excited with the microwave source having f = 9 GHZ. if Zo=74 Q, 6,…

A: For lossless transmission line Characteristic Impedance is Zo Zo =√(L/C) Zo^2 = L/C L =…

Q: Since a 50 ohm transmission line with phase constant (π/10) rad/m will be used at 500 MHz, what is…

Q: The effective span of an antenna is 2.147 m2 at an operating frequency of 100MHz. The antenna has no…

Q: = R₁ = = 50 f. f = Q7. A source [V = 10020, Zg = Rg 100 MHz] is connected to a lossless transmission…

Q: Problem 1. A parallel-wire air-spaced transmis- sion line operating at 1910 Hz has a phase shift of…

A: Given a parallel wire air spaced transmission line operating at, Frequency, f = 1910 Hz Phase shift,…

Q: A station transmits with 50 Watts transmitter power and 6 dB antenna. A) What is the effective…

A: The solution is given below

Q: A dispersion transmission line is one which the wave velocity is not constant as a function of f.…

A: consider the given question;

Q: The following complex propagation constant equation γ=0.02+j20γ=0.02+j20 represents a transmission…

Q: Guestian!- A lossless dipole anteena with an Imput Impedance of 732 ís connected to ☺ a transmission…

A: Maximum gain of the antenna can be calculated as by using the formula, Gain=e×Do Here, 'e' is…

Q: 2.31 Plot the bounce diagram for the transient circuit shown in the accompanying figure. Include at…

Q: (a) A two wire transmission line has a capacitance of 50 pF/m and an inductance of 0.6 uH/m. What is…

Q: A transmission line having characteristic impedance 1202 is operating at 5000 * 105 rad/s, the line…

Q: A 100 MHz FM broadcast station uses a 300 2 transmission line between the transmitter and a…

Q: ) A 50 cm length 50 ohms coaxial cable is terminated with an antenna having an impedance of 100 +…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: At 29 MHz the characteristic impedance of a transmission line is (32- j2) ohm and the propagation…

A: Dear,as per company guidelines we can answer only one question at a time, kindly post other question…

Q: On a 150-2 lossless transmission line, the following observations were noted: distance of first…

A: The solution can be achieved as follows.

Q: The height of base station is 200 meter and operated at 2600MHz. The gain of the base station…

A: According to the question we have to find free space transmission loss and power received when the…

Q: A lossless transmission line has a characteristic impedance of Zo= 50 , a load impedance of ZR =…

A: In the above given question we need to calculate the value of reflection coefficient and input…

Q: Calculate the guided intrinsic impedance at 20 GHz for the lowest-order mode of the rectangular…

A: Qus→ Given rectangular waveguide a=0.7 in…

Q: 11. The impedance on the Smith chart can be repeated for each half wavelength * length of the…

A: From the Question The impedance on the Smith chart can be repeated for each half wavelength length…

Q: 4. A transmission line is terminated in its characteristic impedance as shown below. Explain what…

Q: A transmission line has characteristic impedance of 75 Ω and it is connected to receiver with…

A: According to the question we have to find the value of i. Reflection Coefficient; ii. VSWR

Q: 8. Assume a transmission line with Z = 75 – j25N and Zo = 502. Using the smith chart, find i) the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Q15/ What will happen if the carrier waves ? haven't been modulated

A: Given : Modulating signal: It is a message signal which is having low frequency component.…

Q: What is the required bandwidth according to the Carson's rule, when a 100 MHz carrier is modulated…

A: Given information: The frequency of the carrier signal is fc=100 MHz. The modulating frequency is…

Q: A 702 high-frequency lossless line is used at a frequency where 2 = 80cm with a load of 140+j91 2 a.…

Q: At a frequency of 4 MHz a parallel wire transmission line has the following parameters: R = 0.025…

Q: Show that in a transmission line terminated with a pure positive reactive charge, the magnitude of…

Q: If a transmission line of a characteristics impedance 50 Q is terminated with a load impedance of…

A: Given information: The value of the characteristic impedance of the transmission line is Z0=50 Ω The…

Q: Find out the general solution for a transmission line due to transient voltage,where ,e = f(x-at) +…

A: e = f(x-at) + F(x+at)

Q: The effect of rain attenuation at high frequencies is minimized if vertical polarization is used.…

A: The attenuation in the communication process which is caused by rain is known as rain attenuation…

Q: Calculate the guided intrinsic impedance at 20 GHz for the lowest-order mode of the rectangular…

A: Given rectangular waveguide, a = 0.7in b= 03in F=20 GHz=f Er= 2.76 η=? fc= cut off frequency =…

Q: 11. The impedance on the Smith chart can be repeated for each half wavelength length of the…

A: From the Question The impedance on the Smith chart can be repeated for each half wavelength length…

Q: Assume a transmission line with ZL = 85 + j45 Ω and Zo = 30 Ω. If the frequency of the line is…

A: According to the bartleby's guidelines we have to solve only first three subparts of a question so…

Q: An antenna with a radiation resistance of 48 ohms, a loss resistance of 2 ohms, and a reactance of…

A: antennae resistance 48 ohms loss resistance 2 ohms reactance 50 ohms voltage 10V IMPEDANCE 100 ohms

Q: A 500 transmission line is biased with a load with impedance ZL=100-j20on. Its wavelength is 12cm.…

Q: Find the skin depth at a frequency of 1.6 MHz in aluminum, where o=38.2×10° S/m and μ, = 1.

A: Given: Frequency, f=1.6 MHz. For aluminum the conductivity σ=38.2×106 S/m. And relative permeability…

Q: Q20. Choose the type of cable used to for short distance subscriber loop. Justify why this cable is…

Q: TE01IS 2GHZ calculate:- a) The dimension of the guide b) The cutoff frequency of three high c) The…

Q: Calculate the guided intrinsic impedance at 20 GHz for the lowest-order mode of the rectangular…

A: Given a = 0.7 inchb= 0.3 inchf=20 GHzεr=2.76 Here, a>b it means we take TE10 mode Calculating…

Q: An antenna with a radiation resistance of 48 ohms, a loss resistance of 2 ohms, and a reactance of…

Q: Question # 01: A piece of RG-59B/U Coaxial cable has a 950 characteristic impedance and a nominal…

A: Given data, Characteristic impedance, Z=95 Ω Nominal capacitance, C=89 pF/m Diameter of the inner…

Q: An antenna with a load impedance ZL = (100 + j40)Ω is connected to a transmitter Zg = Z0 through a…

A: we need to find out how much power can it deliver to the antenna?

Q: Antenna radiation U(theta,pfi) = sin(theta)cos(pfi) a) obtain directivity in dB. Is it a good…

A: a) The directivity (D) of an antenna can be defined as In this case, the antenna radiation is given…

Q: An antenna with a gain of 23 dB transmits 5 W of power at a frequency of 1 GHz. The transmitted wave…

Question

A 502 transmission line is terminated with a 502 resistor on series with a 2 * 10 H inductor. If the
frequency of the operation is 60 10° MHz find the reflection coefficient at the load.
*
Select one:
O a. 0.36e56
О .1
O c.0.45e22
O d. 0.6e 37
Oe. 0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

following Series for divergent Test the Condergent or (3n)!
7- DC Chopper with output voltage of 120V and input voltage of 80V and output power of 240W. Assume lossless chopper. The average inductance current IL is * 2.6 A 3.0A 4.3A
QUESTION 50 RG180B/U is a coaxial cable with a nominal impedance of 95 02 and a capacitance per foot of 15.5 pF/ foot. Determine the inductance per foot of this cable. O a. 140 nH/ft Ob.45 nH/ft O c. 95 nH/ft O d.250 nH/ft
An inductor is attached to an AC voltage source. Which change will result in a halving of the current?A. Halving the voltage and doubling the frequencyB. Doubling the frequencyC. Halving the frequencyD. Doubling the voltage and halving the frequency
phase The conductirs in a singke line are 6m above the guünd. gnünd. Each conductrs are spaced 3m a pant. Calculate the capacitance Capaci tance per milo, of the live if' bothe thu conductors radii s 75 mum. a.erdudlirg ground ef fet (ufvestal) b. mcluding gound effed.
draw a handdrawn clear picture of 34 conductors,17 slots ,4 poles wave winding .a computarized picture is given(the upper one)
2-A resultant current is made of two components: a 10 A D.C. component and a sinusoidal component of maximum value 14.14. The average value of the resultant current is amperes (a) 0 (b) 24.14 (c) 10 (d) 4.14 and r.m.s. value is - amperes (e) 10 (f) 14.14 (g) 24.14 (h) 100
Find the core diameter for a SMF in the 2nd window if ncore=1.48 & ncladd=1.478 ?
Calculate Is, IL, Iz and Pz.
A supply of 240V-50HZ feeds a highly inductive load of 502 through thyristor bridge that is half-controlled. What is the load power factor when the firing angle delay is 45°? A. 0.6565 B. 0.5566 C. 0.6655 D. 0.5656 1igatio
1. Use the Gram-Schmit procedure to obtain an orthogonal basis for the set of waveforms shown in Figure 1. 0.4T T. 0.4T 0.8T 0.6T
The current flowing throup h 2H induc toz ie おuen 6. 5 . Find expressi ans for the voeboge, expr-20t) A Sketch the wave forms powes, aud Slored energy. to seple for OL ta l00ms