5. For the below system, find the following: a). What is the system type? b). What is the appropriate static error constant? c). What is the input waveform to yield a constant error? d). What is the steady-state error for the a unit input in part c)? e). Validate your answer for part d). R(s) 10(s + 10) C(s) s(s + 2) (s + 1)

Hi I seem to be getting this wrong I have drawn this and submitted it but it says incorrect so I just really needed help on how to draw it the correct way Thanks!

I want to buy a two METAL SPUR GEAR for my 2 pieces of G.I pipe with an 3 inches diameter (3mm thick) for my Roller. I want the hole of spur gear=1 inch diameter. Determine the specifications of spur gears and what I need to buy spur gear size in market show their model of metal spur gear.

Two shafts 12 feet between centers carry pulleys 4 feet and 3 feet in diameter respectively, connected by a crossed belt. It is desired to put the belt on as an open belt. How long a piece must be cut out of it? Please Show a clear and detailed solution (with illustration). Thank you!

The main shaft of an engine that drives the rice mill line shaft drives a 24 inches flat pulley on a crossed drive assembly. The main shaft pulley has a diameter of 6 inches. The distance between pulleys measured from the center of the shaft is 20 ft. What would be the length of the flat belt, in ft, needed for the drive. Add 1 ft from the computed belt length for splicing purposes.

4.41 in.8.82 in.14 in.22.82 in.

What firce is requure to punch off 5 mm hole out of a 4 mm thick plate if the ultimate punching stress is 200 MPa ?

Draw a circular hole of 2cm deep and give dimensions to it.

thank you can u plz solve f&g now

2) A washer is going to be manufactured by cutting operation out of 2024ST aluminum alloy sheet that has a thickness of 2.5 mm. The outside diameter of the washer is 25.0 mm, and the inside diameter is 12.0 mm. Make a rough sketch, define the geometries to be used and determine a. The punch and die size for the blanking operation b. The punch and die size for the punching operation c. The force required performing the blanking and punching operation simultaneously. The aluminum has a tensile strength = 300 MPa.