+5.0 V +5.0 V +5.0 V 1.0 k2 7447A Vcc R's=330 2 a lo Anode a O Lamp test O BI/RBO ORBI Dip Switch D. B, Output do le f e o MSB I LSB g D FND1056AR CBCD 7-Segment B Input Display GND $330 2 $330 2 $3302 $3302 O O B A

QUESTION 25 When a circuit symbol has no bubble and there is no line above the signal name, the line is said to be Active-LOW Inactive-HIGH Active-HIGH None of the above.

please type so that i can read it

Logic circuit Multiplexer In this question I used same question for two different cell scheme types First one I used up to down cell scheme like 0 4. 12 8 1. 5. 13. 9 3. 7. 15. 11 2 8. 14. 10 Function is €m(0,5,6,8,9,10,14) I got in the letter below I0=B’ Means B complement I1=A’B+AB’ I2=A+B I3= 0 But second k map cell scheme I used like this right to left for the same function 0. 1. 3. 2 4. 5. 7. 6 12. 13. 15. 14 8. 9. 11. 10 But I got different answers for the same function I0=A’B’. I1=A’B+AB’ I2=AB’. I3 = A’+B’ Only i1 I got the same but isn’t which ever cell scheme you use the answer shouldn’t be different right or I do it wrong please look the picture carefully give brief explanation where did I understand wrong

For the device shown below: If the enable signal /EN (ENbar) is HIGH or (inactive) D So S1. EN O ALL outputs will be HIGH Except /YO (YObar) All the outputs will be HIGH All output will be HIGH except/Y3 (Y3bar) All the outputs will be LOW

Use the schematic for our board to select the input signals on the I/O Memory selection hardware that are used to generate the ROMRD signal on our board WR ROMSEL O READY O WR 10/M O RD O O O O O

What is NEC and what is the purpose of it? Does it present the maximum standard or the minimum?

I need help solving this question