point) A constant electric field of magnitude 1. 39 x 10' N/C is crossing a 175 cm² circular area and making an angle of 0-66 with its surface. The electric flux passing through the circular area is equal to -9.87 x 10¹ Vm 0-22.2 Vm 04-9.87 V.m 0 2.22 x 10³ V.m

point) A constant electric field of magnitude 1. 39 x 10' N/C is crossing a 175 cm² circular area and making an angle of 0-66 with its surface. The electric flux passing through the circular area is equal to -9.87 x 10¹ Vm 0-22.2 Vm 04-9.87 V.m 0 2.22 x 10³ V.m

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Answer in 4 sentences only. 4. What happens to current when resistance is increased? 4

A: We need to tell about the effect of resistance on current .

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

A: We need to find out the value of unknown resistor and capacitor for given circuit .

Q: A 3 kW, 315 V DC series motor is being supplied by a feeder with total resistance of 0.02 ohms and…

A: In this question, We need to determine the armature voltage of the DC series motor. If total…

Q: What is the value of a capacitor that can store two coulombs of charge when 500 volts is applied…

A: Given: Charge stored by capacitor, Q=2 C. Applied voltage, V=500 V.

Q: Answer in 4 sentences only. 3. Why should you not hold the resistor while measuring its resistance?

A: We should not hold the resistor will measuring its resistance.

Q: Question 4 Evaluate the following Inverse Laplace transforms. 1 2-1 C-₁ (72+36 +2)

A: Laplace transforms and inverse Laplace transforms are powerful tools for solving inhomogeneous…

Q: From the circuit below, Calculate A. Frequency of Oscillation B. Period of Oscillation

A: The circuit diagram is shown below,

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

Q: In a short bond paper, prepare the winding table for a four pole dynamo with 24 slots and 24…

A: For electric machinery, lap winding is a type of two-layer winding in which every coil is wired in…

Q: Three zones of a single-phase circuit are identified in the figure. The zones are connected by…

A: Transmission lines transport electric energy inside an electric power system from one place to…

Q: 3. An AM transmitter is rated 100 Wat 100% modulation. How much power is required for the carrier?

A: Given: An AM transmitter is rated at, Total power, PT=100 W. Modulation index, μ=100%=1.

Q: Simplify the block diagram below and determine: G(s) = R(s) G₁ H₁ H₂ G₁ G₂ C(s)

Q: What is the fire delay angle of the TRIAC if the device will trigger at +24 and -24 V break- over…

A: It is given that:

Q: Determine Vo2 11.3 V 0.3 V 0.7 V 11 V

A: In this question, We need to choose the correct option What is voltage across the Ge diode. If…

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistanc to be used is…

Q: I can't understand the solution pls fix it

A: It is given that: V=110 VIL=100 ARsh=55 ΩConstant losses=500 WFull load efficiency=0.88

Q: A large residence consumes 1155 kWh of electrical energy over a billing period. Determine the total…

A: Given: Service charge=ℙ345 Energy chargeGovernment Taxes= 10.3% of total bill amountGeneration…

Q: 3. Determine all the mesh currents using mesh analysis. Show simplified equations and complete…

Q: In the network in Fig. V, is known to be 8/45° V. Compute Vs. S

Q: 2. Create the simplified Relay logic of the expression below. F =…

Q: O-A 400 V. 15 kW, 4 pole, 50 Hz, Y-connected induction motor has full load slip of 4%. The output…

Q: Find v and i. 14 V(+ Μ 4Ω 3Ω +:ι 6V 2Ω ww 6Ω Answer: -400 mV, 2.8 A.

Q: In a common emitter amplifier. Assume that the coupling capacitor in the collector is shorted. What…

Q: The electric energy stored in a 20 nF capacitor charged by a 96.7 V battery is

A: Given: The capacitance is, C=20 nF. Capacitor is charge to voltage, V=96.7 V.

Q: - Three phase induction motor has rating of 50 kW, 960 rpm, 400 V. 50 Hz, 6-pole. The motor…

A: The polarity of the back EMF and armature voltage is not the opposite. As a result, the armature…

Q: If you used 600 W of power for 60 h, you have used A. 36 kWh B. 3.6 kWh C. D. 1 kWh 10 kWh

A: Given: The power used, P=600 W. Time, t=60 h.

Q: Two loads are connected in parallel to a source of emf whose voltage is (110 + j63.5). if the branch…

A: Given information are: Source emf, VS=110+j63.5V Current in load 1, I1=8-j8A Current in load 2,…

Q: Determine the over-all transmittance of the signal flow graph shown below.

Q: 03: For class AB amplifier the R.M.S. input voltage is 11V and the supply voltage is +20V and the…

A: Given input voltage VRMS=11V supply voltage or biasing voltage Vcc=±20 V Load resistance RL=8 Ω…

Q: Evaluate the following: for at bl 8 ut b(t2-1) 8 (t-a) dr with a=3 and b=3

Q: Let (-1), (3-). (3+) and (-1+) be the vertices of rectangle C in the complex plane. Assuming that C…

Q: 6. Draw the Wheatstone bridge circuit diagram and explain how it can be used to measure an unknown…

Q: For class AB amplifier the R.M.S. input voltage is IIV and the supply voltage is ±20V and the load…

Q: Consider the following assembly language program. MVI B,87H MOV A,B START: JMP NEXT MVI B,00H XRA B…

A: Solution is priortize in 8085

Q: A short shunt compound generator has the following armature, series field and shunt field…

Q: 10. There are two alternators, 100kW, 3-phase in parallel are driven by shunt motors whose…

Q: 4. The two wattmeter readings for a three-phase balanced load are 175 W and -35 W. Knowing that the…

A: Given, In power measurement using two wattmeter method in a three phase balanced load, the readings…

Q: Design common-base configuration circuit. IE= 1.3 mA and Av= 250.

A: Given: IE=1.3 mAAv=250 To find: Design a common-base configuration circuit.

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

Q: The content must be the connection of resistor color codes to tolerances and the relationship of the…

A: According to the question, for the given resistor color code and measurements as shown below, We…

Q: Write the corresponding differential equation for the system shown

A: Given- 1. Gain of the open loop system- Gs=s5+2s4+4s3+s2+3s6+7s5+3s4+2s3+s2+3 2. Transfer function-…

Q: P 3.4-4. Determine the current i in the circuit shown in Figure Figure P 3.4-4 6 A 16 Q2 www www 89.…

Q: Answer in 4 sentences only. 2. How does a multi-meter measure resistance?

A: Multi-meter: Multi-meter is a measuring instrument. It is used to measure various electrical…

Q: 1. Determine the Total Current and currents passing through each of the resistance. Also, determine…

Q: 8.12 Find the impedance, Z, shown in Fig. of 400 Hz. Z 10 mH m 102 252 ww 10 μF at a frequency

A: Given, Frequency F= 400Hz Inductance L = 10mH Cpacitance C= 10μF

Q: The maximum efficiency of a 100 kVA, 1100/440 V 50 Hz transformer is 96%. This occurs at 75% of full…

A: Given- Maximum efficiency, η=0.96 , Voltage = 100 kVA , Frequency, f = 50 Hz , Power factor,…

Q: 2. Determine the Total Current and currents passing through each of the resistance. Also, determine…

A: The node-voltage technique is an organized procedure for generating a group of simultaneous…

Q: 2. Given points P(1.-3.5), Q(2,4,6), and R(0,3,8), find: (a) The position vectors of P and R (b) The…

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

Q: II. Let f(n) = ryn(1-Yn) and consider the nonlinear difference equation Yn+1 = f(n) or Yn+1 =…

A: A discrete variable is one that typically has a set value, most often 1, and has a limited range of…

Question

(5 points) A constant electric field of magnitude 1.39 x 10³ N/C is crossing a 175 cm² circular area and making an angle of
0 66 with its surface. The electric flux passing through the circular area is equal to:
O 9.87 x 10³ Vm
O=22.2 Vm
04-9.87 V.m
0 2.22 x 10 V.m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two parallel plates 6. 0 x 10 m long are separated by 2.5 x10 m and have a potential difference of 850 V. Point P is located midway between the two plates as shown below. Ov 2.5x 10*m 850 V 6.0x 10°m What is the maonitude of the electric field at noint P?
In the figure below, what is the magnitude of the electric field at the vacant corner of the square? One side of the square is of length 30.0 cm
The magnitude of magnetic field 88.0 cm from the axis of long straight wire is 7.30 µT. What is current in the wire?
An aluminium ring hangs vertically from a thread with its axis pointing east-west. A coil is fixed near to the ring and coaxial with it. What is the initial motion of the aluminium ring when the current in the coil is switched on? could you explain why ring moves towards E by use Faraday's Law
onsanb will save this response. Quèstion 6 A propagating wave in free space has magnetic field intensity H=0.2cos(10t- B y) az the value of B equals to 3.33 4.33 5.33 7.33 A Moving to another question will save this response. I'm Cortana. Ask me anything. DE
find the magnitude and direction of electric field at point p as shown in figure q=1nC , w =1mm
A field line and an equipotential surface are Always parallel Inclined at any angle 0 always at 90° none of these
The the magnitude of the magnetic field density at point a is l=6 A l2=3 A d= 10-4 m a d d d 6 mT ) 12 mT 18 mT None of the above
The parallel-plate capacitor shown to the right is discharging so that the electric field between the plates decreases. Answer the questions below and explain your reasoning. What is the direction of the magnetic field at point S?
A circular coil of 15 turns and radius 4.0 cm is placed with its plane oriented at 90° to a uniform magnetic field of 0.25 T. The field is now increased at a steady rate, reaching a value of 0.50 T after 5.0 seconds. What emf is induced in the coil? 4.2 mV 3.8 mV 17.0 mV 23.1 mV 2.5 mV
Electrons accelerated from rest under a potential difference of 4000V enter perpendicularly into the uniform magnetic field and draw a circle with a radius of 9 cm. Find the magnitude of the magnetic field.
Ferromagnetic material with μ=4.5 μ0 is in a magnetic field of B=4y less mWb/m². In this case jb=?