50. A straight, stiff wire of length 1.00 m and T=0 T=0 mass 25 g is sus- pended in a magnetic field B = 0.75 T. The wire is connected to 1.00 m an emf. How much current must flow in the wire and in what direction so that the wire is sus- pended and the tension in the supporting wires is zero?

50. A straight, stiff wire of length 1.00 m and T=0 T=0 mass 25 g is sus- pended in a magnetic field B = 0.75 T. The wire is connected to 1.00 m an emf. How much current must flow in the wire and in what direction so that the wire is sus- pended and the tension in the supporting wires is zero?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The magnetic field inside an air-filled solenoid 40.0 cm long and 3.00 cm in diameter is 0.535 T . Approximately how much energy is stored in this field?
A piece of copper wire has a resistance per unit length of 4.63 × 10/m. The wire is wound into a thin, flat coil of many turns that has a radius of 0.208 m. The ends of the wire are connected to a 12.0-V battery. Find the magnetic field strength at the center of the coil. Number i Units >
Two long straight aluminum wires, each of diameter 0.40 mm, carry the same current but in opposite directions. They are suspended by 0.5-m-long strings as shown in the figure. If the suspension strings make an angle of 3.0° with the vertical and are hanging freely, what is the current in the wires? (density of aluminum = 2.7 g/cm³, g=9.80 m/s?) 60 Her birinin çapı 0,40 mm olan iki uzun alüminyum kablo eşit büyüklükte ama zit yönde akımlar taşımaktadırlar. Bu iki kablo 0,5 m uzunluğunda ipler ile askıda tutulurken iplerin düşey ile yaptığı açı 3,0° olmaktadır. Tellerdeki akım nedir? (alüminyum yoğunluğu= 2,7 g/cm³, g=9,80 m/s²) 0.5 m
1. A research group is investigating short-lived radioactive isotopes. They need to design a way to transport alpha-particles (helium nuclei) from where they are made to a place where they will collide with another material to form an isotope. The beam of alpha-particles (m=6.64×10−27kg, q=3.2×10−19C) bends through a 90-degree a region with a uniform magnetic field of 0.050 T (Figure 11.10) (a) In what direction should the magnetic field be applied? (b) How much time does it take the alpha-particles to traverse the uniform magnetic field region?
0.790 m and The figure below shows a loop of wire of radius r resistance R = 0.0200 $2 inside a region of spatially constant magnetic field with time dependent magnitude B net magnetic field at the center of the loop vanishes. = bt Find the time at which the S х A xx X + X XXX X X X X X X R XIXXXX + кхх X X X X X 1x XX X X X r X XBX X XXX х хххххх х X
5. A rectangular loop of wire (length L=13.0 cm and width W=7.80 cm) is moving as shown in the drawing with a speed of 1.00 m/s. The loop is leaving a region in which a 2.80 T magnetic field exists; the magnetic field outside this region is zero. During a time of 0.13 s, what is the magnitude of the change in the magnetic flux? Wb XXXX XXX XXXXXXXXX xxxxxxxxx xxxxxxxxx XXXXXXXXX XX
A cargo container, used as a trailer for a semi-truck, has a height of 2.14 m. The truck is being driven with a velocity of 28.6 m/s (East). The magnetic field in this region runs between (North) and (South). An emf of 0.895 V is induced between the top and bottom of the container, with the bottom being more positive. What is the magnitude and direction of the magnetic field the container is being driven through? Select one: O a. O b. O d. 1.46 x 10-2 T (North) 6.84 x 10¹ T North 1.46 x 10-2 T (South) 6.84 x 10¹ T South Clear my choice
You have a closed square loop of wire with length 44cm and a resistance of 750Ω. If there is a magnetic field of strength 0.2T going perpendicular through the loop at what rate (in T /s) does the magnetic field have to change in order to have a current of 0.2A through the loop?
5. A rectangular loop of wire (length L-13.0 cm and width W=7.80 cm) is moving as shown in the drawing with a speed of 1.00 m/s. The loop is leaving a region in which a 2.80 T magnetic field exists; the magnetic field outside this region is zero. During a time of 0.13 s, what is the magnitude of the change in the magnetic flux? X 0.0284Wb 109 33.269 80 F2 ост 11 Q F5 F5 XXXX XXXXXXX XXXXXXXXX XXXXXxxxxx XXXXXxxxx X: x x x x x xxxx XXXXXXXXX F6 tv MacBook Air & С F6 A AA F7 DII F8 V DII FB СС F9 A F9 Show my other submissions 9 F10 W . F10 d) F11 P 4 F11 F12
A piece of copper wire has a resistance per unit length of 8.70 x 10 o/m. The wire is wound into a thin, flat coil of many turns that has a radius of 0.146 m. The ends of the wire are connected to a 12.0-V battery. Find the magnetic field strength at the center of the coil. Number Units
A conducting bar moves with a speed v= 10.2 m/s along parallel frictionless conducting rails connected on one end by a resistor R=2.50. A uniform 0.65 T magnetic field is directed out of the page. What is the current (in A) in the resistor? Bout R Select one: O A. 1.19 B. 1.60 Ос. 1.03 OD. 0.79 OE. 1.44 45 cm
8. In the figure below find the current flowing through section P Q. P Q has length a = 65 cm and 8is part of a conducting wire frame ABCD that is inside a spatially uniform magnetic field that isalways pointing into the page. The magnitude of the magnetic field varies with time according tothe expression B = (1.0×10−3 T/s)t. Assume the resistance per unit length of the wire is 0.10 Ω/m.