Answer the following problems in a short/long bond paper size. Round off your answer up to 2decimals, if applicable. Show your complete solution and box your final answer.You may not copy the problem.Twewattoneters ere propeNA3-phase loa necgobtained stteerersin stionsOtte eurrent.cted to meaeEtotal.nowerhe iof the loaddanctionntaTakesa line uentof A when operating atrateu out-iinecu toa 60drawnSalancent delta-connécte .discomeciea wattmetereer4IRINNby the foasthe load per ehe122Wlihelencorrectheluy. ind the reaciance per puas:Of the eapaCItO Ik.5. It is required to raise the power factor of a 750 kW balanced 3-phase load from 0.70lagging to 0.90 lagging. The line voltage is 6.9 kV, 60 Hz. Find the capacitance perphase required for wye-connected capacitor bank.

Answered: Image /qna-images/answer/1e2cfbcb-1f77-4c40-8c0a-6c8566a586b7.jpg

5. It is required to raise the power factor of a 750 kW balanced 3-phase load from 0.70 lagging to 0.90 lagging. The line voltage is 6.9 kV, 60 Hz. Find the capacitance per phase required for wye-connected capacitor bank.

5. It is required to raise the power factor of a 750 kW balanced 3-phase load from 0.70 lagging to 0.90 lagging. The line voltage is 6.9 kV, 60 Hz. Find the capacitance per phase required for wye-connected capacitor bank.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Desian aproblem for wye delta transform adions Determinc the eauivalend resistance between the terminals A andA B.
In a balanced tephasic system Y - Delta of the figure. Find the line current IL and the average and supplied power to the load
Electrical load that draws current whose impedance varies throughout the cycle of the input ac voltage waveform is known as nonlinear load. True False
A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. A Capacitor bank of a capacitive reactance of 120 ohms is connected in parallel to the load. The power factor at the load is: O A. 0.447 lagging O B. 0.707 leading O C. 0.447 leading O D. 0.707 lagging O E. None of choices are correct
The phase voltages across a certain load are given as: Va = 176 – j132 volts Vb = -128 - j96 volts Vc = -160 + j100 volts Va1 = 163.24-j35.10 / 166.97L-12.135 Va2 = 50.1-j53.9 / 73.59L-47.09 Va0 = -37.34-j42.67 / 56.70L-131.19 Compute for positive, negative, and zero sequence components of voltage.
Given: 1. 2 wye-connected loads per phase to a 3 phase power source 2. first load consists of a 55ohm resistance and a 0.05H inductance per phase 3. second load consumes 1kW and power factor of 0.7 lagging per phase 4. RMS of voltage across the loads are 220V, frequency 120Hz per phase 5. single phase equivalent is shown in the figure: Question: What are the RMS line current at load 1 and 2 respectively?
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020º, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.3322-120° A (C) 0.9962-120º A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta. j20 j3n Za j20 ZA j30 j3n -j20 j 30 -j20 Zo -j20 ZE j30 -j2n j 3n. ZF Assume the generator is star-connected with neutral, calculate total system power, total power factor, and current in neutral.
Impedances Z1 = 5.83 at angle of -59 deg. and Z2 = 8.94 at an angle of 63.43 deg. are in series and carry an effective current of 5A. Determine the Power and power factor of the circuit indicating if it is leading or lagging.
Q4 a) A three-phase system has a rms phase voltage of 6.3 kV. What is the line voltage?
Please Answer My Questions in 30 minutes i'm very needed... Please thank u...
2. For the following system shown in the figure, calculate: a. The current through each phase of the load. b. The total real and reactive power of the three-phase load. c. The power factor at the load side. A 220 V 20° 220VL-120° U8 vol 152 I 220 VI20° 9. M.