50 KPa is equivalent to: OA 5x 10°6 N/m^2 ) B) 5 x 10^5 N/m^2 O95x 10°3 N/m^2 O D) 5x 10^4 N/m^2 Concrete is required for a plain concrete pavement to be constructed in Southern Alberta. The pavement will be exposed to freezing, thawing, and deicers. If aggregates with a nominal maximum size of 20 mm are used, what is the minimum cement content per cubic meter of concrete as per the CSA Standard? OA) 320 kg B) 335 kg OO 390 kg OD) 420 kg During Lab 5, the relative density of a coarse aggregate sample was determined. The sample of coarse aggregate was towel dryed to represent this moisture state: OA OD B) Wet OO SSD ODI Air Dry When performing the slump test, each layer of concrete is rodded times as per CSA specifications:

50 KPa is equivalent to: OA 5x 10°6 N/m^2 ) B) 5 x 10^5 N/m^2 O95x 10°3 N/m^2 O D) 5x 10^4 N/m^2 Concrete is required for a plain concrete pavement to be constructed in Southern Alberta. The pavement will be exposed to freezing, thawing, and deicers. If aggregates with a nominal maximum size of 20 mm are used, what is the minimum cement content per cubic meter of concrete as per the CSA Standard? OA) 320 kg B) 335 kg OO 390 kg OD) 420 kg During Lab 5, the relative density of a coarse aggregate sample was determined. The sample of coarse aggregate was towel dryed to represent this moisture state: OA OD B) Wet OO SSD ODI Air Dry When performing the slump test, each layer of concrete is rodded times as per CSA specifications:

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The following figure shows concrete pavement with the layer thickness and elastic modulus as indicated. Assume modulus of rupture of 650 psi, load transfer coefficient of 3.2, serviceability loss from 4.5 to 2.5, and drainage coefficient of 0.9. The bedrock depth and loss of support is not considered for the subgrade. Use the design equation or monograph with 50% reliability to solve the following: 1) Determine the number of ESAL that the pavement can carry before failure. 2) If the daily traffic has 1080 single axles (20-kip), 400 single axles (24-kip), and 680 tandem axles (40-kip), and the annul traffic is the same over the design period, how many years would the concrete pavement last before failure? 8-inch Portland Cement Concrete Ec=4×106 psi 8-inch Granular Subbase Ec=30,000 psi Subgrade Mr = 5000 psi
A rigid pavement is designed with an 11-inch slab thickness, 90% Rellability (ZR = -1.282), Es = 4 million psi, modulus of rupture of 600 psi, modulus of subgrade reaction of 150 lb/in?, a 2.8 load transfer coefficient, initial PSI = 4.8, final PSI of 2.5, overall standard deviation of 0.35, and a drainage coefficient of 0.80. The pavement has a 20-year design life. The pavement has three lanes in one direction (PDL = 0.80) and is conservatively designed for trucks that have one 20,000-lb single axle load (1.58), one 26,000-lb tandem axle (0.619), and one 34,000-b triple axle (0.593). What is the daily estimated truck traffic on the three lanes? logia (APSI) S,C¢(D@7% – 1.132) 3.0 [1.62410x10 |(D + 1)*46 | log10 (W) = Zg5, + 7.35 (log,0( D + 1)) – 0.06 +: +(4.22 - 0.327SI) log10 1+ 18.42 215.63/ De75 - 0.25
2. You are asked to design a new flexible pavement structure for an existing road that will be totally replaced. You are provided with the following borehole results: a) Existing (Old) HMA - 135 mm b) Existing (Old) Granular A Base - 170 mm c) Existing (Old) Granular B Subbase - 340 mm d) Gravelly Silty Sand (Till) Subgrade (25 % 5-75 um) What is the current GBE for the existing pavement structure? What is the GBE for the same pavement structure when it was newly constructed?
1. During the AASHO road test, ONLY flexible pavements were constructed and tested.a. Trueb. False2. The AASHO present serviceability rating (PSR) was considered an objective quantity used to establish the performance of highway pavement in terms of applied traffic.a. Trueb. False3. The AASHTO present serviceability index (PSI) correlates the PSR to actual pavement performance in terms of applied traffic, and select distresses.a. Trueb. False4. There is only one AASHTO PSI equation that applies to both flexible and rigid pavements.a. Trueb. False5. The AASHTO PSI scale ranges from:a. 0-5b. 0-10c. 0-100d. None of the above
The data given below pertain to the design of a flexible pavement. Initial trafic = 1213 cvpd Traffic growth rate = 8 percent per annum Design life = 12 years Vehicle damage factor = 2.5 Distribution factor = 1.0 The design traffic in terms of million standard axles (msa) to be catered would be
Overall standard deviation, S, Design serviceability loss, APSI 10 5.0 99.9 0.2 99 1.0 0.4 0.5 0.6 90 0.5 0.1 0.05 1.5 2.0 80 70 2.5 60 3.0 50 9 87 65 4 6.5 5.5 4.5 3.5 2 1 Eхample: 2.5 1.5 W18 = 5 x 106 Design structural number, SN R = 95% S, = 0.35 M = 5000 Ib/in² APSI = 1.9 Solution: SN = 5.0
Need asap really need it thank you
3- What is meant by JRCP in rigid pavements? Explain its characteristics.
B. A rigid pavement with a 10-inch slab thickness, 90 percent reliability, E. = 4 million lb/in², 600 lb/in² modulus of rupture, 150 lb/in³ modulus of subgrade reaction, a 2.8 load transfer coefficient, initial PSI of 4.8, final PSI of 2.5, overall standard deviation of 0.35, and a drainage coefficient of 0.8 is designed. The pavement's design life is 20 years. The three-lane road is built for vehicles with one 20,000-pound single axle, one 26,000-pound tandem axle, and one 34,000-pound triple axle. Calculate the projected daily truck traffic on the three lanes.
A six-lane concrete roadway is being designed for a metropolitan area. This roadway will be constructed on a subgrade with an effective modulus of subgrade reactionk of 170 Ib/in^3. The ESAL used for the design period is 6.9* 10^6. Using the AASHTO design method, determine a suitable thickness of the concrete pavement (to the nearest 12 inch). provided that the working stress of the concrete to be used is 650 lb/in2 and the modulus of elasticity is 5 *10^6 Ib/in^2. Assume the initial serviceability is 4.75 and the terminal serviceability is 2,5. Assume the overall standard deviation, So, as 0.35, the load transfer coefficient J as 3.2. the drainage coefficient. Cd as 1.15. and R as 95%. Answer: