47. Table Saw The blade on a table saw rotates at 3450 revolutions per minute. How much faster (in ft/sec) does a 12-in.-diameter blade strike a piece of wood than a 10-in.-diameter blade?
Q: (a) Calculate the velocity v = dr and acceleration a = dt dv and their absolute values. dt Express t...
A:
Q: 2. Show that in the canonical (T –V – N) ensemble (E – E)(P – P) = -(ðP/Əß)v,N = KT²(ƏP/ƏT)v,N , whe...
A: For canonical ensemble ∆E=E-E¯ Square the above equation ∆E2=E-E¯2∆E2=E2-2EE¯+E¯2 and the average i...
Q: A 78.11 gram copper metal is heated to 128°C and dropped into 127.12 gram of water at an initial tem...
A: Given that:-Mass of copper metal, mcu=78.11 gmInitial temperature of copper, Tcu, i=128°CMass of wat...
Q: A small block of mass m, starts from rest at A and slides on a frictionless track which ends in a ci...
A:
Q: A parallel-plate capacitor has capacitance Co 8.50 pF when there is air between the plates. The sepa...
A: (a) What is the maximum magnitude of charge Q that can be placed on each plate. i (b)maximum magnitu...
Q: Consider the thrce circuits (a, b, c) shown in the Figure. In which circuit is the dissipated clectr...
A:
Q: The potential energy U of a particle in a field varies with position r as u -- a U 2 r where a and b...
A:
Q: An uncharged capacitor and a resistor are connected in series to a source of emf. If E = 10.0 V, C =...
A: Given, ϵ=10.0V C = 16.0 × 10-6 F R = 100 Ω
Q: 1. Compute the final velocity of a rolling sphere and a rolling hoop (both of mass M, radius R) if t...
A: Hey dear we can solve this using conservation of energy
Q: 120 18 361 BI "The following is a parallel circuit Answer the following question 1. Calculate the cu...
A:
Q: In the Young's double slit exper glassplate (refractive index 1.5) of thickness t is introduced in t...
A: Given, Refractive index, μ= 1.5thickness =twavelength= λ
Q: Exploring the universe, you and your crew mates come across a sector in which their has been no impe...
A: Gravitational field lines can be analysed to see how strong is the gravitational force in a given re...
Q: 4.9 PQ If somehow you could attach a light to a fluid particle and take a time exposure, would the i...
A: A Path line is the path traced by a single fluid particle as it flows across space over time. As a r...
Q: (a) Give a brief discussion on the two most important experiments that proved light as wave and as p...
A:
Q: For a certain run, the following data is obtained when filling up Table 1 of the manual: Mass of car...
A: Given: The mass of the cart is M = 0.250 kg The hanging mass is m = 0.023 kg The distance traveled b...
Q: A windmill captures 300W of wind power for 9h. The kinetic energy is converted to electric energy an...
A: Given a windmill captures 300W of wind power for 9h. The kinetic energy is converted into electrical...
Q: A small bead of mass m = 5.00 × 10-º kg carrying positive charge Q = 30.0 µC is placed in the electr...
A:
Q: A bar bell has mass 1 kg on one side, and a different mass 2 kg on the other side. The masses are se...
A:
Q: revolutions per second in a magnetic field of (5.160x10^-1) T. The maximum EMF generated is:
A: The req answer is given below.
Q: Part A A 10 cm x 10 cm squaro is bent at a 90 angle. A uniform 5.60x10-2T magnetic field points down...
A: Given, magnetic field B = 5.60 × 10-2 T area A = 10 cm × 10 cm = 100 cm2 ...
Q: The potential energy U of a particle in a field varies with position r as U -- a 2 r where a and b a...
A:
Q: Calculate (p) and (p) for the wavefunction, 2 ¥(x)={( L TT X sin L 0 L
A:
Q: 02
A: We know that:-Magnetic field strength, B=Fmaxil Equation 1where, B is the magnetic fieldF is the...
Q: use the information given in the table to salve for the total Capacitance (C) and total potential di...
A:
Q: What tension should the 6.61 x 10-3 kg/m string have so that its fundamental frequency is 146.8 Hz? ...
A:
Q: At time t = 0 a current of 2 amperes flows in an RLC circuit with resistance R = 40 ohms, inductance...
A: Solution:-Given thatRLC circuitR=40 ohmsL=0.2 HenrysC=10-5 FaradsAt time t=0⇒q=1 CAt time t>0⇒E(t...
Q: A shell leaves a mortar with a muzzle velocity of 150 m/s directed upward at 60° with the horizontal...
A: Solution:-Given thatInitial velocity (V)=150 m/sθ=60°time (t)=20 s
Q: A parallel-plate capacitor has circular plates of radius 7 cm separated by 3 mm. Find: a) the capaci...
A:
Q: An object is placed 9.20 cm in front of the cornea. (The cornea is thin ans has approximately parall...
A: Given: d0=9.20 cmTo find:a) Image distance (d1)b) Optical ...
Q: A car is traveling from point A, B, C, D and E The car started from Point A with a speed of 5.5 m/s ...
A:
Q: Problem 2. A ball is dropped down a well and 5 seconds later the sound of the splash is heard. If th...
A:
Q: An object is placed 11.9 cm in front of the cornea. (The cornea is thin ans has approximately parall...
A: Given, An object is placed 11.9 cm in front of the cornea. The cornea is thin ans has approximately ...
Q: Consider a hexagonal lattice with basis vectors as shown in the figure below. If the lattice spacing...
A:
Q: A8.0 kg box begins at rest on the ground. The coefficient of static friction between the box and gro...
A: Given Mass m = 8 kg Force F = 50 N Frictional force, fk=μN=μmg=0.3×8kg×9.8 m/s2=23.52 kg.m/s2Whe...
Q: An electron is trapped in an infinitely deep one dimensional well of width 0.285 nm. Initially, the ...
A: Given: Mass of electron,m=9.1×10-31kgWidth,L=0.285nm=0.285×10-9mPlanck's constant,h=6.626×10-34Js Th...
Q: Question 5 ZnSe is a direct gap semiconductor with a band gap of 2.87 eV. Calculate the binding ener...
A: An exciton is a bound state of an electron-hole pair in a semiconductor material. It is formed when ...
Q: 45. The five coplanar forces shown in the figure act in an object. Find their resultan 15.0 N 16.0 N...
A:
Q: B Suc 1. The three charges are laid out as shown. If the values of n dan 2 are 0,12 and 0,20 m, resp...
A: Refer to the figure below :
Q: White light containing wavelengths from 410 nm to 750 nm falls on a grating with 7200 slits/cm/cm. H...
A: There are 7500 slits in 1 cm. Therefore the 1 slit width is d=1 cm1 m100 cm7500d=1.33×10-6 m The c...
Q: The two point charges Q1 and Q2 are in (0, 5, 1) and (0, 2, 6), respectively. Find the relationship ...
A: Given, Q1 0,5,1Q20,2,6P0,2,3
Q: White light containing wavelengths from 410 nm to 750 nm falls on a grating with 7200 slits/cm/cm. H...
A: Generally, protons with chemical shifts that differ greatly display first-order spectra, whereas pro...
Q: A sharp shooter at a Wild West show impresses the crowd with her marksmanship. For her first trick, ...
A:
Q: A monkey of mass m = 30 kg is climbing up a rope with an acceleration a = -2 5 ms relative to the ro...
A:
Q: 3.12 This manometer contains water at room temperature. The glass tube on the left has an inside dia...
A: Given: The inside diameter of the glass tube on left is 1 mm. The diameter of the glass t...
Q: A 2. On each corner and on the center/origin of the parallelipiped , place a charge Q = -30 µC. Solv...
A:
Q: A 397 N crate rests on a ramp; the maximum angle just before it slips is 33° with the horizontal. Wh...
A: Concept: The Schematic diagram of the system is Here, N= Normal Force N=mgcosθ And, Fs= Static Fric...
Q: n wide, is illuminated by light o first two minima on either sid e
A: Given as, Distance, d=0.0500 nm=0.0500×10-3, Wavelength, λ=550 nm=550×10-9.
Q: A thermometer is carried outside a house whose ambient temperature is 70° Fahrenheit. After five min...
A: The outside temperature (which is assumed to be constant). Given,Thermometer readingT=70 oFThermomet...
Q: An emf is induced by rotating a 1000-turn, 20.0 cm diameter coil in the Earth's 5.00 x 10-5 T magnet...
A: Using Faraday's law and lenz's law,the expression for induced emf is ε=-N∆φ∆t =-N∆BAcosθ∆t =...
Q: Simplify Derivation + Integration
A: To Find : Find the work done and do the calculation in detail
Step by step
Solved in 3 steps