50 hz. current of 2 A flows in a circuit consisting of an adjustable resistor and a 56.6 uF capacitor in series. Determine the value to which resistor should be adjusted for the voltage across the capacitor to be 0.75 the voltage across the circuit.

Q: pomts Save Ans For the following circuit, if Rf 10K2, R1= 2KQ, R2= 1K, R3= 1KQ, find the output volt...

A:

Q: With the aid of diagram discuss the importance of the Fermi Energy level, especially its relevance t...

A: The valence band and conduction band are the bands nearest to the Fermi level in solid-state physics...

Q: In the figure shown, the voltage at y is equal to

A:

Q: f a logic circuit is operated within the noise margin limits, then the output can be A) Assumed to b...

A:

Q: A 4600 to 230 Volts, 60 Hz step down

A:

Q: Find the Laplace impedance of a series parallel circuit where 2Ω resistor is in series with the para...

A: It is given that: R=2 ΩL=2 HC=0.5 F    

Q: Please answer the following: a) What is the resistance in the circuit? b) What is the reading in m...

A: In this question potentiometer is given....We have to find out it's total resistance and current flo...

Q: (Ъ) An ammeter shown in Figure Q.1b(i) with full scale current of PMMC is 100 µA and internal resist...

A: The solution is given below 

Q: Calculate the average output voltage of the circuit shown. Vo = volts 10 V 2 ΚΩ 0. 2 k2 2k2

A: Full wave rectifier- A circuit which converts alternating current into DC with the help of diodes.

Q: 4.5 A 60HZ, 120/24 V, single-phase transformer has 300 turns in its primary winding, determine the f...

A:

Q: 5Ω α 50 V 20 Ω (+ 1)

A:   The solution is given below 

Q: Given the inputs A,B,C and D please make a truth table for the outputs at points F,G and H (а) U8 A:...

A: Since you have posted the multiple questions so we are supposed to answer the 1st question. a) 

Q: 16. Calculate the output voltage, Vo, in the circuit of Fig. 14.55. 100 ka V -01 V. 20 ka 400 ka 10 ...

A: This question belongs to analog electronics . It is related to operational amplifier . It is based o...

Q: R = 3.3 kn R3 = 3.3 kn + Vs - Rs = 2.2 kN E 20 V R2 = 2.2 kn R = 1.2 kN FIG. 14.4 Using any one of t...

A: Since it is unbalanced bridge  The current and voltage can be found using the thevinins equivalent c...

Q: An input sawtooth waveform with a voltage of 20Vpk-pk at the origin has its negative cycle clipped a...

A: Please refer the attached images for the complete answer..

Q: (c) Figure Q5(c) shows a without and with guard circuit of a Megger insulation resistance instrument...

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any s...

Q: In order to keep 10 gram current carrying conductor with 40 cm length suspended inside a magnetic fi...

A:

Q: Fill in the bianks / Tdentim volts Given the circuit below, calculate the voltage drop across R1 whe...

A:

Q: 4.6 A 60 Hz, 75 kVA, 2400/240 V, single-phase transformer is used to step down the voltage of a dist...

A:

Q: The number of secondary turns required is: 1200 turns 120 turns |12 turns 120.5 turns

A:

Q: A shunt DC generator has no load terminal voltage of 140V. Armature resistance is 1ohm and shunt fie...

A:

Q: ) A current of 250mA flows through a perfect inductor, when it is connected to a 5V, 1kHz supply. D...

A:  Disclaimer:  Since you have asked multiple questions, we will solve the first question for you. If ...

Q: Find the capacitance (nF) of a 14 cm diameter sensor immersed in oil if the plates are separated by ...

A: Please refer the attached images for the complete answer..

Q: PCF of the station

A: Plant capacity Factor- Plant capacity factor is defined as the ratio of produced amount of electrici...

Q: 8. A 15.9-µF capacitor and a 15.1-mH inductor are connected in parallel. In series with these units ...

A:

Q: Problem 4. Let the components of the vector x = [r1,., Ta]' be binary-valued (0 or 1), with d odd, a...

A:

Q: 12.43 Find f(t) for each of the following functions. 135 a) F(s) : s(s + 3)*" 10(s + 2)2 b) (s) (2 +...

A:   a) F(s) = 135s (s+3)2      There are no zeros     Poles are s = 0 and s= -3 (its a double pole)   ...

Q: An SSB system requires 100 W transmitted power for reliable transmission. How much power is needed i...

A:

Q: what are the draw back of using DTOC relays for the protection of long feeders?

A: Relay: The main work of relay is used to detect the fault and send the signal to the circuit breaker...

Q: Salme using Si Thom. 3 12 오 TRiv.

A:

Q: D Question 6 For the sine wave shown below determine the RMS voltage. The Horizontal scale "time bas...

A:

Q: Evaluate these complex numbers: (a) [(5 + j2)(-1 + j4) – 5/60°J* 10 + j5 + 3/40° (b) + 10/30° + j5 -...

A:

Q: 15. a. Find the Thévenin equivalent circuit for the portions of the network of Fig. 9.139 O external...

A: Brief description : In case of electrical circuits any complex circuit can be reduced into simplifie...

Q: In the circuit in the figure, the apparent power (S) of the second arm is given as 1490 VA. Accordin...

A:

Q: 5. When connected to a 12V battery, a 160mH inductor draws 200mA of current. When connected to a 120...

A:

Q: (c) Two (2) ideal voltage sources, V1 and V2 are connected together by a line impedance, Z. (i) Draw...

A: C)(I) To draw the circuit  Ii)to find the Real and reactive power supplied by each source  iii) Dete...

Q: 1. A transistor circuit can be modeled by the following circuit. 0.82 KQ 20 KO +) 7.5 V 39is 0.6 V i...

A:

Q: (b) Figure Q1(b) shows a transistor voltmeter with the following parameters: Vcc = 12 V; Rm =2 k2; I...

A:

Q: tain the trigonometric Fourier series representation of f(t).

A:

Q: Briefly explain TWO (2) disadvantages of low power factor.

A: Power factor angle (φ) is the angle between the voltage (V) and the current (I)

Q: R V + (+1)

A: Given

Q: A balanced Y-connected source is connected to a A-connected balanced load. The phase voltage of the ...

A:

Q: For the circuit below, z, = 2 + j2 N, Z, = 4 – j3 N, Z, j10 N, and z, , and (b) the current in Z3 an...

A: The solution is given below 

Q: 892 + 37s + 32 а) F) (s + 1)(s + 2)(s + 4)' 8s3 + 89s2 + 311s + 300 b) F(s) s(s + 2){s2 + 8s + 1.5) ...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: Before testing the electroscope, the foil strip is positively charged. 1. 2. Before testing the elec...

A:

Q: The regulation of a 250 volt shunt generator is 6 percent. Calculate the no load voltage.

A: GivenFull load volatge=250 vPercentage of regulation=6%

Q: Design a differentiator to have a time constant of 10-2s and an input capacitance of 0.01µF. What is...

A: Given,Time constant τ=RC=10-2sand C=0.01μFSo,R=τC=10-20.01×10-6R=1MΩ      

Q: For the figure below: Find the range of K to keep the system stable. Also, determine the value of K ...

A: The solution is given below 

Q: (a) Answer the following questions. (i) Explain briefly the main funetion of a power transformer in ...

A:

Q: Find the time constant for the RC circuit in Fig.

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit....

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.