4001 2008 + 300A 4 10 Η 5 μF tou b ΣΚΩ

Q: problem: Find the state equations For į (the current of inductor) and ve in the circuit below. 1.n…

A:

Q: ange in torque if the load is changed so that the m

A:

Q: Consider the following converter topology in a battery charger application. Vs= Vbatt = 240V Vs •…

A: Given information about a converter topology is, Vs=333 Volts. L=10 mH=10×10-3 H. Vbatt=240 Volts.…

Q: R₁ 30 R₂ 100 8. For the circuit above (circuit from question 3): a. Find the Norton equivalent…

A: given here electrical network and asked to find norton equivalent external to resistor RL  . here we…

Q: 7.29. Determine C/R for each system in Fig. 7-55. (a) R (b) (c) R R 9 G₁ H₂ G₂ G₁ H₂ G₂ G₁ H₁ Fig.…

A:

Q: 1\ Write the mesh equations for the circuit in figure below R www 40 802 E₁ = 10 V 20° ell 60 + E, =…

A:

Q: The step down chopper is operating at 1 kHz. Other data are V=240 V, L = 10 mH, R = 102 and duty…

A: Given Vs=240 V L= 10 mH R=10 ohm D=0.6

Q: From the circuit below, if R = 53, determine the maximum power absorbed by the load impedance ZL…

A: The given circuit diagram is shown below:

Q: Q2: Assume that A = 50p²a, Wb/m in a certain region of free space. (a) Find H and B. (b) Find J. (c)…

A:

Q: Find the temperature at which an ele Fermi -Dirac by (0.3 evl is 15% on above

A: We need to find out the tempreture at which probability of electron is 15% .

Q: In a BJT common emitter configuration, if the base current is 2.0 µA, find the current through the…

A: Given, In a BJT common emitter configuration Base current, IB=2.0 μA Common base current gain,…

Q: Design using NAND gate to have such a truth table. Inputs Outputs C Y₂ Y₁ Y₁

A: Given truth table of inputs A,B,C. To design the respected outputs with  NAND gates only.

Q: A system is described by its state-space model as indicated below. Convert the state-space model to…

A: This problem can be done by finding transfer function of given system

Q: For a citizens band receiver using high-side and low-side injection with an RF carrier of 27.04 MHz…

A:

Q: A three-phase 6-pole 400-volt cylindrical-rotor synchronous machine has negligible arr resistance…

A: In this question we will find operating speed of synchronous motor.....

Q: The power of a heater is 500 W at 800 °C. What will be the power at 200 °C? Temperature coefficient…

A: In this question we need to find a power at 200oC .

Q: Figure below represents a circuit in which a d-c generator is connected to two storage batteries in…

A: In this question we need to find a current IA , IB , Itotal , Power deliver by generator and total…

Q: State whether the given statements are True of False with e (a) The electric signal can be…

A: a. The electrical signal can be transmitted inside of a conductor -True Since conductor has low…

Q: Given an analog x(t)= 5c sampled at a rate of 8,

A:

Q: RLe in series where Rs 2012 XL = 50 Хc5 дол find Z 6 20-j30 @ 20+ j30 30+ j Zo C1 @ 30-j 20 /

A:

Q: Reduce the diagram to a single block ရ G₂ H သက်တမ် 1 2 6 G4 p =_c C

A:

Q: Your aunt living in the USA sent an appliance that has impedance equal to 10 + j3 22 at 60 Hz. She…

A: We use method A to solve this question

Q: ulate the total current shown in figure (2-37). 100 Ω 100 V 60 Ω 40 Ω 88 9 Figure (2-37) www 38Ω

A:

Q: EXAMPLE (3):-by using nodal voltage method find the currents passing in (R3,R4) in the circuit in…

A:

Q: EXAMPLE (1):- Calculate the electrical energy consumed by the electrical heater during (7 hours) if…

A: Given Time, t = 7 hr Voltage, V = 220 V Current, I = 8 A

Q: A resistor having a resistance of 40 ohms is connected in series with an inductor having an…

A: To find the resonant frequency of the circuit in rad/sec

Q: Your aunt living in the USA sent an appliance that has impedance equal to 10+ j3 2 at 60 Hz. She…

A: We use method A to solve this question.

Q: An AM broadcast station operates at its maximum allowed output power of 80W at a percent modulation…

A:

Q: A certain de shunt motor has R.= 0.5 ohm, Rr= 80 ohms. and kr= 0.02 s/rad (kr Ir= ka D). Under…

A: Given,For a DC shunt motor,Ra=0.5 ΩRf=80 ΩKf=0.02 Ωs/radV=10 VIa=20 A

Q: Consider the circuit shown in Figure Q7. The full-wave bridge rectifier is supplied from a…

A:

Q: A 440 V, six poles, 80 hp, 60 Hz, Y connected three phase induction motor develops its full load…

A: Given  Parameters of three phase induction motor are given.we need to determine the value of rotor…

Q: Total impedance is Z= Z₁XZ₂ Z₁ + Z₂ (5+j 6.28)(1+j 25.23) Z= 5+j 6.28+1+j 25.23 Z=

A: given total impedance is Z=z1z2z1+z2Z=5+j6.281+j25.235+j6.28+1+j25.23here we have to find the total…

Q: A building, supplied by a 230 Vrms source and with inductive loads, has an average consumption of…

A:

Q: 2. What would be the voltage on the secondary side of a transformer with a 400:20 turns ratio and a…

A: 2)Let the voltage at primary be V1 and secondary be V2. Then V2/V1=N2/N1 Therefore…

Q: A 10 KVA, 2400/240V, single phase transformer has the following resistances and leakage reactance Rp…

A: The Given is, The Resistances and leakage reactance Rp=3-ohm;       Rs=0.03-ohm;         Xp=15-ohm;…

Q: and Q) Design a self brasing circuit which has follang Parameters Vcc=150, Vc =qv VCE = U₂U RE=23k…

A:

Q: Vs +1 + R ww VR IR + LV. IL + I. RLC circuit C

A:

Q: 3.2 In the circuit in Figure 3.2, the switch is closed at time t=0, the capacitor with 10 V voltage…

A:

Q: Q4. a) Figure 4 depicts a simple DC motor, its armature winding consisting of a single turn of…

A: A DC motor is a Electric device which converts the electrical energy into physical motion. The…

Q: Q5. A point charge Q is placed in the center of a hollow metallic sphere as shown in Figure Q5.…

A: Given  A point charge is placed at middle of a hollow metallic sphere.we need to find out the…

Q: 1. Reduce the network below to the smallest possible number of components if each inductor is 1 nH…

A: Given here electrical network and asked to reduce the network to the possible combinations.

Q: (2-9) Calculate and draw the output voltage for the circuit shown in Figure (2-74). D₂ +100v V₁ A…

A: We need to find out the output voltage for given circuit

Q: Compare the different types of etching: 1) isotropic versus anisotropic etching; 2) dry etching…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A building with inductive loads has the average consumption of 40kW and 26kVAR. At the are location…

A: In this question we need to find a average current , effective impedance and surcharge

Q: If you have a system with a quantizer of 8V & 4 bits resolution, show the following: 1. howmany…

A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…

Q: A 1.5-kVA 240/120-volt single-phase transformer is serving a 10-ohm load connected at the…

A: Transformer is a static device which is used to step up/Down the voltage level or current level. It…

Q: D+ 01 1F Μ 19 1 F 201 1Ω +C 02 ΤΟ

A:

Q: How: For the fixed bias BJT circuit B = VCE IC, RL=8 and vcc = 24 V; determine the maximum Power…

A: Given, Configuration - fixed bias RL = 8 ohm Vcc = 24 volts

Q: 2. What would be the voltage on the secondary side of a transformer with a 400:20 turns ratio and a…

A: Given, Transformer with turn ratio, N1N2=40020 Primary voltage, V1=6000 V

Q: Power factor 90 to 100% 88 to <90% 85 to <88% 80 to <85% 75 to < 80% 70 to < 75% 65 to < 70% 60 to <…

A: In this question we need to find effective impedance , average current and surcharge of the given…

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.