430 mm 570 mm 290 mm

Q: 270 N 0.40 m 1.24 m 270 N 270 N

A: We have to determine the value of equivalent force couple system at O according to the given data.

Q: Find the centroid of the area of a trapezoid that has two equal slanting sides, a 6 cm base and a 3…

A:

Q: 45° SG = 0.86 50 cm A Hinge 10 cm SG = 1.23 80 cm B F 40 cm

A:

Q: Determine external as well as static indeterminacy

A: Given data : Number of external support reaction (R)=2+1+3=6Number of member (m)=3Number of Joint…

Q: A bridge is to be built across a 7.5 m wide almost rectangular river with uniform flow depth of 2.5…

A: n=0.003

Q: Please help me drawing the shear force and tension side only bending moment diagrams for the…

A: Draw shear force diagram and bending moment diagram (tension side).

Q: 6,2 and cœntroid of the following Afanes Cross-sectons 2"

A:

Q: For the trapezoidal region: a. Find y bar b. Find ixx c. Construct the centroidal axis x’ and then…

A:

Q: Q1: Find the polar coordinates of the Cartisian point P(-2,2)

A:

Q: Draw the free body diagram

A: Consider the given beam.

Q: If the magnitude of the resultant force acting on the eyebolt is 600 N and its direction measured…

A: Given: The magnitude of the resultant force is 600 N. The resultant angle is 30o.

Q: Problem 1: Determine the resultant of the four forces and one couple, which act on the plate shown.…

A: Feel free to ask any doubt.

Q: Hexagonal prism of base side 30 mm height 80 mm is resting on one of its base edge on HP. Its axis…

A:

Q: 5 in. 1 8 in. R = 6 in. 2 in.- y H (a)

A:

Q: r 10 in. B a = 5 in. a = 5 in. Fig. P5.8

A:

Q: H. G. D. E B.

A:

Q: A homogeneous, planar plate of constant thickness in the figure the coordinates of the centroid…

A: a= 9cm t = 3cm hence the actual figure will look like this

Q: Locate the centroid of the quarter-cone.

A: First, we draw the free body diagram:-

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.