I need handwritten and correct don't copy only handwritten otherwise dislike 5. The bracket shownin the figure is boltedwith 5-20 mm diabolts. It carries anPu35 kN150250eccentric load of P=35 kN. Using elasticmethod of analysis.a. Compute the100100location of thecentroid of the groupof bolts measured tothe left of A andbelow that of A.b. Compute the shearing stress of bolt A and B.

Answered: Image /qna-images/answer/4e8032ea-db01-43e4-b44e-8ace1bdeba3d.jpg

5. The bracket shown in the figure is bolted with 5-20 mm dia bolts. It carries an P35 KN 150 250 mm eccentric load of P: 35 kN. Using elastic method of analysis. a. Compute the location of the centroid of the group of bolts measured to the left of A and 100 10 below that of A. b. Compute the shearing stress of bolt A and B.

5. The bracket shown in the figure is bolted with 5-20 mm dia bolts. It carries an P35 KN 150 250 mm eccentric load of P: 35 kN. Using elastic method of analysis. a. Compute the location of the centroid of the group of bolts measured to the left of A and 100 10 below that of A. b. Compute the shearing stress of bolt A and B.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Moving to another question will save this response. Quèstion 4 Which of the following is correct for the 'calipers' used in fitting shop? A. An outside caliper can be used to measure the diameter of a hole D. Neither A nor B is correct C. Both A and B are correct B.A caliper alone is sufficient to measure the dimension of a given part, no other additional tools are necessary A Moving to another question will save this response.
Show all working explaining detailly each step.
The test conducted by a scan tool can also be tested by some
How to draw 4/5 × 2/3 on a model
I need these 3 parts answered TRUE or FALSE.
Which statement is true in the case of the term "Range". The minimum and maximum values the instrument is designed to measure Is closely related to accuracy and output reading of an instrument is linearly proportional to the quantity being measured. Is not related to accuracy and define the maximum error of the measuring instrument during measurement process. Is closely related to accuracy and define the minimum and maximum values an instrument is designed to measure.
Provide the appropriate datum feature symbols and datum features in the feature control frames on the drawing
When several measured values are close to the standard or accepted value, the values are said to be precise accurate neither accurate nor precise both accurate and precise
The term "maintenance" refers to maintaining all of the systems and features in working order. * as close as possible to the original O design purpose of the manufacturer tons as close to the manufacturer's original design purpose as impossible as impossible to the manufacturers original design intent tons. as possible to the manufacturers unoriginal design intent tons skip Punctures are- a small hole in a tire resulting in an get- away of air a large hole in a tire resulting in an get- away of air a small hole in an engine resulting in an escape of air a small hole in a tire resulting in an get- away of oil Skip
the principle orthographic views
Vernier Caliper with 50 divisions (lines) on the vernier scale, then the least count is
in autocad typing clip does what?